Regulatory & Warnings section of Ducati vehicle manual Radio components Certifications Radio equipment installed in the vehicle Frequency band Max Transmission Power 04610242, 04610243 134.9 kHz 49.3 dBV/m @10m Radio equipment installed in the vehicle 04610242, 04610243 Manufacturers' addresses C.O.B.O. S.p.A. Via Tito Speri, 10 - 25024 - Leno (BS) - Italy FCC/ISED certifications The manufacturers of these radio equipment declare that devices comply with the FCC and ISED regulations. Type FCC ID IC ID 04610242, 04610243 2AVOV-04610242 25864-04610242 HVIN: 04610242- PMN: 04610242 HVIN: 04610243- PMN: 04610242 To comply with FCC and ISED RF exposure compliance requirements, a separation distance of at least 20 cm must be maintained between the antenna of these devices and all nearby persons. FCC Certification FCC CFR 47 Part 15, 15.19, (a) (3) Compliance information This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC CFR 47 Part 15, 15.105 Compliance information This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. FCC CFR 47 Part 15, 15.21 Information to user Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Regulatory & Warnings section of Ducati vehicle manual ISED Certification Responsible partys contact located in the Canada:
Name: Ducati Canada Address: 777 Bayly Ave. Ajax ON Canada L1S7G7 Contact: Steven Hicks Tel: cell. +1 705 878 2231 - office +1 705 786 7768 Fax: +1 705 786 7768 Email: steve.hicks@ducati.com Company n. 23452 This device contains licence-exempt transmitter/receiver that comply with Innovation, Science and Economic Development Canadas licence exempt RSS(s). Operation is subject to the following two conditions: (1) this device may not cause interference; (2) this device must accept any interference, including interference that may cause undesired operation of the device. Lemetteur/recepteur exempt de licence contenu dans le present appareil est conforme aux CNR dInnovation, Sciences et Developpement economique Canada applicables aux appareils radio exempts de licence. Lexploitation est autorisee aux deux conditions suivantes: (1) lappareil ne doit pas produire de brouillage; (2) lappareil doit accepter tout brouillage radioelectrique subi, meme si le brouillage est susceptible den compromettre le fonctionnement. ICES-003 Class B Notice - Avis NMB-003 Classe B:
This Class B digital device complies with Canadian ICES-003. Cet appareil numerique classe B est conforme la norme Canadien ICES-3(B)/NMB-3(B). CAN ICES-3(B) / NMB-3(B)