FCC ID: 2AJLC-B6RGB Waketower Speaker

0622 B6ABT 6.5 (165 mm) 2-Way Marine/

Powersports Roll Cage/

Waketower Speaker Pods Congratulations on your purchase of a product. It has been engineered to bring you the highest level of performance. Its quality will afford you years of listening pleasure. Thank you for making your choice for audio entertainment!

Specifications Mid Bass Driver:

6.5 (165 mm ) Poly injection cone Rubber surround Tweeter:

1 (25 mm) PEI dome tweeter Crossover network:

Built-in Impedance:

4 Ohms Frequency Response:

140Hz - 20kHz Sensitivity:

93dB (1 watt/1 meter) Dimensions (W x H x D):

7.19 x 9.88 x 7.31

(182 x 250 x 186 mm) Weight (in gift box):

10.7 lbs (4.85 kg) Amplifier:

Input Impedance: 10k Frequency Response: 20Hz - 20kHz Bluetooth:

Version: 5.0 w/ EDR A2DP Range: 33ft (10m) Network Name: BOSS Audio Systems B6ABT All specifications are subject to change without notice. Introduction Your new B6ABT waketower speakers are high-power, fully-waterproof 2-way systems featuring 6.5 drivers and a 1 PEI dome tweeter. understands that wake tower speakers are used in many different types of installations. Our versatile mounting solutions give you the ability to attach our wake tower speakers to mounting tubes with diameters of 1.5 - 2 (38 - 51mm). What is included?

Before you begin installation, please check that your product contains the following contents:

(2) Speaker pods

(4) 130x14x2mm rubber mounting strips

(4) 120x14x1mm rubber mounting strips

(2) 48x30x2mm rubber mounting pads

(4) 2" mounting aluminum bands for 2" and 1.875" installation.

(4) 1.75" mounting aluminum bands for 1.75" and 1.5" installation.

(4) M6 locknuts

(4) M6 flat washers

(4) M6x60mm screws

(1) Power/speaker wire harness

(1) 3.5 mm audio cable Safety considerations when installing Please remember that these are heavy products that will be installed in a boating environment. These vehicles can travel at high speeds and be unstable. So please consider this and use extreme caution. Some safety considerations include:

1- Do not mount the speakers in a location where someone may either walk into or strike their head. During a turbulent ride, please make sure that you do not loosen footing and fall or hit the unit, or it may cause injury. 2- Secure the wires to the speakers in multiple locations along their route to your audio source, so that there are no hanging loops of wire. Having unsecure wires in any hanging conditions can cause entanglement and injury. 3- Tighten the aluminum bands with rubber inserts using care. Do not over compress the rubber inserts. After installation is complete, please recheck all bolts and tighten them further if needed before taking your boat or vessel out for an audio adventure. 4- Do not install these speakers where they may block the view of the pilot and prevent safe operation of the vessel or vehicle. B6ABT 6.5 (165 mm) 2-Way Marine/Powersports Roll Cage/Waketower Speaker Pods B6ABT 6.5 (165 mm) 2-Way Marine/Powersports Roll Cage/Waketower Speaker Pods It is strongly recommended that you work with an assistant to install these speakers. Installation instructions STEP1 STEP2 Metal base Metal base To adjust the mounting angle, loosen the metal base of the mounting band by unbolting the two screws. Make sure to put all components of the mounting hardware in a safe location. Twist the metal base to determine the optimal mounting angle for the speaker on the cage bar. Then secure the metal base by tightening the two screws. STEP3 STEP4 48 x 30mm rubber pad Aluminum band As illustrated, secure the aluminum bands to the metal base using a pair of M6 x 60mm screws, M6 flat washers, and M6 locknuts. The locknuts must be installed into the hex shaped recess on one end of each aluminum band. Hand-tighten the screws to the degree which allows just enough freedom to rotate the speaker around the cage bar. Speaker installation now completes. Bluetooth Through Bluetooth connection, you can stream music from a Bluetooth device (e.g. a mobile phone) to the speakers. Make sure Bluetooth is enabled on the device. When the device is in Bluetooth range, it will connect Bluetooth automatically and will be disconnected when it is out of Bluetooth range. AUX input Using the supplied 3.5mm audio cable, connect the speaker to your mobile phone for audio input to the speakers. Make sure Bluetooth connection is not made to enable AUX input. mounting tube diameter:

1.5 - 2

(38-51mm) Rubber strip Product dimensions Mounting cage bar

(part of your marine boat or powersports vehicle) 9.88

(250mm) Place a supplied rubber pad (48 x 30 mm) on the metal base of the mounting band to prevent abrasion and secure clamping. Place two supplied rubber strips around the cage bar to prevent abrasion and secure clamping. Then push two supplied aluminum bands over the cage bar, and align the aluminum bands with the metal base on the speakers. 7.19

(182mm) 7.31

(186mm) B6ABT 6.5 (165 mm) 2-Way Marine/Powersports Roll Cage/Waketower Speaker Pods B6ABT 6.5 (165 mm) 2-Way Marine/Powersports Roll Cage/Waketower Speaker Pods Wiring 12V wire harness connection

B l a c k y +

a G r FCC compliance statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause undesired operation. FCC rules This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. FCC RF radiation exposure statement This equipment should be installed and operated with minimum distance 20cm between the radiator and your body. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. AUX input 2) ACC wire

(red) 3) Remote out wire (blue) Ground wire

(black) DC12 (-) grounded to metal chassis, or directly to negative polarity of battery Battery wire

(yellow) DC12 (+) extention power cable with fuse holder (not included) 1) Audio output 1) Connect the RCA plugs (red/white) to an external amplifier for audio output. 2) Connect the ACC wire (red) to the accessory power of the vehicle as ON/OFF switch of the speakers. 3) Connect the remote out wire (blue) to an external amplifier as ON/OFF switch of the amplifier.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two condition:

(1) This device may not cause harnful interference, and

(2 this device must accept any interference received, Including interference that may cause undesired operation. B6RGB/Waketower Speaker FCC ID: 2AJLC-B6RGB This unit is compliant with FCC standards. AVA ENTERPRISES INC

C5266091_X10_Ed.2 AVA ENTERPRISES INC Office of Engineering Technology Federal Communications Commission 7435 Oakland Mills Road Columbia, MD 21046 Date:

05/31/2022 Subject: Request for Confidentiality FCC ID: 2AJLC-B6RGB To Whom It May Concern, Pursuant to the provisions of Sections 0.457 and 0.459 of Commission's rules

(47CFRO.457, 0.459), we are requesting the Commission to withhold the following attachment(s) as confidential document from public disclosure. Exhibits Long-Term Short-Term Confidentiality | Confidentiality NOTE 2 ID Label/Location No No Attestation Statement No No External Photos No Block Diagram x Schematics Test Report No No Test Setup Photos No Users Manual NOTE 1 Internal Photos NoTe 1 Parts List / Tune Up RF Exposure Info No No Operational Description Cover Letter(s) No No SDR Software / Security Info No NOTE 1: Long-Term Confidentiality may be permitted under special conditions (See Il. LONG-TERM CONFIDENTIALITY, Section 3 of KDB 726920, use last in force) NOTE 2: Short-Term Confidentiality can be requested for a maximum of 180 days from the date of the grant. Above mentioned document contains detailed system and equipment description are considered as proprietary information in operation of the equipment. The public disclosure of above documents might be harmful to our company and would give competitor an unfair advantage in the market. In case of short-term Confidentiality, the applicant requests the exhibits selected above are withheld from public view for a period of days from the date of the Grant of Equipment Authorization and prior to marketing. It is our understanding that all measurement test reports, FCC ID label format and correspondent during certification review process cannot be granted as confidential documents and those information will be available for public review once the grant of equipment authorization is issued. yal C5266091_X10_Ed.2 Sincerely, Signature: Kan John SON Name:ken Johnson Title: Senior Product manager ii

C5266091_X8_Ed.1 Letter of Authorization AVA ENTERPRISES INC Company: AVA ENTERPRISES INC Address: 3451 Lunar Court, Oxnard, CA93030, Oxnard, California, United States. Product Name: Waketower Speaker Model Number: B6RGB, B6ABT FCC Identifier: | 2AJLC-B6RGB We authorize LGAI Technological Center S.A., Ronda de la Font del Carme, s/n, 08193 Bellaterra, Spain, to act on our behalf on all matters concerning the above named equipment. Any individual within LGAI Technological Center S.A. is authorized to act on our behalf and take action on the application. We declare that authorize LGAI Technological Center S.A., Ronda de la Font del Carme, s/n, 08193 Bellaterra, Spain, is allowed to forward all information related to the approval project to the Federal Communication Commission and to discuss any issues concerning the approval application. Any and all acts carried out by LGAI Technological Center S.A. on our behalf shall have the same effect as acts of our own. Name: ken Johnson Date: 05/31/2022 Title: Senior Product manager Signature of applicant: la Joknsoa ii

AVA ENTERPRISES INC Models Declaration Letter We:

Company:AVA ENTERPRISES INC Address:3451 Lunar Court, Oxnard, CA93030, Oxnard, California, United States. Product Name: Waketower Speaker Trademark:

Model Number(s):B6RGB Series Model: B6ABT Difference :Both models are identical except model B6GRGB has an extra board to control RGB function. Signature: kon je bn son Date:05/31/2022 Name: Ken Johnson Title: Senior Product manager Company: AVA ENTERPRISES INC