Wireless Handset User Manual
1. Performance parameter
Model
Voltage
Current
Keys
Protection class
Main material
RF
4.5VDC(3AAA 1.5V battery)
KDH231B
MAX 50mA
9
IP 42
HIPS-2230
2420Mhz
Key 1: Short press button 1, and the fader will run to a fixed position (Book
mode) to stop; long press button 1, after 3 seconds, the current
position will be memorized (overwrite the previous memory), the
backlight will flash 3 times quickly, and the control box will beep
1
1 time;
After the position is memorized, short press button 3, and the fader
will switch to the current memorized position;
Key 2: Short press button 2, and the push rod will stop running to a fixed
position (TV mode); long press button 2, after 3 seconds, the current
position will be memorized (overwrite the previous memory), the
backlight will flash 3 times quickly, and the control box will beep
1 time;
After memorizing the position, short press button 2 to switch the
fader to the current memorized position;
Key 3: Long press button 3, push rod 1 extends, release it to stop;
Key 4: Long press button 4, push rod 2 extends, release it to stop;
Key 5: Long press button 5, push rod 1 retracts, release it to stop;
Key 6: Short press button 6, the push rod 1 and push rod 2 retract at the same
time; press any key to stop the push rod during the operation of the
push rod;
Key 7: Long press button 7, the push rod 2 retracts, release it to stop;
Key 8: long press button 8 for about 3 seconds, the backlight flashes for 3
seconds and then stays on, the control box will memorize the current
push rod position (overwrite the previous memory); at the same time
the buzzer buzzes once, the backlight is off; short press again Press
the 8 key, the push rod moves to the memory position;
Key 9: Short press button 9 to stop the push rod running to a fixed position
(zero gravity mode); long press button 9 for 3 seconds, the current
position is memorized (overwrite the previous memory), and the
backlight flashes 3 times quickly, the control box bee Beep once;
after the position is memorized, short press button 9 to switch the
fader to the current memorized position.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference
2
operation.
FCC warning:
will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. T
he device can be used in portable exposure condition without restriction.
3