[PF 537 7S PRAMS ALT TER ACTIVATE THE OPENER ONLY WHEN DOOR IS. IN FULL VIEW, FREE OF OBSTRUCTION AND PROPERLY ADJUSTED. NC ONE SHOULD ENTER OR LEAVE GARAGE WHILE DOOR IS IN MOTION. DO NOT ALLOW CHILDREN TO OPERATE REMOTES OR WALL PUSH BUTTONS. DO NOT ALLOW CHILDREN TO PLAY NEAR THE DOOR. :
Radio Controls FCC. rules prohibit adjustments to or modification of receiver and transmitter circuitry except for changing the cade set-
ting and replacing the transmitter battery. THERE ARE NO OTHER USER SERVICEABLE PARTS. Manutactured under t or more of the following US. patents: RE2Z9 525; 6(07,20t 4,790,118;
4806930. Other patents pending. Your 53000SR SERIES garage door opener (with RECEIVER SR CODE BUTTON) has been factory set to operate with the LARGE push button on the transmitter. The 3-function transmitter(s) can also activate additional garage door openers and/or light controls. Instructions are given below for matching the code in all transmitters, changing your code selection or using the trans-
mitter(s) with other receivers. , MATCH/CHANGE THE CODE IN TRANSMITTER(S) SET CODE SWITCHES IN ALL TRANSMITTERS TO MATCHING POSITIONS Locate the code switches in transmitter(s), either by sliding battery compartment cover back or by removing cover screw and carefully turning case top over. With a pen or a screwdriver, set code switches in all transmitters to matching (+), (-) or (0) positions. NOTE: Code switches 2 through 9 in ALL transmitters used lo operate a receiver must be set to match. (Code switch 1 on a 3-function transmiller is neutral. Set it to ANY position. It will not affect the code selected). Standard Standard 3-Function 3-Function ~~ 3-Function Mini Transmitter Transmitter Transmitter Code Switches Code Switches Code Switches
{1-9) SET RECEIVER TO MATCH TRANSMITTER(S) CODE 53000SR SERIES GARAGE DOOR OPENERS 53000 SERIES GARAGE DOOR OPENERS
(WITH RECEIVER SR CODE BUTTON) AND LIGHT CONTROLS WITH RECEIVER CODE SWITCHES Push Button (-}
3 FUNCTION A GARAGE DOOR Push Buttoa (+) BO oscunction TRANSMITTER OPENER RECEIVER
(With SR Code Button) TRANSMITTER Select a transmitter push RED WHT 8x EL button to operate receiver Select a transmitter push button to operate receiver Push Button (0) Receiver Code Switches LIGHT CONTROL PROOUCTS
(With Receiver Cade Switches) SR Indicator Code Button = Light Slide receiver code switch a1 to position that matches selected Code Switch #1 {-) transmitter push button Recerver will operate (+, O08 -) with transmitters MAKE SURE ALL TRANSMITTERS USED TO OPERATE large push Suton A GARAGE DOOR OPENER ARE SET TO A MATCHING CODE AS DESCRIBED ABOVE. MAKE SURE ALL TRANSMITTERS USED TO OPERATE YOU MAY WA LIGHT CONTROLS OR GARAGE DOOR OPENERS WITH NT SOMEONE TO HELP AT THIS POINT! CODE SWITCHES ARE SET TO A MATCHING CODE AS 1. Press and HOLD the selected remote control push button. DESCRIBED ABOVE. 2. Then press the receiver Smart button on the back panel 1. Locale the receiver code switches. Figure B shows of the opener (Illustration A). The adjacent indictor light will representative light contro! code switches. FLASH and the door will betgin to MOVE. Release the re- . mote control push button. 2. Set code switch #1 to match transmitter push button you The opener will ast operale when either the door control h want to use with that receiver (+), (0) or ()-
Pus 4 Hold a transmitter (with code switches visible) alongside button or the transmitter push button ts pressed. : se ; . NOTE . the receiver. Beginning with RECEIVER code switch #2,
: If the teansmitter push button is not held down until match the position of each transmitter switch the receiver indicator fight flashes, the receiver will nol learn the code. 23