ID 11 12 15 19 13 17 14 18 16 Smart-Learn Button Opener Dip Switch Opener
- 9 Switch Systems, Yellow, White or Grey Learn Button
- 9 Switch Systems, Yellow, White or Grey Learn Button - Canada
- 8 Switch Systems, Yellow, White or Grey Learn Button
- 7 Switch Systems, Yellow, White or Grey Learn Button BRAND CHAMBERLAIN, SEARS, LIFTMASTER, MASTER MECHANIC, DO IT GENIE (12 Switch Systems) GENIE (9 Switch Systems) LINEAR 10 Switch Systems) LINEAR, MOORE-O-MATIC (8 Switch Systems) STANLEY (10 Switch Systems) Note Any unused switch locations should be left blank TEST THE KEYPAD Examples:
+
0
--
+
--
would be 1 2 3 2 1 2 3 would be 1 2 1 2 1 2 1 2 1 2 1 2 Code sequence Code sequence PROGRAMMING KEYPAD 1. Write your PIN from above on line 5. 2. Write your brand ID from above on line 6. 3. Write your code sequence from above on line 7. 4. Press * and # together until the keypad stops flashing. 5. Enter your PIN ___ ___ ___ ___ using the keypad and press the # key. 6. Enter brand ID ___ ___ using the keypad and press the # key. 7. Enter code sequence _________________________ using the keypad and press the # key. Programming is complete. Proceed to step 3. KLIK2U SELECT PIN NUMBER Choose a 4-digit Personal Identification Number (PIN). Any combination of numbers from 0 to 9 may be used. Write PIN here: ___ ___ ___ ___ ID 2 3 4 5 6 1 7 9 PROGRAMMING KEYPAD 1. Write your PIN from above on line 4 and line 7. 2. Write your brand ID from above on line 5. 3. Press * and # together until the keypad stops flashing 4. Enter your PIN ___ ___ ___ ___ and press the # key. 5. Enter your brand ID ___ and press the # key. 6. Press and release smart-learn button on motor unit (indicator light next to smart-learn button should turn on). 7. Enter your PIN ___ ___ ___ ___ and hold the 0 button on the keypad until the indicator light next to the smart-learn button blinks or the worklight blinks
(Note for Genie units, press the 0 button twice). Programming is complete. Proceed to step 3. BRAND CHAMBERLAIN, SEARS, LIFTMASTER, MASTER MECHANIC, DO IT GENIE, OVERHEAD DOOR (315MHz) GENIE, OVERHEAD DOOR (390MHz) LINEAR STANLEY WAYNE DALTON TEST/USE THE KEYPAD
- Orange/Red Learn Button
- Purple Learn Button
- Green Learn Button To test the KEYPAD wait 15 seconds, enter your PIN and press the 0 button. If the door does not move and/or the keypad does not flash, repeat step #2. Press * and # together until the keypad stops flashing (approximately 5 seconds). This erases previous programming and returns the unit to the unprogrammed factory setting. KEYPAD FAST & SLOW FLASHING The keypad will flash rapidly after a correct PIN has been entered and any number key is pressed. The rapid flashing indicates that the keypad is transmitting your code. The keypad will flash slowly when there is an error in the programming sequence. Once programmed and a valid PIN entered, the keypad remains active for 15 seconds. During this time you may stop, reverse or reactivate the door by pressing any number on the keypad.