FCC ID: H8N9961V1 Alcatel-Lucent 9961 Multi-Standard Home Cell (MSHC) V1 B2/B4 - Femtocell

Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Radiation Exposure Statement:

The product comply with the FCC portable RF exposure limit set forth for an uncontrolled environment and are safe for intended operation as described in this manual. The further RF exposure reduction can be achieved if the product can be kept as far as possible from the user body or set the device to lower output power if such function is available. FOR MOBILE DEVICE USAGE (>20cm/low power) Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.

8.25 4G LTE CellSpot Quick Start Guide You now have a powerful, simple way to create your own personal T-Mobile 4G LTE mini-tower in your home or small office. It can provide improved indoor 4G LTE coverage, more dependable voice calls and more consistent data speeds. 11.7 Attention: Important Information This device must be installed at your registered address with T-Mobile. Failure to maintain this address could affect your ability to contact emergency services and result in device deactivation. Visit https://my.t-mobile.com , MyAccount on your handset or call CARE at *611 from your handset or 1-800-937-8997 to update the device use address. MECHANICAL FILE NAME RM2_4GPersonalCellSpot_QSG_TCS525167_1.ai 55 Union Street | 3rd Floor San Francisco, CA 94111 T 415 427 1200 | F 415 348 0063 sterlingbecker.com DATE 12.04.14 CLIENT T-Mobile DIELINE FILE NAME 8.25 wide x 11.7 tall CREATIVE APPROVAL DRAWN BY vl PRINTER TBD DIELINE SOURCE Drawn by SB SB JOB NUMBER 1600634 PRINTING TYPE TBD DIELINE DATE n/a PRODUCTION APPROVAL PROOFREADING APPROVAL NOTES:

FRONT COVER PRINTING STATIONS:

Black TMO Magenta 4-COLOR Process PROCESS MIX:

8.25 Whats Inside Quick Start Guide

(This document) 4G LTE CellSpot Device Stand/Wall Mount Wall Mounting Kit

(2 Cheese Screws and 2 Wall Anchors) AC Power Adaptor GPS Antenna & Cable (15 ft) Ethernet Cable GPS Cable Bracket Getting to know your 4G LTE CellSpot 11.7 CellSpot Device in Stand GPS Cable Bracket

(Attach GPS cable here after installation is complete) Reset 1. Press and hold for 5s for reboot 2. Press and hold for 10s for power off 3. Press and hold for 15s for factory setting reset and software update Power

(Power on when AC Adaptor is plugged in) Grey LAN Port

(Connect to other devices if needed) Yellow WAN Port

(Connect to Wi-Fi router or Wi-Fi cable modem router) Round GPS Port

(Connect to GPS Antenna & Cable) Stand/Wall Mount Wall Mounting Kit INSIDE - LEFT CellSpot Device with Wall Mount 1 8.25 Quick Setup 1 2 3 4 11.7 Connect your CellSpot to the Internet Connect the yellow Ethernet cable from the WAN yellow port on your CellSpot to an available Ethernet port on your Wi-Fi router or Wi-Fi cable modem router. Connect GPS antenna to the CellSpot Connect the GPS antenna cable to the GPS port. Position the antenna as close to a window as possible.

(You'll attach the GPS antenna and cable to the bracket after installation is complete.) Power on your 4G LTE CellSpot Plug in your AC power adaptor into the power outlet and connect the power cable to the CellSpot power port. 2 1 3 Let your CellSpot set up After you power on your CellSpot, the CellSpot will go through self-installation process. It can take up to 45 minutes to complete the device setup. Your CellSpot may download updates and could restart during this time. Power (Solid Green): Power on. Device self testing and update complete. Internet (Solid Green): Successful internet connection. Status (Solid Green): Successful connection established with T-Mobile network. GPS (Solid Green Optional): GPS position locked if GPS signal is present. Device can still proceed through setup without GPS signal lock and operate normally. 3G/4G (Solid Green): Device is ready to provide 3G/4G service. 4G LTE (Solid Green): Device is ready to provide 4G LTE service. Congratulations! Your CellSpot setup is complete. Make your first 4G LTE CellSpot call with your 3G, 4G or 4G LTE capable devices. Just use your mobile device as you normally do and enjoy the improved coverage, more dependable voice calls and a more reliable high speed data connection. 4 2 INSIDE - RIGHT 8.25 Common Troubleshooting Procedures Issue Description and Resolution Power Internet Status GPS 3G/4G 4G LTE Device has a hardware issue. Contact T-Mobile for resolution. Device unable to capture GPS signal. Without GPS signal lock, device is still able to proceed through setup and operate normally. Device connection issue with the Wi-Fi router or Wi-Fi cable modem router. Check Wi-Fi router or Wi-Fi cable modem router connection. 11.7 Device is unable to reach T-Mobile network. Check with Internet Service Provider on network settings. Ensure ports UDP 500, UDP 4500 and UDP 123 are opened. Unable to activate the device with T-Mobile network. Contact T-Mobile for resolution. 3G, 4G, 4G LTE service is not available. Device may not be used in T-Mobile market or remote disabled by T-Mobile. Contact T-Mobile for resolution. Device has reached maximum number of 8 active voice and data connections for each technology. Attempt to call again after existing calls are terminated. The device is overheated. Move device to a cooler location Solid Orange Solid Orange Solid Orange Solid Orange Solid Orange Solid Orange Any Any Any Any Any Solid Orange Flashing Green Solid Orange Flashing Green Flashing Orange Off Any Off Off Off Any Off Off Flashing Green Solid Green Solid or Flashing Orange Any Off Off Solid Green Solid Green Solid or Flashing Green Any Off Off Solid Green Solid Green Flashing Green Any Flashing Green Flashing Green Flashing Orange Flashing Orange Flashing Orange Flashing Orange Flashing Orange Flashing Orange Have More Questions?

For additional information about T-Mobile 4G LTE CellSpot installation go to http://4GLTECellSpotSetup.T-Mobile.com Call T-Mobile customer service at *611 from your handset or 1-800-937-8997. Deposit, qualifying wireless service, compatible phone & broadband Internet connection required. May require plan change. All data, messaging and other services billed according to your regular rate plan and other pricing. Non-return fee applied if device is not returned; damage fee may apply. Current location address required for device use. See T-Mobile.com for details and restrictions including important 9-1-1 limitations. Property of T-Mobile USA, Inc. Not For Resale. TCS525167.1 BACK COVER

Page 8 Page 9 Page 10 Page 11 Page 12 Page 13 Page 14

CONSTRUCTION PHOTOS OF EUT Page 1 Page 2 Page 3 Page 4 Page 5 Page 6 Page 7

Askey Computer Corp 10F, No. 119, Chienkang Rd Chung-Ho,Taipei, 235, Taiwan, R.O.C. TEL: +886-2-2228-7588 Date: 2014-12-31 FCC ID: H8N9961V1 To the attention of Federal Communications Commission Authorization and Evaluation Division Confidentiality Request Pursuant to Sections 0.457 and 0.459 of the Commissions Rules, the Applicant hereby requests confidential treatment of information accompanying this Application as outlined below:

Schematics Block Diagram Operational Description Part list Tune-up Procedure The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these matters might be harmful to the Applicant and provide unjustified benefits to its competitors. The Applicant understands that pursuant to Rule 0.457, disclosure of this Application and all accompanying documentation will not be made before the date of the Grant for this application. Sincerely yours,

Askey Computer Corp Name: John Chiou Title: Director TEL: +886-2-2228-7588 E-mail: jchiou@askey.com.tw

Askey Computer Corp 10F, No. 119, Chienkang Rd Chung-Ho,Taipei, 235, Taiwan, R.O.C. TEL: +886-2-2228-7588 Date: 2014-12-22 FCC ID: H8N9961V1 To the attention of Federal Communications Commission Authorization and Evaluation Division Confidentiality Request Pursuant to Sections 0.457 and 0.459 of the commissions rules, we request short-term confidential treatment for the following information until 180 days after the Grant Date of Equipment Authorization in order to ensure sensitive business information remains confidential until the actual marketing of the device:

External photos Test Setup photos Users manual Internal Photos Sincerely yours,

Askey Computer Corp Name: John Chiou Title: Director TEL: +886-2-2228-7588 E-mail: jchiou@askey.com.tw

Askey Computer Corp 10F, No. 119, Chienkang Rd Chung-Ho,Taipei, 235, Taiwan, R.O.C. TEL: +886-2-2228-7588 Date: 2014-12-22 FCC ID: H8N9961V1 A U T H O R I Z A T I O N L E T T E R To whom it may concern:

We, the undersigned, hereby authorize Andrea Hsia / Senior Specialist of Bureau Veritas Consumer Products Services (H.K.) Ltd., Taoyuan Branch (BV CPS Taoyuan) of Taiwan to act on our behalf in all manners relating to FCC application for equipment authorization, including signing of all documents relating to these matters. Any and all acts carried out by Andrea Hsia / Senior Specialist of BV CPS Taoyuan on our behalf shall have the same effect as acts of our own. If you have any questions regarding the authorization, please dont hesitate to contact us. Sincerely yours,

Askey Computer Corp Name: John Chiou Title: Director TEL: +886-2-2228-7588 E-mail: jchiou@askey.com.tw