FCC ID: 2AGNTEF9RC2409A Autel Smart Controller

WARNING:pdfminer.pdfpage:The PDF <_io.BufferedReader name='/Volumes/Scratch/Incoming/eg-scratch/5230583.pdf'> contains a metadata field indicating that it should not allow text extraction. Ignoring this field and proceeding. Use the check_extractable if you want to raise an error in this case FCC Caution:

Operation of 5150-5250 MHz is restricted to indoor use only. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 ofthe FCC Rules. Operation is subject to the following two conditions: (1) This device may not causeharmful interference, and

(2) this device must accept any interference received, includinginterference that may cause undesired operation. IMPORTANT NOTE:

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmfint erferencul e to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Specific Absorption Rate (SAR) information SAR tests are conducted using standard operating positions accepted by the FCC with the device transmitting at its highest certified power level in all tested frequency bands, although the SAR is determined at the highest certified power level, the actual SAR level of the device while operating can be well below the maximum value, in general, the closer you are to a wireless base station antenna, the lower the power output.Before a new model device is a available for sale to the public, it must be tested and certified to the FCC that it does not exceed the exposure limit established by the FCC, Tests for each device are performed in positions and locations (e.g. at the ear and worn on the body) as required by the FCC. For limb worn operation, this device has been tested and meets the FCC RF exposure guidelines when used with an accessory designated for this product or when used with an accessory that contains no metal. For body worn operation, this device has been tested and meets the FCC RF exposure guidelines when used with an accessory designated for this product or when used with an accessory that contains no metal and that positions the device a minimum of 10mm from the body. ISEDC Warning Operation of 5150-5250 MHz is restricted to indoor use only. This device complies withInnovation, Science, and Economic Development Canadalicence-exempt RSS Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le fonctionnement de 5150-5250 MHz estlimit uneutilisation en intrieuruniquement. Le prsentappareilestconforme aux CNR d' Innovation,Sciences et Dveloppementconomique Canada applicables aux appareils radio exempts delicence. L'exploitationestautorise aux deux conditions standard(s). suivantes :

(1) l'appareilnedoit pas produire de brouillage, et

(2) l'utilisateur de l'appareildoit accepter tout brouillageradiolectriquesubi, mmesilebrouillageest susceptible d'encompromettre le fonctionnement. IMPORTANT NOTE:

Specific Absorption Rate (SAR) information SAR tests are conducted using standard operating positions accepted by the ISEDC with the device transmitting at its highest certified power level in all tested frequency bands, although the SAR is determined at the highest certified power level, the actual SAR level of the device while operating can be well below the maximum value, in general, the closer you are to a wireless base station antenna, the lower the power output. Before a new model device is a available for sale to the public, it must be tested and certified to the ISEDC that it does not exceed the exposure limit established by the ISEDC, Tests for each device are performed in positions and locations (e.g. at the ear and worn on the body)as required by the ISEDC. For limb worn operation, this device has been tested and meets the ISEDCRF exposure guidelines when used with an accessory designated for this product or when used with an accessory that contains no metal. For body worn operation, this device has been testedand meets the ISEDC RF exposure guidelines when used with an accessory designated for thisproduct or when used with an accessory that contains no metal and that positions the device aminimum of 10mm from the body. Tauxdabsorptionspcifique (SAR) informations les tests SAR sonteffectus en utilisant les positions oprationnellesnormalisesacceptespar la ISEDC, le dispositifmettant son niveau de puissance certifi le plus levdanstoutes les bandesdefrquencestestes.Avantquun nouveau modle de dispositif ne soitdisponible la vente aupublic, ildoittretest et certifi la ISEDC quil ne dpasse pas la limitedexpositiontablieparla ISEDC, les Tests pour chaquedispositifsonteffectusdans des positions et des emplacements(par exemple loreille et portsur le corps) commelexige la ISEDC. Pour le fonctionnement desmembresuss, cetappareil a ttest et rpond aux lignesdirectricesdexposition aux RF ISEDClorsquilestutilis avec un accessoiredsign pour ceproduitoulorsquilestutilis avec unaccessoire qui ne contient pas de mtal. Pour le fonctionnement du corps us, cetappareil a ttest et rpond aux lignesdirectricesdexposition RF ISEDC lorsquilestutilis avec un accessoiredsign pour ceproduitoulorsquilestutilis avec un accessoire qui ne contient pas de mtal etqui positionnecet appareil au moins 10mm du corps. Steps to use electronic tags Step1:SelectCamera Step2:Click the gear icon in the upper right corner,enter the settings menu Step3:SelectCertification Mark

Step2:Click the gear icon in the upper right corner,enter the settings menu Step1:SelectCamera Step3:SelectCertification Mark

Autel Robotics Co., Ltd. Address: 9th Floor, Bldg.B1, Zhiyuan, 1001 Xueyuan Rd. Xili, Nanshan, Shenzhen, China Tel: 86-18926791906; Fax: 86-755-86147758 Email: zhouzhilan@auteltech.net FCC Confidential Authorization Date: 2021-03-02 FEDERAL COMMUNICATIONS COMMISSIONS Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 Subject: Confidentiality Request regarding application for certification of FCC ID: 2AGNTEF9RC2409A In accordance with Sections 0.457 and 0.459 of the Commissions Rules, Autel Robotics Co., Ltd. hereby requests long-term confidential treatment of information accompanying this application as outlined below:

As well as short-term confidential treatment of information accompanying this application for a period of 180 days after grant is issued as outlined below:

The above materials contain proprietary and confidential information not customarily released to the public. The public disclosure of these materials provides unjustified benefits to its competitors in the market. Block Diagram Schematics Operation Description Internal Photos Users Manual External Photos Test Set-up Photos Sincerely Yours, Signature XIANGXI PAN PRESIDENT

Autel Robotics Co., Ltd. Address: 9th Floor, Bldg.B1, Zhiyuan, 1001 Xueyuan Rd. Xili, Nanshan, Shenzhen, China Tel: 86-18926791906; Fax: 86-755-86147758 Email: zhouzhilan@auteltech.net Attestation Letter Date: 2021-03-02 FEDERAL COMMUNICATIONS COMMISSIONS Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 Dear Sir or Madam:

We, Autel Robotics Co., Ltd., hereby declare that our product Autel Smart Controller, Model:

EF9-1, FCC ID: 2AGNTEF9RC2409A, has the ability to work in 2.4G and 5G 4 frequency bands: 5150~5250MHz,5250~5350MHz, 5470~5725MHz, 5725~5850MHz. For the purpose of marketing, the frequency of the procuct sold in U.S. are programmed and locked to work only in 2.4G5150~5250MHz and 5725~5850MHz. The other frequency bands 5250~5350MHz, 5470~5725 MHz are disabled by firmware in factory. The end user or any other parties can not have the capability to activate the other frequency bands. We applied for testing frequency bands: 2.4G and 5180~5240MHz, 5745~5825MHz, 5729.5~5752.5MHz for the United States this time in BACL. Sincerely, Signature XIANGXI PAN PRESIDENT