This product is a Remote control transmitter, the hardware includes a button switch, a Remote chip (HF1631), a Red LED.
The user manual
TX227-HF can be used with light band controller.
1. Connect the light strip to the controller and power it on
2. Press the first group of ON/OFF buttons of TX227-HF back and forth within 30 seconds after the controller with the lamp is
powered ON
3. If the light strip is controlled, the connection is successful
4. Can realize remote control switch, color selection, mode and other functions
Tx227-HF key function description:
ON: Turn ON the light strip
OFF: Turn OFF the light strip
WHITE_UP: The light strip switched to brightness increase
WHITE_DOWN: The light strip is switched to brightness reduction
CHANGE_COLORS: Indicates the color switch
STROBE_COLORS: Indicates the blinking mode
FLASH_COLORS : Indicates the jump mode
FADE_COLORS: Indicates the breathing mode
Reset:The clear code
FCC STATEMENT :
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
This device may not cause harmful interference, and
(1)
(2)
This device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority
to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
RF warning statement:
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition
without restriction.