Bernafon Radio Model - Quick Installation Radio Model Name: Aurora ITE The Aurora ITE radio model contains a radio transceiver running at 3.84 MHz and a transceiver running at 2400MHz-2483MHz implemented on a single hardware platform. The 3.84 MHz radio is a low power, short range, inductive radio transceiver working at a single channel at 3.84 MHz using MSK modulation with 320 kbit/s data rate and connected to a small coil antenna. The radio model is implemented in an engine module mounted on the main PCB with connections to the antennas, the microphones, the speaker and the battery terminals. The radio model can be seen in in the picture below:
Speaker 2,4 GHz Antenna Microphone Battery chamber Microphone Main PCB 3,84 MHz coil antenna 1 Bernafon Radio Model - Quick Installation Radio Model Name: Aurora ITE The Aurora ITE radio model requires only a single cell battery (size 13 or size 312) to be attached and a customized plastic shell, holding everything together, in order to be operational as a fully functional hearing aid. An example is shown here:
Speaker Battery chamber Microphone 2,4 GHz Antenna Main PCB Microphone Coil antenna 2 Bernafon Radio Model - Quick Installation Radio Model Name: Aurora ITE The Aurora ITE radio model is intended to be installed in Bernafon wireless ITE hearing aid devices (In-The-Ear) styles. 3 Bernafon Radio Model - Regulatory Label Information for USA & Canada The following information will be part of the User Manual for the final product:
Radio Model Name: Aurora ITE 13 / Aurora ITE 312 If size 13 battery is used:
Contains: FCC ID:
IC:
U6XAUITE13 7031A-AUITE13 If size 312 battery is used:
Contains: FCC ID:
IC:
U6XAUITE312 7031A-AUITE312 NOTICE:
This device complies with Part 15 of the FCC Rules and with RSS-210 and RSS-247 of Industry Canada. Operation is subject to the following two conditions:
(1)
(2) This device may not cause harmful interference, and This device must accept any interference received, including interference that may cause undesired operation. Changes or modifications made to this equipment not expressly approved by Bernafon AG may void the FCC authorization to operate this equipment. Le prsent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorise aux deux conditions suivantes:
(1)
(2) compromettre le fonctionnement. l'appareil ne doit pas produire de brouillage, et l'utilisateur de l'appareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible d'en 4