| NOTICE: To comply with FCC and or Industry Canada rules, adjustment or modifications of this
|| receiver and/or transmitter are prohibited, except for changing the code setting or replacing the
'| battery. THERE ARE NO OTHER USER SERVICEABLE PARTS. Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: The Passport transmitter works with all Chamberlain Security+ rolling code garage door openers and accessories. NOTE: When using the Passport transmitter with an access system or gated entry, contact property manager for instructions on use. NOTE: If programming a HomeLink transmitter for an access system is required, contact property manager. PRO USING THE LEARN BUTTON Model CPTKx Remote Control OWNER'S MANUAL Children operating or playing with a garage door opener can injure themselves or others. The garage door could close and cause serious injury or death. Do not allow children to operate the wall push buttons or remote controls. A moving garage door could injure or kill someone under it. Activate the opener only when you can see the door clearly, it is free of obstructions, and is properly adjusted. _ USING THE MULTI-FUNCTION DOOR CONTROL 1. Press and release the learn button on the motor unit. The learn indicator light will glow steadily for 30 seconds. 2. Within 30 seconds, press and hold the button on the hand-held remote* that you wish to operate your garage door. 3. Release the button when the motor unit lights blink. It has learned the code. If light bulbs are not installed, two clicks will be heard. To Erase All Codes From Motor Unit Memory To deactivate any unwanted remote, first erase all codes:
Press and the hold learn button on motor unit until the learn indicator light goes out
(approximately 6 seconds). All previous codes are now erased. Reprogram each remote or keyless entry you wish to use. 1. Press and hold the button on the hand-
held remote* that you wish to operate your garage door. 2. While holding the remote button, press and hold the LIGHT button on the Multi-
Function Door Control. 3. Continue holding both buttons while you press the push bar on the Multi-Function Door Control (ail three-buttons are held). 4. Release buttons when the motor unit lights blink. It has learned the code. If light bulbs are not installed, two clicks will be heard. NOTE: Any button can be used with a garage door opener and/or access control system. However, the property manager may have restrictions on which buttons can be used when operating the gate entrance or access system.