belkin.com Belkin Tech Support US: 310-898-1100, ext. 2263 800-223-5546, ext. 2263 UK: 0845 607 77 87 Australia: 1800 235 546 New Zealand: 0800 235 546 Europe: www.belkin.com/support 2009 Belkin International, Inc. All rights reserved. All trade names are registered trademarks of respective manufacturers listed. 8820-0 0400 F5L075-USB FCC Statement
(15.21) Warning: Changes or modications to this unit not expressly approved by the party responsible for compliance could void the user authority to operate the equipment. 15.19 (a)(3) This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. IC Statement Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device Wireless Mouse Quick Installation Guide Wireless Mouse 2 On/Off Button Mouses Connect Button 5 1 Battery Compartment Cover 3 The Receiver 4 Receivers Connect Button Quick Installation Guide Setup Instructions Connect the mouse and receiver when you use the mouse for the first time and when replacing batteries. 1. Remove the battery compartment cover and install two AAA alkaline batteries as indicated by the polarity symbols (+/-), then replace the cover. 2. Turn on the mouse. 3. Plug the receiver into an available USB port. 4. Press the USB receivers Connect button. 5. Press the mouses Connect button. Note:
The unit will go into stand-by mode after a few seconds of idling. Slide the mouse around to wake it up. The unit will go into sleep mode after 68 minutes of idling and the LED will go off. Click the mouse button to wake it up.