FCC ID: ON5-OHR30 Optical Heart Rate Sensor

Optical heart rate sensor OHR-30 Parts names Wrist band Button Optical sensor Contact LED indicator 1. Before use: How to charge 2. Pairing 3. Using the optical heart rate sensor Handling and Support Copyright 2020 CATEYE Co,.Ltd. OHR-30 1. Before use: How to charge Be sure to charge it before use, according to the instructions How to charge and Charging precautions. Handling the rechargeable battery Caution!

Charging precautions Avoid charging under direct sunlight or in a vehicle parked under direct sunlight, and make sure to charge only when the ambient temperature is between 5 and 40C. Before charging, be sure that no dust or other foreign objects are attached to the USB plug. When the connected PC is in the sleep state, the battery cannot be charged. Do not subject the device to vibrations while charging. Usage precautions Charging, discharging, and storing in high temperature environments will cause the rechargeable battery to deteriorate faster. Do not place the product inside a vehicle or near a If the operating time is significantly reduced even after proper charging, the rechargeable battery may be reaching the end of its service life. Dispose of the battery according to the heater. disposal precautions. Storage precautions If the device will not be used for a long period of time, store it in a location that is not too hot or too humid. In addition, charge the battery for about 30 minutes every 6 months. Disposal precautions according to local regulations. When disposing of the product, remove the internal rechargeable battery and dispose of it When using this sensor with a CATEYE computer, the heart rate display will flash when the remaining battery power is low. Important Recharge the sensor if the computer's heart rate display starts flashing. 1. Attach the USB charging cable connector to the contact of the heart rate sensor, and charge using a PC or a commercially available USB charger. Be careful that metal objects do not touch the contacts of the charging cable connector. This Caution!

could lead to an electrical short circuit and damage the device.

The indicator turns red and charging starts. The indicator turns blue to indicate that charging is complete. USB charging cable connector Contact LED indicator Standard charging time Approx. 1.5 hours Continuous operating time Approx. 8 10 hours

* When your PC is in sleep state, the unit may not be charged.

* Charging and operating times are approximate values, and will vary by environmental and user conditions. Copyright 2020 CATEYE Co,.Ltd. 1. Before use: How to charge OHR-30 2. Pairing Important This section explains how to pair the smart computer and the sensor using the Cateye Cycling smartphone app. online manual or instruction manual. To pair the sensor directly to the computer without a smartphone, refer to your computers The Cateye Cycling smartphone app (free) must be installed on the smartphone to be used in advance. If using an iPhone If using an Android smartphone

* For the latest information on the smartphones that are compatible with Cateye Cycling operations, see Cateye Cycling Recommended Devices. Pairing via Bluetooth Smartphone Important Perform pairing at a distance of no more than 3 m. 1. Verify that [Connect] is set to ON in the

(MENU), and then tap [Device]. Tap [Pair to Device] to start pairing. 2. Press the heart rate sensor button to transmit the signal. The indicator flashes blue. Press LED indicator When Cateye Cycling detects the sensor signal, a message will be displayed on the Tap [Pair to Device]. The verified sensor (CATEYE OHR-30) is displayed under [Device] and

* When pairing a sensor with the Cateye Cycling app an A is displayed after the sensor smartphone. pairing is completed. name (HR). 3. After pairing is complete, turn off the power of the heart rate sensor. Press and hold the heart rate sensor button, and release your finger when the LED indicator turns red. information. When using the smart computer in Sensor Direct Mode:

Connect the smart computer to Cateye Cycling, and then transmit the paired sensor Important STRADA SMART/PADRONE SMART: Connecting smart computer and smartphone PADRONE SMART+: Connecting smart computer and smartphone When using AVVENTURA/PADRONE SMART+:

Heart rate will not be displayed on the measurement screen in default configuration.

Customize the measurement screen to display heart rate. AVVEBTURA: Changing the measurement screen PADRONE SMART+: Changing the measurement screen When using ANT+ to perform pairing or pairing with a commercial computer Refer to the instruction manual for your computer. Copyright 2020 CATEYE Co,.Ltd. 1. Before use: How to charge OHR-30 2. Pairing 3. Using the optical heart rate sensor Wear the optical heart rate sensor on your arm. Before wearing the heart rate sensor Never use this device if you are using a pacemaker. Warning!!!

Secure the sensor appropriately using the wrist band so that the optical sensor part makes close contact with the skin. consult with a doctor. If an allergic reaction or skin inflammation occurs during use, stop using immediately, and When the outside temperature is low, the heart rate may not be measured correctly. In these situations, use your cycling wear or other object to warm the sensor, and then perform measurement. This sensor cannot be used underwater. 1. Press the heart rate sensor button to turn on the sensor. The indicator flashes blue. Press LED indicator 2. Wear the sensor on your wrist, forearm, or upper arm using the wrist band. Adjust the length of the wrist band, and secure the sensor in place. Overtightening the wrist band may cause discomfort during measurement. Wrist band

* Ensure that the optical sensor part is in close contact with your body.

* If the heart rate cannot be measured correctly, try again by wearing on a different area

(wrist, forearm, upper arm). 3. After measurement is complete, turn off the power of the heart rate sensor. Press and hold the heart rate sensor button, and release your finger when the LED indicator turns red. Copyright 2020 CATEYE Co,.Ltd. Handling and Support Optical heart rate sensor OHR-30 Warning!!! / Caution!

Never use this device if you use a pacemaker. Warning!!!

Caution!

Be careful that metal objects do not touch the contacts of the charging cable connector of the optical sensor. This could lead to an electrical short circuit and damage the device. Handling the rechargeable battery Charging precautions Avoid charging in direct sunlight or in a vehicle parked under direct sunlight, and make sure to charge only when the ambient temperature is between 5 and 40C. Before charging, be sure that no d st or other foreign objects are attached to the USB plug. When the connected PC is in the sleep state, the battery cannot be charged. Do not subject the device to vibrations while charging. Usage precautions Charging, discharging, and storing in high temperatures will cause the rechargeable battery to deteriorate faster. Do not place the product inside a vehicle or near a heater. If the operating time is significantly reduced even after proper charging, the rechargeable battery may be nearing the end of its service life. Dispose of the battery according to the disposal precautions. Storage precautions Disposal precautions according to local regulations. If the device will not be used for a long period of time, store it in a location that is not too hot or too humid. In addition, charge the battery for about 30 minutes every 6 months. When disposing of the product, remove the internal rechargeable battery and dispose of it Specifications Batteries used Lithium-ion polymer battery 50 mAh Continuous operating Approx. 8 10 hours time

* The continuous operating time is approximate and will vary according to environmental and user conditions. Standard charging time Approx. 1.5 hours

* The standard charging time is approximate and will vary according to environmental conditions during charging. Number of 300 standard charges (until rated capacity is reduced to 70%) recharges/discharges Transmission/reception Bluetooth 4.1 / ANT+

Signal range Approx. 30 m (within 3 m when pairing)

(The range will vary depending on weather and surroundings.) Temperature range Charging: 41F 104F (5C 40C), Operating: 32F 104F

(0C 40C) measured correctly.

* When the outside temperature is low, the heart rate may not be Waterproof IPX7

* This device is rated IPX7 based on JIS C0920. Dimensions/weight 1-25/32" x 1-3/8" x 25/64" (45.3 x 34.9 x 9.8 mm) / 0.32 oz (9.2 g) (Not including wrist band)

* Specifications and design are subject to be changed without notice. Maintenance If the sensor unit becomes dirty, clean with a soft cloth moistened with mild detergent, and then wipe with a dry cloth. Never apply paint thinner, benzine or alcohol; damage will result. Product warranty 2-year guarantee Sensor unit (Accessories and battery deterioration excluded) CatEye cycle computers are warranted to be free of defects from materials and workmanship for a period of two years from original purchase. If the product fails to work due to normal use, CatEye will repair or replace the defect at no charge. Service must be performed by CatEye or an authorized retailer. To return the product, pack it carefully and enclose the warranty certificate (proof of purchase) with instruction for repair. Please write or type your name and address clearly on the warranty certificate. Insurance, handling and transportation charges to CatEye shall be borne by person desiring service. For UK and REPUBLIC OF IRELAND consumers, please return to the place of purchase. This does not affect your statutory rights. 2-8-25, Kuwazu, Higashi Sumiyoshi-ku, Osaka 546 - 0041 Japan Attn: CATEYE Customer Service Section Phone: (06)6719-6863 Fax: (06)6719-6033 E-mail: support@cateye.co.jp URL: https://www.cateye.com

[For US Customers]

CATEYE AMERICA, INC. Phone: 303.443.4595 Toll Free: 800.5.CATEYE Fax: 303.473.0006 E-mail: service@cateye.com 2825 Wilderness Place Suite 1200, Boulder CO 80301-5494 USA Federal Communication Commission Interference Statement ThisequipmenthasbeentestedandfoundtocomplywiththelimitsforaClassB digitaldevice,pursuanttoPart15oftheFCCRules.Theselimitsaredesignedto providereasonableprotectionagainstharmfulinterferenceinaresidential installation. Thisequipmentgenerates,usesandcanradiateradiofrequencyenergyand,ifnot installedandusedinaccordancewiththeinstructions,maycauseharmful interferencetoradiocommunications.However,thereisnoguaranteethat interferencewillnotoccurinaparticularinstallation.Ifthisequipmentdoescause harmfulinterferencetoradioortelevisionreception,whichcanbedeterminedby turningtheequipmentoffandon,theuserisencouragedtotrytocorrectthe interferencebyoneofthefollowingmeasures:

.Reorientorrelocatethereceivingantenna. Increasetheseparationbetweentheequipmentandreceiver. Connecttheequipmentintoanoutletonacircuitdifferentfromthattowhichthe receiverisconnected. Consultthedealeroranexperiencedradio/TVtechnicianforhelp. FCCCaution:Toassurecontinuedcompliance,anychangesormodificationsnot expresslyapprovedbythepartyresponsibleforcompliancecouldvoidtheuser's authoritytooperatethisequipment.(Exampleuseonlyshieldedinterfacecables whenconnectingtocomputerorperipheraldevices). FCCRadiationExposureStatement ThisequipmentcomplieswithFCCRFradiationexposurelimitssetforthforan uncontrolledenvironment. Thistransmittermustnotbecolocatedoroperatinginconjunctionwithanyother antennaortransmitter. This device complies with Part 15 of the FCC Rules. Operation is subject to the followingtwoconditions:

(1)Thisdevicemaynotcauseharmfulinterference,and(2)Thisdevicemustaccept any interference that may cause undesired operation. interference received, including IndustryCanadaStatement ThisdevicecomplieswithIndustryCanadalicenceexemptRSSstandard. Operationissubjecttothefollowingtwoconditions:(1)thisdevicemaynotcause interference,and(2)thisdevicemustacceptanyinterference,includinginterference thatmaycauseundesiredoperationofthedevice. LeprsentappareilestconformeauxCNRd'IndustrieCanadaapplicablesaux appareilsradioexemptsdelicence.L'exploitationestautoriseauxdeuxconditions suivantes:(1)l'appareilnedoitpasproduiredebrouillage,et(2)l'utilisateurde l'appareildoitacceptertoutbrouillageradiolectriquesubi,mmesilebrouillageest susceptibled'encompromettrelefonctionnement. ICRadiationExposureStatement:

ThisequipmentcomplieswithICRSS102radiationexposurelimitsetforthforan uncontrolled environment. Cet quipementestconformeauxCNR102d'IndustrieCanada.

CATEYE Co., Ltd. 2-8-25, Kuwazu, Higashi-Sumiyoshi-Ku, Osaka 546-0041 Japan Federal Communications Commission Authorization and Evaluation Division Equipment Authorization Branch 7435 Oakland Mills Road Columbia, MD 21046 Date: 2020-04-27 To whom it may concern:

We, the undersigned, hereby authorize Worldwide Testing Services (Taiwan) Co., Ltd to act on our behalf in all matters relating to applications for equipment authorization FCC ID: ON5-OHR30 including the signing of all documents related to these matters. Any and all acts carried out by Worldwide Testing Services (Taiwan) Co., Ltd on our behalf shall have the same effect as acts of our own. We also hereby certify that no party to this application is subject to a denial of benefits, including FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of 1988, 21 U.S.C. 862. Sincerely, Name: Koichi Tsuyama Title: President Company: CATEYE Co., Ltd.

CATEYE Co., Ltd. 2-8-25, Kuwazu, Higashi-Sumiyoshi-Ku, Osaka 546-0041 Japan Federal Communications Commission Equipment Authorization Branch 7435 Oakland Mills Road Columbia, MD 21046 Date: 2020-04-27 Request for Long-Term Confidentiality Company name: CATEYE Co., Ltd. FCC ID: ON5-OHR30 FCC Part 15 Certification To whom it may concern:

In accordance with 0.457(d) and 0.459 of CFR 47, CATEYE Co., Ltd. hereby requests Long-Term confidentiality of all Block Diagrams, Schematics, Operational Description attachments for the subject application. These documents contain detailed system and equipment description and related information about the product which CATEYE Co., Ltd. considers to be proprietary, confidential and a custom design and otherwise would not release to the general public. Since the design is a basis from which future technological products will evolve, CATEYE Co., Ltd. considers that this information would be of benefit to its competitors and that the disclosure of the information in these documents would give competitors an unfair advantage in the market. Sincerely, ne Name: Koichi Tsuyama Title: President Company: CATEYE Co., Ltd.