Product Description Smarter Eye Cl is an advanced driver-assist product that can provide alarms to the driver in certain potentially dangerous situations. Power interface Warning indicator light Indicator light Standby/reply Camera regulation mouth Installation Tips Friendly reminder: Adjust the visual angle of the camera combined with the mobile client during the installation of Smarter Eye C1, please download Smarter Eye APP in advance. Please install this product in strict accordance with the following steps, Our company shall not be liable for product failure, personal damage and property damage caused by wrong installation of the product Scan the download to download it Device Installation Please wipe up the windshield in front of the automobile before installation, and conrm whether you have downloaded Smarter Eye app. The angle of ADAS camera shall be adjusted combined with Smarter Eye app. Step one Take out the installation aid in the box, and paste it at the center of the windshield in the front, (under the original), and keep it horizontally centered as shown in Figure 1. Make one end of the aid scaleplate hold out against the juncture of front windshield and top carport. If the aid scaleplate is too long, it can be cut at identical graduation ( ensure the aid is horizontal). Smarter Eye C1 Installation and operating instructions Warning!
Smarter Eye C1 product can not replace safe and prudent driving. Please do not change the system settings of Smarter Eye C1 product during driving!
Please don't adjust the knob in the binocular camera before reading the installation and operating instruction of Smarter Eye C1 product carefully. After installing the SmarterEyeC1 product, it is deemed that you have conrmed and agree to operate the Smarter Eye C1 product according to the safety tips and warnings. 1, Smarter Eye C1 is an advanced driver-assist product that can provide alarms to the driver in certain potentially dangerous situations. It can not replace the normal operation of the driver when driving a motor vehicle, nor should the driver be less alert during driving when using it, but the driver must comply with all the safe driving standards and practices and comply with trac rules and laws and regulations. 2, Smarter Eye C1 system is not an automatic driving system, which can not replace the operation of the driver or safe driving practice. The driver must not rely on Smarter Eye C1 to any extent, but remain cautious at any time to ensure the driving safety and avoid accidents. 3, Although Smarter Eye C1 has advanced stereo vision software and other specialized techniques, Smarter Eye C1 can't guarantee complete detection of vehicles, pedestrians, trac signs or lanes, thus can not guarantee to provide any sound or visual warning. In addition, the road face, weather and other conditions will havean impact on the identication and reaction capacity of the Smarter Eye C1 system. The driver can not rely on Smarter Eye C1 to ensure safe driving, but comply with safe driving practices. 4. We have made all the eorts to ensure the accuracy of all the information in this user's manual, but there is possibility of dierence caused by non-subjective negligence. In order to improve the functions or eects of the product, the equipment specications and instructions in this guide are to be modied. You can report the errors or omissions you have found to the technical support department of Beijing Smarter Eye Technology Co,Ltd. E-mail: service@smatereye.com 5,The company reserves the Instruction of Smarter Eye C1 Installation and Operating, the nal interpretation. 1 Function Descriptions Forward Collision Warning - FCW At the speed of more than 10km / h, when the vehicle may collide with any objects (such as cars, pedestrians, bicycles, ower beds, etc.) in front, Smarter Eye C1 will give the driver an alarm of certain frequency according to the dangerous level, in the meanwhile, red light ickers at the side of the car body. FCW gives an alarm up to 2.7 seconds in advance. Lane departure warning - LDW At the speed> 50km / h, when the vehicle is traveling while imposing lines, the Smarter Eye C1 system give give an alarm, to remind you to go back to the lane, in the meanwhile, yellow light ickers at the sides of the car body. City forward collision warning - CFCW At the speed of 0 - 30km / h, when the vehicle may collide with any objects (such as cars, pedestrians, bicycles, ower beds, etc.) in front, Smarter Eye C1 will give the driver an alarm of certain frequency according to the dangerous level, in the meanwhile, red light ickers at the side of the car body. Instructions Smarter Eye C1 system is activated automatically when you are starting the vehicle parameter settings The warning function of Smarter Eye C1 system can be set according to personal demands Double faced adhesive tape 2 3 Camera Correction Step one Make sure that the device interface is properly connected, and start the vehicle to power on the device. If the green indicator light beside the power supply button is on, it indicates that the connection is correct, if it is not on, please refer to Figure 6 to check the device display. Step Three Enter the WIFI use interface to click conrm, and the connected device list pop up. Click the product name to connect the product (default name: Smarter Eye C1). The Apple phone users should connect it manually in the mobile phone settings for the rst time use, and input the Wi-Fi password: 12345678. Enter the connection interface through app. connection interface. Step four After the device is successfully connected, insert a hexagon tool into the groove 1 at the side of the binocular camera, and click the correction function 2 of the camera in the APP, switch the hexagonal tool to adjust the camera angle with reference to the sample image. 1 Insert the hexagon tool into the groove at the side of the product. green light: normal red light: standby No light: the device is not properly connected or the interface is not connected Figure 6 Step two Open the SmarterEye app to connect device (scan the QR Code in the manual to download app if there is no app in your phone), click the device powered on, and click on the next step as shown in Figure 7. 2 Switch the hexagonal tool, and pay attention to the display of the mobile phone(refer to the picture below to make adjustment). Step Five After the angle is adjusted correctly, take the hexagonal tool down and then the angle of the camera is locked, and the correction is completed. Installation completed!
Reminder: Please read the product description carefully before using Smarter Eye C1. If there is no display, make sure that the WIFI of the phone is on. If it is an Apple phone, please open the permission of WIFI connection. Keep within one meter range of ADAS. Please wait patiently if it is connected, and delay is permitted for the rst connection.
*Note: When adjusting the camera, it is necessary to make the horizon of the picture outside the car shown in the mobile phone and the red line coincide. Rotate the rotary knob to the bottom, if the horizon and red line still cannot coincide, make sure that the horizon is close to the red line to the greatest extent. 8 9 10 Figure 7 7 Step two As shown in Figure 2 and 3, unmask tear down the double faced adhesive tape from the device, and then paste the device to the frame at the bottom of the aid, and then press hard. Step Three Plug one end of the OBD plug of power line into the OBD interface 1, and the other end into the power outlet 2 of Smarter Eye C1 1 OBD Figure 4 2 Connect the power line Connect the OBD interface of the automobile Figure 5 6 Regulatory Notices America This equipment has been tested and found to comply with the limits for a Class B digital device,pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protectionagainst harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. FCC Caution:
Any changes or modications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated withminimum distance 20cm between the radiator & your body. 160 150 140 130 120 110 100 90 80 70 60 50 40 30 20 10 160 150 140 130 120 110 100 90 80 70 60 50 40 30 20 10 Figure 2 mid Figure 3 Note: ensure that there are no vehicles sunshade net and other objects at the location where the binocular camera is pasted. 5 Other Notes Product limitations The lane departure warning of the Smarter Eye C1 system is suitable for asphalt road with clear lane marks. Based on the characteristics of this product and technical limitations, omissions, mistakes or defects occur, when the Smarter Eye C1system is detecting the vehicle, pedestrian or lane, or giving a warning against potential road trac danger, shall not be regarded as the basis for the judgment of unqualied products or claiming for compensation. Smarter Eye C1 system can't replace the driver to
"observe" road conditions. The driver should keep alert during driving and drive according to his own observation or knowledge of road conditions. Please be sure to drive according to the actual trac conditions and trac rules. The Company doesn't assume any responsibility for the trac accident and the various losses caused thereby. In addition, the road surface, weather and other conditions will aect the Smarter Eye C1 system. Covering part or full view of the binocular camera can cause the function failure or decrease of Smarter Eye C1 system. Please ensure clear vision of the binocular camera. Limited license The software used in this product is the property of Beijing Smarter Eye Technology Co, Ltd. Beijing Smarter Eye Technology Co, Ltd award purchasers non-exclusive license of the software, and the purchaser is forbidden to:
(1) modify, ret, change or convert the software used in the product or the software provided along with the Smarter Eye C1 product, or use it to produce derivative products, (2) reverse assembly, de-compile, disassemble, etc.to obtain the source code of software (3) transfer, sublicense, lease, contact, transfer, disclose the software, etc., or (4) remove the property right of the product or the corresponding document. Figure 1 Note: The position of the aid should be in the middle of the front windshield of the car. Refer to the position of the rear view mirror bracket when pasting it, to ensure that the aid is level and not slant. Make sure that the mounting bracket at the bottom of the aid is within the wiping range of the windscreen wiper when pasting the aid. Ensure that the sunshade net at the rear of rear view mirror is not within the mounting frame at the bottom of the aid when pasting the aid. You can cut out the aid scaleplate according to your own demand, and ensure that the remaining two numerical values of dividing rulers at the left and right are the same (ensure that the aid is level) 4 Smarter Eye ADAS Standard Project Eective measurement distance View angle Maximum frame rate resolution ratio Baseline distance Image type Data depth Dynamic range Maximum measurement error 30 m range measurement error service voltage Describe 3m-60m 40 15FPS 640x480p
>100mm Black and white 8bit 120db
<10%
<5%
12V
-20C~ 60C Note : This function can not be disabled or muted, but if Smarter Eye C1 is in standby mode or the power is turned o , the system will not give a warning. Note: This function can not be disabled or muted, but if Smarter Eye C1 is in standby mode or the power is turned o, the system will not give a warning. Note: This function can not be disabled or muted, but if Smarter Eye Cl is in standby mode or the power is turned o, the system will not give a warning. operating temperature 1.Don't adjust the binocular camera lens arbitrarily in daily use. 2.Please don't transfer Smarter Eye C1 between dierent vehicles. 3.Please don't cover the product to ensure normal operation of Smarter Eye Cl system.Please remove the foreign matters at the front windshield in time if there are. 11 12 13 14 15 16 17 All rights reserved by Beijing Smarter Eye Technology Co,Ltd.Please read this installation and operating instruction carefully and keep it in good care