THE PRODUCTS LIST:
Mr.ESP1 Silicone Headset1 Charging Cable1 Instruction Manual1 CERTIFICATE 1 WARRANTY1 1. Boot Tap the switch button LEDs of Red and blue alternately illuminate (shown in the picture) 2. Wear Three electrode pads cling to the forehead. Adjust to fit size, make sure it is not loose. Two beeps indicates that it is worn correctly 3. Connect Open Bluetooth in the phone "Settings" and connect to the MrESP device. When the device red light disappears, it indicates that the Bluetooth has been connected.
(Use our company's peripheral hardware to automatically connect to Bluetooth) 4. Charging Poor signal when low battery. Basic parameters Product model: BIO-MR-17001 Working temperature: -10 - +50 degrees Celsius Operating humidity: 0-95% RH, no condensation Input voltage: 5V Connection method: wireless connection This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirement. The device can be u sed in portable exposure condition without restriction