FCC ID: AZD322 Wireless Module

User Manual This is Limited modular approval as this module is limited to installation by the grantee into our host systems This Wireless LAN Module is not sold to general end users directly. For the details about this module, please refer to the specification sheet of module. This module should be installed in the host device according to the interface specification (installation manual). This device complies with below part 15 of the FCC Rules. Part 15 Subpart C The end product must be labeled Contains FCC ID: AZD322/ IC: 498J-322 Following statement must be included in the user manual of host device. FCC/IC Notice Model: CD1171 (including WLAN Module Model WM322, FCC ID: AZD322 / IC: 498J-322) This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines and RSS-102 of the IC radio frequency

(RF) Exposure rules. This equipment should be installed and operated keeping the radiator at least 20cm or more away from persons body. This device complies with Part 15 of FCC Rules and ISEDs applicable licence-exempt RSSs. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of this device. This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter. Do not make any changes or modifications to the equipment unless otherwise specified in the manual. If such changes or modifications should be made, you could be required to stop operation of the equipment. The modular transmitter is only FCC authorized for the specific rule parts (i.e., FCC transmitter rules) listed on the grant (FCC Part 15.247), and the host product manufacturer is responsible for compliance to any other FCC rules that apply to the host not covered by the modular transmitter grant of certification. The final host product still requires Part 15 Subpart B compliance testing with the modular transmitter installed. The following statements shall be described after confirming that the end product complies with FCC Part 15B. FCC Notice operation. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions;

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause undesired Note: This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. The cable with the ferrite core provided with the printer must be used with this equipment in order to comply with Class B limits in Subpart B of Part 15 of the FCC rules. Canon U.S.A., Inc. One Canon Park, Melville, New York 11747, U.S.A. Tel No. 1-800-OK-CANON (1-800-652-2666) Canadian Radio Interference Regulations CAN ICES-3 (B)/NMB-3 (B)

ca oll CANON INC HEADQUARTERS 30-2 SHIMOMARUK0 3 CHOME OHTA Kt .TOKY0 146 R501 JAPAN PHONE:(03)3758 2111 Letter ofAuthorization Date:July 21)2021 UL Verincation Ser ces lnc. 47173 Benicia Street,Fremont,CA 94538 Applicanti Canon lnc FCC ID:AZD322 To whom it may concerll:

Wc,thc undersigned,hereby authorize Akiko Nishirnura ofConsumer Technology Division,UL Japan, Inc.to act on our bchalfin ali manners relating to application for equipment authorization)including signing ofall documents relating to these rnatters.Any and an acts cattried out by l L Japan,Inc.on our bchalfshan have the same effect as acts ofour o vn. We,thc undersigned,hereby cehitt that we are not suttect tO a den l of federal bcncits,that includes FCC beneits,pursuant to Section 5301 of the Anti Drug Abuse Act of 1988,21 UoS.C, 862 This authorization is valid until further written noticc from the applicant. Thc applttation forhe suttect equipment has not been submitted to another TCB fOrceniicatiOn. Sincerely Yours, Tomohiro Suzuki Canon lnc

ca CANON INC HEADQUARTERS 30 2,SHIMOMARUK0 3 CHOME OHTA KU .TOKY0 146-8501 APAN PHONE I(03)3758 21 11 Request for Linlited IOdular TransElitter pproval October 14,2021 FCC ID :AZD322 Apphcanti Canon lnc This transmitter,model:WM322 is designed by us. It compties with the modular transmitters basic requirements(Item i to 8)in FCC Part 15 Subpart C Section 15 212 as indicated belowi This is Lilnited lnodular approval as this lnodule is lilnited to installation by the grantee into our host systems lvrOdular Approval Checklist:

"Iodular approval requirement

(1)HaVe its own RF shielding.

(2)Have bufFered modulation/data inputs

(3)Have itS OWn power supply regulation.

(4)Comply with the antenna and transmission systcm requiremcnts of 15.203,15.204(b)and 15,204(c).

(5)Tested in a stand alonc confaguration. Unless the ttansmitter module will be battely powered,it must comply with the AC tinc conducted requircments found in FCC s 15.207.AC or DC power lines and data input/output lines connected to thc module must ot contain feiFiteS,untcss they vill be marketed with the module.The length ofthese lines shali bc the length typical ofactual use or,ifthat length is unk own,at lcast 10 centimeters to insure that thcrc is no coupling be veen thc case of the module and suppo ing equipment, Any accessories, pcripherals,Or support equipment connectcd to the module during testing shan bc unlnodifled and conllncrcially available,

(6)Equipped with either a pennancndy afrlxed label or lnust be capable ofelecttonicaHy displaying its F(,C ID. Ifthe FCC ID is not visible when the l odule is instancd inside anothcr device,then the outside ofthe devicc into which thc rnodutc is instaned must also display a labcl reFelring to the enclosed module. No Yes

(7)Comply wih any spcciac rules or operating requiremcnts hat ordinarily apply to a complete ttansmittcr and the manufacturer must providc adequate insttuctions along with the modulc to explain any such requiremcnts,

(8)Comply wih any applicable RF exposure requiremcnts in its flnal conf18uration:The modular lSmitter complies with FCC radiation cxposure requircmcnt. Tomohiro Suzuki Canon lnc

Ca olB CANON INC HEADQUARTERS 302,SHIMOMARUK0 3-CHOME,OHTA KU,TOKY0 146 8501 APAN PHONEI(03)3758 2111 Request for Comndentiality Date:July 21,2021 UL Verincation Services lnc. 47173 Benicia Stteet Fremont,CA 94538 Applicanti Canon lnc FCC ID :AZD322 To whom it may concerni Please be advised that the following infollllation is to be held confldential on behalf of us,refering to the FC(3 rulcs O.457 and O.459:

BIock Diagram Theory ofOperation Schernatics Parts List The applcation contains technical info mlation which we deenl to be ttade sccrcts and propmetary, If made pubLc,the infol ation might be used to the disadvantage ofthe applcantin thc market place. Thank you For your attention to this lnatte Sinccrely, Tomoho Suzuki Canon lnc

Caoll CANON tNC, HEADQUARTERS 30-2,SHIMOMARUK0 3-CHOME,OHTA KU,TOKY0 146-3501 JAPAN PHONE (03)3758 2111 Request for Short Term Conndentiality Datc:July 21,2021 UL Veri cation 8er ceR Inc. 47173 Benicia Strcet,Fremont,CA 94538 FCC ID :AZD322 Applicanti Canon lnc To whom it may concem Piease be advised thatthe following infollilation is to bc held in conidence for 180 days l om thc date of the Grant ofEquipment Authorization and behalf ofus,referring to the FC(3 rulcs O.457 and O.459:

ExtemaI Photos lnternaI Photos Tcst Setup Photos User Manual The applcation contains tcchnical info 11lation,which we dcem to be tradc secrets and proprietary. If made public,the infolmiation might be uscd to the disadvantage ofthe applcantin thc l arket place Thank you l r your attention to this lnatter. Sincerety, Tomohiro Suzuki Canon lnc

Canon CANON INC. HeapaquarTers Tamagawa Office 16-1, Shimonoge 3-chome, Takatsu-ku, Kawasaki-shi, Kanagawa 213-8512, Japan a l@]\ Het Reese hel 7a a Special Power of Attorney I, Yoshihiro Funamizu of Canon Inc. hereby appoint Tomohiro Suzuki of Canon Inc. to represent me to act on my behalf to do any and all of the following:

Sign on my behalf the agency, anti-drug and confidentiality cover letters and apply to FCC for the products. The rights, powers and authority in fact to exercise any and all of the rights and powers herein granted shall commence and be in full force and effective from March 7, 2018 unless specifically terminated by either party. Dated March 7, 2018, Yoshihiro Funamizu Canon Inc. Japan