FCC ID: 2ADRG-BRY230N Wireless desktop trackpad

C-Touch User Manual Mode demploi 1 POWER To power on, slide power switch on back of unit from left to right and release. LED will turn green for three seconds to indicate trackpad is on. To power off, slide power button to left and release. 2 PAIR Once trackpad is on, slide the power switch to the right

(towards the LED) and hold for three seconds. LED will flash blue until the trackpad is successfully paired. On your device under Bluetooth settings select Brydge C-Touch. 3 SLEEP MODE Your Brydge C-Touch is designed to operate for extended periods of time between charges. To conserve the battery, it will enter sleep mode after 10 minutes of non-use. 4 CHARGE To charge your Brydge C-Touch, insert the supplied USB-C cable into the charging port. The battery is charging when the LED flashes red. The LED will turn off when the battery is fully charged. 5 WIRED OPERATION Wired operation is not supported. The USB-C cable is provided for charging only. 1 ALIMENTATION Pour allumer, faite glisser le bouton dalimentation de gauche droite au dos de lappareil puis relchez. La LED sera verte pendant trois secondes pour vous indiquer que le pav tactile est allum. Pour teindre, faite glisser le bouton dalimentation vers la gauche puis relchez. 2 JUMELER Une fois le pav tactile allum, faite glisser le bouton dalimentation vers la droite (en direction de la LED). La LED clignotera bleue jusqu ce que lappareil soit jumel. Slectionnez Brydge C-Touch dans Bluetooth de votre appareil. les paramtres 3 MODE VEILLE Le C-Touch a t conu pour fonctionner pendant une priode prolonge entre les chargements. Pour prserver la charge de la batterie, votre appareil entrera en mode veille aprs 10 minutes dinactivit. 4 CHARGER Pour charger votre Pav Tactile C-Touch Brydge, insrez le cble USB-C dans le port de chargement. La LED clignote rouge pour indiquer que la batterie est en cours de chargement. Une fois le clavier compltement charg, la LED rouge steindra. 5 MODE CBL Le mode cbl nest pas soutenu. Le cble USB-C est fourni dans un but de chargement seulement. HAVE A QUESTION?

Visit www.brydge.com/support WARRANTY: Thank you for purchasing a Brydge product. This product comes with a 1-year limited hardware warranty on the terms and conditions set out in this document and at www.brydge.com/warranty. All Brydge warranties are non-transferrable and are only available to the original end-user of the product. Warranties do not apply to products purchased from online vendors unauthorized to sell Brydge-branded product. To obtain warranty service, visit www.brydge. com/support. Proof of purchase is required to verify eligibility. This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canadas licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device. This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communi cations. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna Connect the equipment into an outlet on a circuit different from that to which Increase the separation between the equipment and receiver the receiver is connected Consult the dealer or an experienced radio/TV technician for help. CAUTION DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS The battery shall not be exposed to excessive heat such as sunshine, fire or the like. Operating Temperature: 045C 2019 Brydge. All Rights Reserved. | This product has been certified by Brydge to meet Googles compatibility standards. Google is not responsible for the operation of this product or its compliance with any applicable safety or other requirements. Learn more at g.co/madeforgoogle. Googles made for badge, Chrome and related marks are trademarks of Google LLC. USB Type-C and USB-C are trademarks of the USB Implementers Forum. The Bluetooth word mark and logos are owned by Bluetooth SIG Inc. and any use of marks by Brydge is under license. VOUS AVEZ DES QUESTIONS?

Visitez www.brydge.com/support GARANTIE: Nous vous remercions davoir achet un produit Brydge. Ce produit est accompagn dune garantie matrielle limite dun an aux conditions prvues dans ce document et sur www.brydge.com/warranty. Toute garantie Brydge ne peut tre transfre et est applicable seulement lutilisateur initial du produit. Les garanties ne sappliquent pas aux produits achets auprs de vendeurs en ligne non-autoriss vendre des produits de la marque Brydge. Pour bnficier dun service sous garantie, visitez le site www.brydge.com/support. Une preuve dachat peut tre exige pour vrifier lligibilit. Cet appareil contient un metteur-rcepteur exempt de la licence CNR en conformit avec Innovation, Sciences et Dveloppement conomique Canada. Le fonctionnement de cet appareil est soumis aux conditions suivantes : (1) cet appareil ne doit causer aucune interfrence nuisible. (2) cet appareil doit accepter toute interfrence reue, y compris celles risquant dentraner un fonctionnement prjudiciable. Ce dispositif rpond aux limites de la norme CNR-102 sur lexposition aux rayonnements tablies pour un environnement non-contrl. Cet metteur ne cohabitera pas ou ne sexploitera pas en conjonction avec tout autre antenne ou metteur. Ce dispositif est conforme la section 15 des rglementations de la FCC. Le fonctionnement de cet appareil est soumis aux conditions suivantes : (1) cet appareil ne doit causer aucune interfrence nuisible. (2) cet appareil doit accepter toute interfrence reue, y compris celles risquant dentraner un fonctionnement prjudiciable. Les changements ou les modifications non expressment approuves par le fabricant peuvent annuler lautorisation de lutilisateur faire fonctionner lappareil. Cet quipement a t test et dclar conforme aux limites pour appareils numriques de classe B, selon la section 15 des rglements de la FCC. Ces contraintes sont destines fournir une protection raisonnable contre les interfrences nuisibles quand lappareil est utilis dans une installation rsidentielle. Cet quipement produit, utilise et peut mettre de lnergie radio lectrique et, sil nest pas install et utilis conformment aux prsentes instructions, peut causer des interfrences nuisibles aux communications radio. Cependant, il ny aucune garantie que de telles interfrences ne se produiront pas dans une installation particulire. Si cet appareil cause des interfrences nuisibles la rception des signaux de radio ou de tlvision, ce qui peut tre dtermin en allumant et en teignant lappareil, on encourage lutilisateur dessayer de corriger ces interfrences par lun des moyens suivants :

Rorienter ou dplacer lantenne rceptrice loigner lquipement du rcepteur Brancher lquipement une prise autre que celle du circuit auquel le rcepteur Sadresser au revendeur ou un technicien radio/TV expriment pour obtenir est reli de laide. MISE EN GARDE JETER LES PILES USES SELON LES INSTRUCTIONS La batterie ne doit pas tre expose une chaleur excessive telle que le soleil, le feu ou similaire. Temprature de fonctionnement: 0-45C 2019 Brydge. Tous les droits sont rservs. | Ce produit a t certifi par Brydge pour tre en conformit avec les standards de compatibilit de Google. Google nest pas responsable du fonctionnement de ce produit ou des normes applicables en matire de scurit et autres exigences. Pour en savoir plus cliquez sur g.co/madeforgoogle. Le logo Made for Google, Chrome et autres marques associes sont des marques dposes de Google LLC. USB Type-C et USB-C sont des marques commerciales de USB Implementers Forum. La marque et les logos Bluetooth sont la proprit de Bluetooth SIG Inc. et toute utilisation des marques par Brydge est sous licence.

BRYDGE GLOBAL Federal Communications Commission Authorization and Evaluation Division 1435 Oakland Mills Road Columbia, MD 21046 Date: 2020/11/26 SUBJECT: FCC Application for (FCC ID: 2ADRG-BRY230N) To Whom It May Concern:

We, the undersigned, hereby authorize Alisa Feng in Shenzhen Huaxia Testing Technology Co., Ltd at 1F., Block A of Tongsheng Technology Building, Huahui Road, Dalang Street, Longhua District, Shenzhen, China on our behalf, to apply to the Federal Communications Commission on our equipment. Any and all acts carried out by Shenzhen Huaxia Testing Technology Co., Ltd on our behalf shall have the same effect as acts of our own. This is to advise that we are in full compliance with the Anti- Drug Abuse Act. We, the applicant, are not subject to a denial of federal benefits pursuant to Section 5301 of the Anti-Drug Act of 1988, 21 USC853a, and no party to the application is subject to a denial of federal benefits pursuant to that section. Sincerely,

(Must be signed by the person that is listed on the FCC Website) Signature:

Contact name: Nicholas Smith Company name: BRYDGE GLOBAL Address: 1912 Sidewinder Dr #104, Park City, Utah, United States, 84060 Date: 04/17/2018 VCB_F-01: Operating Procedures Form FCC Authorization v02 Page 1 of 1

File Name 1. 2ADRG-BRY230N -Block diagram 2. 2ADRG-BRY230N -SCH 3. 2ADRG-BRY230N -Operational description BRYDGE GLOBAL Federal Communications Commission Authorization and Evaluation Division Confidentiality Request regarding application for certification of FCC ID:

2ADRG-BRY230N Pursuant to Sections 0.457 and 0.459 of the Commissions Rules, we hereby request confidential treatment of information accompanying this application as outlined below:

Exhibit Type 1. Block Diagram, 2. Schematics, 3. Operational Description The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these materials may be harmful to the applicant and provide unjustified benefits to its competitors. The applicant understands that pursuant to Section 0.457 of the Rules, disclosure of this application and all accompanying documentation will not be made before the date of the Grant for this application. Pursuant to DA04-1705 June 15, 2004 of the Commissions public notice, we also request temporary confidential treatment of information accompanying this application as outlined below for an initial period of xxxx (ie- 45, 90 or 180) days:

Exhibit Type N/A Signature:

File Name N/A Contact name: Nicholas Smith Company name: BRYDGE GLOBAL Address: 1912 Sidewinder Dr #104, Park City, Utah, United States, 84060 Date: 04/17/2018 VCB_F-01: Operating Procedures Form FCC Confidentiality v02 Page 1 of 1