1.Description The iBeacon module is built-in a battery holder and a coin battery, it can work as alone system.We would like to provide the housing development service at low cost to potential customers. 1/4 2.Features
- Built-in iBeacon firmware
- Built-in a coin battery
- Bluetooth low energy technology compatible
- Excellent link budget (up to 97dB)
- Enable long range applications
- Accurate digital RSSI
- Compatible with CE and FCC regulation
- High performance and low power 8051 core MCU
- AES security coprocessor 3.iBeacon parameter default setting
-UUID: EBEFD08370A247C89837E7B5634DF524
-Major and minor identifier: 0x0001, 0x0001
-Pairing password: 0x666666
-Power Value:0xc5
-Broadcast Rate:0x14
-It can be rang(default)
-It will ring 3 times after reset(default) 4.Modify iBeacon parameter PleasedownloadtheeBeaconfromApplestoreandthenrefertothebelowpictures. 2/4 5.Electronic Parameters Item Battery model Operation Voltage Operation Frequency Frequency Error Modulation Standby current Output Power Receiving Sensitivity Transmission distance Antenna Size Test Data CR2016(CR2032) 2.0-3.6V 2402-2480MHz
+/- 20KHz GFSK 12uA 1 dBm1dB
-93dBm 30 meters 50ohm 23.1 x 23.1 x 4mm (23.1 x 23.1 x 5.6mm) Remarks Coin battery, 3.0Vdc, 1pc DC Programmable Null Null Null Programmable High gain mode BER<0.1%, Open space Onboard Null 3/4 6.Operation state and power consumption State Operation Current (mA) State 1: wake-up State 2: pre-processing State 3: pre-receiving State 4: receiving State 5: Rx changed to TX State 6: transmitting State 7: pre-processing FCC Statement 6 7.4 11 17.5 7.4 17.5 7.4 This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interfere nce in a residential installation. This equipment generates and can radiate radio frequency energy and, if no t installed and used in accordance with the instructions, may cause harmful interference to radio communic ations. However, there is no guarantee that interference will not occur in a particular installation. If this equi pment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the fol lowing measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions: (1)Thi s device may not cause harmful interference, and (2)This device must accept any interference received, in cluding interference that may cause undesired operation. Note: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modific ations to this equipment. such modifications could void the users authority to operate this equipment. FCCRFRadiationExposureStatement The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. 4/4