CHAOS-Q1 Digital display CHAOS-Q1 S M L CHAOS-Q1 x9 Two confirming beeps Reset Product specification:
Bluetooth chip: QCC3020 v5.0 Dual ear direct connection, regardless of master-slave, master-slave switching function Support apt-X audio decoding (HD decoding) Receiving distance: within 10m Working frequency: 2.402 GHz ~ 2.480 GHz Transmission power: class2, max4dbm Audio decoding mode: apt-X, AAC, SBC Charging input voltage: DC5 0.25V Battery Specification: 3.7V 50mah (headset) 400mah (charging box) Working voltage: 3.7V (3.3-4.2v) Charging time: 1.2h Sensitivity of microphone: - 38 2dB Low voltage prompt: 3.3V Speaker specification: 16 / 6mm Frequency response range: 20 ~ 20KHz Sensitivity: 99 3dB Continuous call: 4H Continuous music playing: 4H Standby time: 100h QCC 3020 V 5.0 APT-X 10 2.402 GHz~2.480 GHz CLASS 2,MAX 4 dbm APT-XAACSBC DC 50.25 V 3.7 V 50 mAh() 400 mAh() 3.7 V3.3-4.2 V 1.2 H
-382 DB 3.3 V 16/ 6 mm 20~20 KHz 993 DB 4 H 4 H 100 H
, QCC3020 V5.0
,, APT- X 10 APT-X AACSBC DC50.25V 3.7V 50mAh(
400mAh CLASS2MAX4dbm 2.402GHz~2.480GHz 3.3V
-382DB 3.7V3.3-4.2V 1.2H 4H 100H 16/6mm 20~20KHz 993DB 4H FCC Caution This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.