cover pages 1 & 2 pages 3 & 4 a u d i o I Bluetooth
Package Contents:
True Wireless Earbuds ModelIH-AU-BE-302 Charging Travel Case Micro USB Charging Cable Instruction Manual Specifications:
or: Micro USB BluetootVersion:
5.0 Working distance:
33 ft Charge Connect Sensitivity:
105 dB3dB Play time: 2-3 hrs Standby Charging Case Battery:
Case Charge time: 1.5 hrs Charges Earbuds Battery:
Earbuds Charge time: 1hr time: approx 80 hrs voltage:
5V/1A from case: approx 2.5 2 x 40 mAh 300 mAh Operation Guide Getting Started Basic Functions Control Surface Indicator LED Before using this device, Charging can be found on page 6. instructions fully charge it. Right Earbud:
, Double press the control surface to play or pause the audio. case and take out Both LED lights Open the charging the earbuds. will flash red and blue until one of the earbuds flashes earbud flashes right and left earbuds each other. red and blue, while the other blue, indicating that the have synced to Press and hold to skip to the next audio track. Single press to raise the volume. Left Earbud:
Press and hold to skip to the previous audio track. Pairing Single press to lower the volume. 1.Go to Bluetooth Settings on your Phone calls mobile device. 2.Turn BluetootON,on your device, 3.On your Bluetooth select device.
"iH AUBE302" from the list of available devices. 4.The earbud indicator LEDs will shut off to indicate they are connected. When there is an incoming will pause the playback and ring to alert you of the call. Phone call functions the same on either of the earbuds.*
call, work the unit single press surface earbud. double press the control call, of either To answer an incoming the control end a call, surface. and hold the control
*Volume controls with some smartphone models. an incoming surface. may not work during phone call, press To reject calls To Indicator LEDs Micro USB Charging Port Reset button TRUE WIRELESS EARBUDS pages 5 & 6 pages 7 & 8 back Troubleshootings Charging Warnings FCC FCC ID: 2AHN6-AUBE302 Warranty QfJ 3.Plug the cable into a standard USB metallic objects. Earbuds do not sync with each other:
1.Replace the earbuds in the case. 1.Place the earbuds take out the earbuds, earbuds are turned on. in the case, then both ensuring 2.Connect the Micro USB charging cable to the charging bottom of the case. port on the 2.On each earbud, press and hold the for 5 seconds. The surface control earbud will turn off after the LED flashes purple 3 times. 3.Replace the earbuds in the charging case. 4.Repeat the Getting Started process. Earbuds do not pair to device:
1.Turn the Earbuds OFF by pressing the control surface until the LED blinks turns off. on each earbud red, and then 2.Replace the earbuds in the case. Turn Bluetooth OFF and your device's then back ON. Then repeat the pairing process. 5V/1A or higher power output. the indicator When you plug the case into a charging mechanism inside available the case battery of the case flash. case battery is being charged. This indicates charge and means LEDs on the While this is happening buds inside indicates they are being charged. the case glow solid red, which the lights on the When fully charged solid and the earbud LEDs will shut off. the case LEDs will glow 4.When fully charged, unplug the charging cable from the power source. from the the earbuds If want to charge charge case internal replace will show battery the LEDs on the buds will glow solid red. them in the case. The case LEDs battery, status while charging, simply Do not use this unit for anything other than its intended use. product. Do not puncture, throw, drop, bend, or modify this Do not throw this product Do not short-curcuit the battery into fire or water. with any metal or FCC STATEMENT :
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the injury equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment sunlight, generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause or seat of a vehicle. harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. a choking such should only be hazard a Do not expose this product to corrosive liquids such as salt water. Do not operate to prevent yourself Do not allow the unit if it has been wet or moist against electric shock and/or to and damage to the unit. children to play with this product as it is not a toy, and may present Avoid leaving your device as on the dashboard, your device, Do not leave in direct console, or use your device, in the temperature is likely to drop any area where below 32F, or may exceed closed on a hot day. vehicle to electrical Repairs equipment 140F, such as inside electrician. by a qualified performed repairs Protect Improper may place the user at serious risk. your hearing Prolonged your hearing at a safe listening may use at elevated volumes in level. affect hearing loss. and could result capacity by always Use the earbuds To avoid damage with this charging to the charging case only. case, please only use a USB 5V/1A or higher charger. RF warning statement:
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. In order to ensure once a month. at least the battery life, charge normally this product purchaser free from defects and with regard to this limited to repair purchase at its option, shall be limited solely of any Bytech NY INC. warrants to be materially workmanship to the original for a period of 12 months from the original date. Bytech responsibility warranty or replacement product use. This warranty consumer extend to damage or failure results alteration, abuse, or maintenance. 12 months period following purchase, defects return freight the defective prepaid) from misuse, in material the product product improper At any time during the which fails during normal does not which accident, neglect, or workmanship, with proof of purchase. fails due to
(with the installation WWW.BYTECHINTL.COM Bytech NY Inc 2585 West 13street Brooklyn
(718)449-3700 NY 11223 CE @J (j e). MADE IN CHINA 2020 BYTECH NY INC.
*All trademarks property and copyrights are the of the respective companies.
-AU-BE-302-WT User Manual v1 052120 Black ink only, thin glossy paper, staple saddle bound, 5 sheets front & back