Package Contents Check the contents of the package Router 5. 6. 7. 8. x 1 2. Installation 1 2 3. 1 2 s Connect the
. Plug power power ports. to the Routers
(This page intentionally left blank.) Router Power Wireless Router EAI2304P Quick Installation Guide
. SIM Card and Battery
. GPS Cable
. LED Indicators LEDs
. Drilling Template 1. Turn the device upside down. 2. Remove the SIM Card & Battery cover by loosening the two Philip screws. 4. Insert the SIM Card. Make sure the SIM Card is pushed all the way into the slot. 1. Connect the GPS Cable to the GPS-marked mini co-axial (SMC) connector located on the front panel of the wireless router. GPS Antenna Philip screws Philip screws SIM Card &
SIM Card &
Battery Cover Battery Cover S I M M i c r o 3. Set aside the removed SIM Card &
Battery cover. 5. Insert the Battery. SIM Card slot Battery compartment SIM Card &
Battery Cover 2. Locate a nearby window. Mount the GPS Antenna on the window glass. (Remove adhesive lm on the back of the GPS Antenna prior to mounting in on the window glass.) GPS Antenna Wireless Router 6. Place the SIM Card & Battery Cover on the Battery compartment, tighten the Philips screws till the cover is tightly secured. To ensure proper installation, use three M3.5 screws with a minimum length of 21.8 mm. The input connector must face toward the oor. Pour garantir une installation correcte, utilisez trois vis M3,5 d'une longueur minimale de 21,8 mm. Le connecteur d'entre doit tre orient vers le sol. Window
*Wall Mount Caution:
LED Activity Description OFF Solid BLUE Solid YELLOW LTE service is not connected. LTE connected and signal level good. [ RSRP Range -105 dbm to -40 dbm]
Intermittent LTE signal [ RSRP Range -106 dbm to -120 dbm ] or DATA Connection failed casealso LTE Solid RED 1. LTE is not functional. 2. SIM card is not provisioned or not properly provisioned. 3. SIM card is not inserted or not inserted properly. Solid GREEN Reserved Flashing GREEN Device is under rmware upgrading process. System Status 2.4GHz/5GHz Flashing LED ( Color depends on LTE state ) OFF Solid BLUE Solid GREEN Solid RED Flashing LED ( Color depends on LTE state ) Solid GREEN Flash GREEN OFF OFF Solid GREEN Flashing GREEN Flashing YELLOW Solid RED Device is under Battery mode, LED Flashing period 5 seconds once Device is not connected to internet. Internet is connected thru multiple WAN. Internet is connected thru single WAN. Device is under error state other than LTE error. Device is under Battery mode, LED Flashing period 5 seconds once Wi-Fi is not on and not operational, Wi-Fi disabled by default in Battery Mode Wi-Fi is on and operating normally. Device is under rmware upgrading process. Device is not receiving power. Device is completely power on. Device is under power on process. POWER Device is under Battery mode. Flashing period 5 seconds once Battery needs to be replaced. Flashing RED 5 times Device cannot be power on for any reasons.
(Critical low battery, High temperature) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. o o o o FCC Caution: Any changes or modications not expressly approved by the party responsible for compliance could void the users authority to operate this equipment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 45cm between the radiator & your body. Operations in the 5.15-5.25GHz band are restricted to indoor usage only. Battery Caution:
- If the battery is incorrectly replaced, there is a danger of explosion.
- Replace only with the same or equivalent type recommended by the manufacturer.
- Discard used batteries according to the manufacturer's instructions.
* N'ouvrez pas le capot du systme. Si l'ouverture du couvercle pour l'entretien est indispensable, seule une personne qualie doit le faire. MISE EN GARDE:
- Si la batterie n'est pas remplace correctement, il existe un risque d'explosion.
- Remplacez uniquement par un type identique ou quivalent recommand par le fabricant.
- Jetez les piles usages conformment aux instructions du fabricant. Flashing GREEN Device is under rmware upgrading process.
* Do not open the systems cover. If opening the cover for maintenance is a must, only a skill person should do so.