Package Contents yA AMPBOX 3.5mm audio cable AC Charger USB power charging cable Setup OFF ON f (ll
(00) o0!:00 Features rc 4321 1. Power On/Off 8. Volume down 5. Microphone 2. Charging status indicator 6. Play/Pause 9. Volume up 3. Micro-USB Charging port 7. Pair or phone button 10. Bluetooth status indicator 4. Auxiliary-in jack
) To play audio from a Bluetooth device, you need to pair the device with AMPBOX. 1. Turn on AMPBOxX. Push the Bluetooth pairing button. When powering up for the first time, AMPBOX is discoverable for 180 seconds and is ready for pairing. The Status indicator blinks blue. 2. On your Bluetooth device, turn on Bluetooth and scan for AMPBOxX in its Bluetooth menu. 3. When AMPBOX appears on the device list of your Bluetooth device, select AMPBOX (If a pass code is requested, enter 0000). The Bluetooth status light blinks rapidly for 6 times. After pairing is established,the speaker is ready to play music. 4. To pick up phone call, please push phone button. Push phone button again to cut phone call off. 5. Music line-in function: please connect your audio device with 3.5mm audio cable to AMPBOXs Auxiliary-in jack and then AMPBOX can start to play music from Auxiliary-in jack source. When 3.5mm line is in, you can control volume by pushing volume up/down buttons. Bluetooth Status Indicator:
1. Pairing Mode: Blue light blinks Charging Plug the charging cable into the speakers charging port and the other end into USB wall charger or a computer USB port for charging. Note: Computers USB port has a lower charging current, it may take up to 3.5hr to reach full charge. Charging Status indicator:
1. Battery Low: Red light ticking and warning sound (four short beeps) 2. Charging: Red light on 3. Fully Charged: Red light off Note: Please charge AMPBOX at the first sign of low battery warning. If the battery's charge becomes too low, low battery warning sound will be heard during music playback even with the charge cable plugged in. If that happens, simply turn off AMPBOX and charge for at least 20min before resuming music playback while charging. 2. Normal Mode (Bluetooth Paired): Blue light blinks every 4 second Troubleshooting If AMPBOX doesnt work or won't pair:
* Try moving your device closer.
+ Is the speaker turned on or charged?
* Turn the speaker off then on to wake it.
+ Is Bluetooth enabled on your device or computer?
+ Try repeating the setup procedure in this manual or try pairing with a different Bluetooth device.
* The speaker plays music from one device at a time. Unpair the device when not being used. (Refer to your device documentation for help.) Pair a new device using the setup procedure. If pairing with a computer, specify AMPBOX as the audio out device on the computer. Spec Driver Unit 50mm Full-Range Speakers x 2, Passive Bass Driver x 1 Magnet Type Neodymium Frequency Response | 80Hz -20Khz RMS. Output 5 Watts Music Play Time Up to 12 hours (Battery life varies by volume and audio content) Operating Range 30 Feet Bluetooth Version A2DP, AUX-In 3.5mm Battery 1700mAh Rechargeable Lithium Polymer battery FCC STATEMENT 2. Tisdoies compli with art 35 of the FAs Operation subject othe flowing two conten:
(2) Ts device must accept any ntererence rected, Icung there Is no maranee that inference wil not occur In 2 partear inaataten, reception which canbe determined by tung the equipment of and on, 2. Changes or modcatons nat expesiy sproved by the party response fr compliance coud vid the use authory to operate the NOTE: This equipment has ben tested a found to comply with he ts
{or Gas 8 cptal deve, pursuant Pat 5 ofthe FC Rules. Theses ato frequency ener an, nt ntl and wan secoreanc wah the Insructions, may cause harmful iterference to redo communiatos. the flowing esses Rocio of aes the recehing aren
~ erase the separation between the equpment nd rceher.
~conect he equpment int anoutet on acre erent Const the ele or an experiance lV techn fore 3. FC Radon Exposure Statement:
The device can be wed in portable exposure conon without RF strcion, www.rosewill.com