Wein Federal Communications Commission (FCC) Rules This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference re-
ceived, including interference that may cause un-
desired operation. This equipment has been tested and found to comply with the limits for a Class B di-
gital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable pro tection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not in-
stalled and used in accordance with the instruc:
tions, may cause harmful interference to radio com-
munications. However, there is no guarantee that in-
terference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determ-
ined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following:
= Reorient or relocate the receiving antenna.
= Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a cir cuit different from that to which the receiver is connected.
= Consult the dealer or an experienced radio/TV technician for help. Changes or modifications made to the product without Boschs consent is prohibited and may void the user's ability to operate the equipment. Region |Agen |Certification ey lus and [Model Icanada [iq RF-UT-1A207-CO-433 ISED IC ID: 12494-EICO
|RSS210, issue 9 Foc |Fcc 1D: T3xICO Industry Canada (IC) Rules This device complies with Industry Canada licence-
exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le prsent appareil est conforme aux CNR dIndustrie Canada applicables aux appareils radio exempts de licence. exploitation est autorise aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit ac-
cepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible den compromettre le fonctionnement. Under Industry Canada regulations, this radio trans-
miter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i-p.) is not more than that necessary for successful communication. Conformment a la rglementation dIndustrie Canada, le prsent metteur radio peut fonctionner avec une antenne d'un type et d'un gain maximal
(ou infrieur) approuv pour Imetteur par Indus-
trie Canada. Dans le but de rduire les risques de brouillage radi-
lectrique a lintention des autres utilisateurs, i faut choisir le type dantenne et son gain de sorte que la puissance isotrope rayonne quivalente
(p.ire.) ne dpasse pas lintensit ncessaire 8 I't-
ablissement d'une communication satisfaisante.