v.06 12+
LIVE VIDEO STREAMING COVENTRY AVIATION DRONE LIVE VIDEO STREAMING COVENTRY AVIATION DRONE LIVE VIDEO STREAMING COVENTRY AVIATION DRONE GETTING TO KNOW YOUR DRONE PLEASE READ ALL WARNINGS AND INSTRUCTIONS PRIOR TO USE. KEEP THIS DOCUMENT AS IT CONTAINS IMPORTANT INFORMATION ABOUT YOUR DRONE. 1. Turn your drone on and place on a flat, level surface 2. Turn on the remote on and move the left joystick up, then down 3. The beep will indicate successful pairing 4. Repeat steps 1 and 2 if necessary 1. CHARGING Drone must be charged before each use (USB Charge Cable included) Indicator light will turn off once fully charged Install batteries in remote 2. PAIRING Before each flight pair the remote with the drone:
3. DIRECTIONAL LIGHTS White lights indicate the front of the drone Red lights indicate the back of the drone Not applicable in auto-orientation mode 4. REMOTE CONTROL OVERVIEW Practice flying your drone below 10 feet and at low speeds until comfortable with all controls to avoid unnecessary damage or injury To cut power to drone, move left joystick to down position Left joystick:
Right joystick: controls flight direction Direction Trim: use to eliminate drift Up/Down controls elevation Left/Right controls spin QUESTIONS OR CONCERNS?
PLEASE GIVE US A CALL ... WERE HERE TO HELP CUSTOMER SERVICE 1-888-987-6533 Before calling please locate the 10-digit code printed on the back of your remote CHOKING HAZARD SMALL PARTS NOT FOR CHILDREN UNDER 3 YEARS. ADULT ASSEMBLY REQUIRED. INTRODUCTION Congratulations on your purchase of the Streaming 2.4 GHz Coventry Aviation Drone. Get ready to soar to new heights. Master the art of drone flying and stunts with remote control maneuverability. This lightweight stunt drone will provide hours of fun. SPECIFICATIONS Drone Battery: 850 mAh Li-Po Remote Controller Battery: 3 x 1.5V AAA Charging Time: Approximately 180 minutes Maximum Recommended Altitude 120 ft. TABLE OF CONTENTS General Warnings Contents and Remote Battery Installation Charging Battery and Replacing Propellers Remote Overview Operating Drone Modes Tips and FCC Warning Page 1 Page 2 Page 3 Page 4 Page 5 Page 6 Page 7 READ ALL WARNINGS AND PRECAUTIONS BEFORE USE. Prevent contact with spinning blades by turning off remote prior to handling drone. Not recommended for children under 12 years of age. As with all electrical products, precaution should be observed during handling and use to reduce the risk of electrical shock. Adult supervision is required at all times. Before each use, an adult should review the product and battery to determine that no damage or hazards exist. DO NOT TOUCH SPINNING PROPELLERS. Do not allow anything to intentionally make contact in any way with spinning propellers. Use caution and pay attention to your surroundings while operating drone. Do not fly drone into animals, people, or inanimate objects. Keep drone away from power lines, buildings, trees, public areas, and any other potentially hazardous areas. Do not operate in rain, heavy wind, and or any type of severe weather. Do not land drone on wet surfaces. Never touch or allow others to touch drone while it is flying. Always turn drone off when it is not in use. Always fly drone in large open areas. SAFETY WARNINGS:
Never fly drones above or near people, sudden changes in wind or other conditions could lead to unexpected crashes. Always use caution when flying drone vehicles, obey relevant laws, respect the privacy and property rights of others. The drone shall never be modified or used for anything except its intended purpose. Only charge the rechargeable drone battery using the included charging cable. Fly-aways are the responsibility of the individual pilot and will not be replaced by the manufacturer. Invasion of Privacy Warning Always be mindful of others privacy and do not record video or take images of others without their consent. Check and comply with your federal, state and local laws regarding privacy. Page i Page 1 LIVE VIDEO STREAMING COVENTRY AVIATION DRONE LIVE VIDEO STREAMING COVENTRY AVIATION DRONE LIVE VIDEO STREAMING COVENTRY AVIATION DRONE CONTENTS Coventry Aviation Drone LAND Drone Controller Smart Phone Mount USB Charge Cable Replacement Propellors REMOTE BATTERY INFORMATION 1. Unscrew and open the battery compartment. 2. Install 3 AAA batteries as shown in the diagram shown above. 3. Replace and close battery compartment. Rechargeable Battery Warning:
This product contains batteries that non-replaceable. There is a risk of fire and personal injury if battery is punctured, damaged or misused. Do not dismantle, crush, incinerate or short-circuit battery. Never expose battery to extreme temperatures or moisture. Keep away from flammable materials and direct sunlight. Only charge using the provided charger, cable, and/or adapters. Rechargeable battery is only to be charged by an adult. Adult Supervision of the battery while it is charging is required Allow battery to cool to room temperature before charging. Charge on a non-flammable surface and keep away from flammable products Discontinue charging if battery becomes hot, swells, smokes, or gives off a strong odor. Battery chargers used with the product are to be regularly examined for damage to the cord, plug, enclosure, and other parts, and in the event of such damage, they must not be used until the damage has been repaired. Recycle or dispose of battery according to federal, slate, and local laws Keep these instructions for future reference. Alkaline Battery Warning:
Do not mix old and new batteries Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries Alkaline batteries are recommended. Use only the specified voltage. Insert batteries using the correct polarity. Always use, replace, and recharge(if applicable) batteries under adult supervision. Do not charge with non-rechargeable batteries. Do not short-circuit the supply terminal. Do not dispose of batteries in fire, batteries may explode or leak. Remove batteries before storing. Recycle or dispose of batteries according to federal, state, and local laws. Page 2 Connect the Charging Cable to the Drone Insert the Charging Cable into a USB power source CHARGING BATTERY Note: The Battery Charge Cable will light up when it is charging the battery and turn off when the battery is fully charged. Charge time is approximately 180 minutes. Turn off the drone before charging. Connect the Battery Charge Cable to the charging port on the Drone. Connect USB connector to power source. Replacing Propellers 1. Follow diagram 2. Remove screw from top of Propeller 3. Remove broken Propeller and replace with new Propeller 4. Make sure you installed the correct blade. Each blade has a number written on it. Match the blades with the corresponding number on the drone 5. Insert screw into top of Propeller DRONE APP Controls flight direction Speed Control Directional Trim Stunt button Throttle Joystick Increases or decreases drone elevation Spins Drone Spin Trim Auto Orientation Auto Landing Go to your app store on your smart phone and download the FAO Drone application. Live Streaming Options Live Streaming Options Flip Camera View Flip Camera View Take Photos Take Photos Record Video Record Video View Album View Album Pairing Drone - First Time 1. Press the connect to Wi-Fi button 2. Follow the on screen instructions After Connecting Drone 1. Press the Stream Button to begin streaming 2. Press the Album Button to review pictures and videos Page 3 Page 4 LIVE VIDEO STREAMING COVENTRY AVIATION DRONE LIVE VIDEO STREAMING COVENTRY AVIATION DRONE LIVE VIDEO STREAMING COVENTRY AVIATION DRONE INSTALLING PHONE HOLDER Insert antena through hole at the base of the Smart Phone Mount. Align hole on Mount with hole in antena. Insert screw to secure Mount to remote. Carefully slide phone into Mount by pulling up on top of Mount. Adjust angle accordingly. OPERATING DRONE Step 1 Pre Flight Checklist 1. Read all warnings and instructions. 2. Install remote batteries, page 2. 3. Make sure that drone and remote are powered off. 4. Install drone holder. 5. Charge batteries, page 3. Step 2 Choosing a location Drone is designed to be flown indoors and Always make sure you have enough space to fly outdoors. drone. Always follow warnings, page 1. Step 3 Starting Drone 1. Making sure your remote is off, slide drone switch to ON. Drone lights will begin to flicker. 2. Place drone on a flat even surface with clearance according to diagram (Fig 1). 3. Turn remote on. Make sure the left stick (throttle) is in a neutral position (stick is centered). 4. Push the stick up and then down. 5. A single tone indicates that the drone is paired. Drone lights will flicker rapidly then turn on permanently once paired. 6. If pairing is unsuccessful, repeat steps 3-4. Step 4 Lift Off Slowly and carefully press the Throttle Joystick up. Drone will begin to elevate. You can compensate for some of the drones drifting by using the Multi Directional Button or by following Step 5. You may need to practice this step several times before successfully getting drone into the air. Step 5 Drone Begins to Drift Follow this step if your drone begins to drift while take off or during flight. Drone drifts backwards: Press the forward Direction Trim Button. Drone drifts forwards: Press the Backwards Direction Trim Button. Drone drifts left: Press the Right Direction Trim Button. Drone drifts right: Press the Left Direction Trim Button. Drone spins clockwise (viewing drone from top): Press the Left Spin Trim Button Drone spins counter-clockwise (viewing drone from top):
Press the Right Spin Trim Button Read and be aware of all warnings found on Page 1. Maintain your desired elevation by using the Throttle. Push the Throttle joystick to right or left to spin the drone. Use the right joystick to move forward backwards, and side to side. Review step 5 if your drone begins to drift. Drone will begin to blink when drone is paired to remote and battery is low. Step 6 Operating Drone in Flight The drones range is approximately 250 feet or 120 feet of altitude:
Step 7 Landing Drone There are two ways to land the drone:
1. Press the Auto Land Button. The drone will slowly begin to land. If the drone begins to drift, you can still control the drones direction using the Multi Directional Button. 2. Slowly and carefully press the Throttle Joystick down until drone lands. If the drone begins to drift, you can still control the drones direction using the Multi Directional Button. Fig. 1 10FEET 10 FEET 5 FEET 10 FEET 10FEET Always turn off remote prior to retrieving or picking up drone. This will help you avoid accidently activating propellers. Page 5 1. Hover the drone to at least above 10 feet. 2. Press the Stunt Button. You will hear beeping coming from the remote. 3. Move the Multi Directional Button to the desired direction that you would like the drone to flip. MODES Stunt Button Once you are comfortable flying the drone, use the Stunt Button to perform acrobatic stunts. Auto Orientation Button Auto Orientation default setting is off. To enter this mode press Auto Orientation button. Remote will beep twice. After drone is successfully paired, the 2 white LED lights toward orientation will be the original forward orientation, when drone is in auto orientation mode, the drone will orient to the user (remote), no matter what direction the drone is facing. Pushing the right stick up will send the drone away from the user, pushing it to the right will move the drone right, etc. Remote will beep every 6 seconds to indicate the drone is in Auto Orientation mode. To exit mode, press the Auto Orientation button. Remote will sound 1 long beep indicating that it has exited Auto Orientation mode. Note: Auto Orientation mode is oriented to the user when pairing. If the remote is moved after pairing Auto Orientation, please follow directions above to reset Auto Orientation. Auto Landing Button Make sure you have achieved level, balanced flight, where the drone is neither climbing nor descending. This mode allows you to safely and slowly land your drone without having to control the speed. It is done for you automatically. The ideal auto landing height is 25-30 ft. Press the Land button to trigger auto land. Remote will beep continuously until you exit the auto land mode. To steer the drone during landing, use the right control until drone has reached the ground. Press the Land button again to exit auto landing mode. NOTE: Please make sure the throttle joystick is in the down position before exiting auto landing mode Camera taking pictures and creating videos Taking a picture- press camera icon on app once to take a picture. Creating video- press video icon on app once to take a video. Press the video icon on app again to stop recording. CUSTOMER SERVICE 888-987-6533 1) Check that batteries in the remote are installed correctly OR 2) Replace with new batteries. TIPS Do not crash drone into sand or dirt. Drone gears may become clogged. When first learning to fly, practice lifting off and hovering. Stay several feet from walls and buildings. Always press throttle all the way down after crashing or when something gets stuck in propellers. Never fly drones above or near people, sudden changes in wind or other conditions could lead to unexpected crashes. Always use caution when flying drone vehicles, obey relevant laws, respect the privacy and property rights of others. The drone shall never be modified or used for anything except its intended purpose. WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. TROUBLESHOOTING:
When remote switch is turned on, the remote light does not illuminate:
During drone flight, the remote LED is flashing:
Drone and remote properly pair, but the drone will not lift-off:
After trimming the drone, the drone flight is very unstable and cannot fly properly:
After impact, the drone is unstable:
Remote Controller and Drone can not be paired:
Note: If there are 2 sets of Drones within 12 feet for Pairing, you must pair one successfully before pairing the second set. 1) Put the left remote control lever to the left bottom and put the right remote control lever to the right bottom at the same time. This will reset the gyroscope (Fig. 1). 2) If the above does not resolve the issue, reboot the drone and controller and pair again. 1) One or more blades are most likely damaged;
2) Turn off the drone and remote. 3) Replace with the proper number replacement blade and try flying again. 1) Drone battery needs charging. Use the USB Charge Cable to connect the drone to power source. 1) Check Point: Remote Controller must be closed to Drone, not exceed 12 feet. 1) Remote batteries are low; replace them with new batteries.
(Fig. 1) This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures:
FCC RF Radiation Exposure Statement Caution: To maintain compli
- Reorient or relocate the receiving antenna,
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. ance with the FCCs RF exposure guidelines, place the drone least 20cm from nearby persons. FAO and FAO Schwarz names and logos are trademarks or registered trademarks. All rights reserved. Distributed by 2017 MerchSource, LLC, Irvine, CA 92618. For customer support please call 888-987-6533. The artwork and design of this package are protected by US copyright law and may not be reproduced, distributed, displaced, published or used for any purpose without prior written permission. Altering, removing or reproducing any of the trademark or copyright notices on this package is not permitted. Page 6 PATENT PENDING Printed in China Page 7