WIC911 无线充电器说明书
WIC911 Wireless Chargers Product Instruction Manual
01/ 产品参数
型号:WIC911
输入:12V-24V/3A(MAX)
无线充输出:15W
频率:110KHz~205KHz
环境温度:-5℃－40℃
01 / Product Parameters
Model: WIC911
Input: 12-24V/3A(MAX)
Wireless Output: 15W
Frequency: 110KHz~205KHz
Ambient temperature: -5℃－40℃
02/ 使用方法
1. 将五匹车载无线充电器 WIC911 安装在五匹摩托车支架上，并将子弹头端子专用插头插入
五匹摩托车专用子弹头插头接口上。
2. 将支持无线充电的移动设备的无线接收位置对应放置在无线充电器发射区域上，按下五
匹车载无线充电器按扭开关， 蓝绿灯交替闪烁三次后，绿灯或蓝灯长亮，开始充电(移动
设备的无线接收位置一般处于设备正中央)。
3. 充电完成或需要停止充电时，需再次按下车载无线充电器控制开关，指示灯熄灭。
备注：此车载无线充电器不限于只在摩托车上使用。
02 / Operation Method
1. Install the five vehicle-mounted wireless chargers WIC911 on the brackets of the five
motorcycles, and insert the special plug for bullet terminals into the special connector for
bullet terminals of the five motorcycles.
2. Place the wireless receiving position of the mobile device supporting wireless charging
on the transmitting area of the wireless charger, press the button switch of the five
vehicle-mounted wireless charger, and after the blue and green light alternately flashes
for three times, the green or blue light will be long and the charging will begin (the wireless
receiving position of the mobile device is generally located in the center of the device).
3. When charging is completed or charging needs to be stopped, press the on-board
wireless charger control switch again, and the indicator light will go off.
Remark: This car wireless charger is not limited to motorcycle use only.
03/ LED 灯状态说明
蓝灯绿灯交替闪烁三次后熄灭（间隔 1 秒）
正常待机
快充充电
慢充状态
充电异常
故障
绿灯长亮
蓝灯长亮
蓝灯闪烁
蓝灯闪烁
Blue light and green light
flash alternately three times
Green light for a long
Blue light for a long
Blue lights flashing
03/ Indicator LED
Stand-by
Working--Fast
charging
Working--Slow
charging
Metal foreign objects
detected
or Insufficient input
powerout
or deviation from the
right position
04/ 注意事项
1. 请将移动设备放置在无线充电器的中心位置，如偏离将会导致充电效率下降或断充。
2. 手机壳的厚度小于 4mm，且移动设备与无线充电器接触的充电区域内不得有金属异物。否
则会导致充电效率下降、断充或带来安全隐患。
3. 建议充电环境温度低于 28℃，高于此温度会导致充电效率下降。
04/ Notes:
1. Please make sure the phone is placed on the center of the wireless charger.
Deviation from the center will decrease the charging efficiency or interrupt the
charging.
2. It should be less than 4mm for the thickness of the phone case, and there should
be no foreign metal objects in the charging area between the phone and wireless
charger. Otherwise, the charging efficiency will be decreased, or the charging could
be interrupted, even it could lead to latent danger.
3. It is highly recommended that the ambient temperature should be below 28 degrees
Celsius (82.4 degrees Fahrenheit) during the charging period. it could decrease
charging efficiency or lead to interruption for the higher ambient temperature.
05/ 安全提示
1. 请确保设备与无线充电器之间没有金属异物，否则会存在安全隐患。
2. 请勿将磁条卡(比如信用卡、电话卡、银行存等)或某些医疗设备(比如起博器或助 听器
等)与本品放在一起，可能会引起磁条损坏或设备运转不正常。
3. 请勿施加重压，并放置在儿童或动物不能接触到的地方。
4. 请勿自行拆卸、改装和修理无线充电器，否则将无法进行正常的售后。
05/ Safety tips
1. Do not put foreign metal objects in the charging area between the phone and
wireless charger, which will lead to latent danger.
2. Do not put magnetic stripe cards (such as credit cards, telephone cards, bank
cards, etc.) or some medical equipment (such as pacemakers or hearing aids) together
with this product, which may cause damage to the magnetic stripe or abnormal
operation of the equipment.
3. Do not apply heavy pressure and place it out of reach of children or animals.
4. Do not disassemble, refit and repair the wireless charger by oneself, otherwise
it will not be able to carry out normal after-sale service.
06/
有害物质测
测试结果
07/
本品
系品
本品
1. 因
2. 因
3. 超
07/
The
fact
unde
The
1.Da
2.Fa
3.Wa
十二个月。非人
保修说明
品保修期为十
品牌方售后。
用于:
品保修不适用
造成的损坏。
因不可抗力造
导致本品故障
因人为原因导
。
超过保修期。
障或损坏。
Warranty
warranty of
tors, pleas
er warrant
warranty d
amage cause
ailure or d
arranty exp
f this produ
e contact th
ty.
does not ap
ed by force
damage of t
pired.
人为因素引起
起的故障或损
损坏，可在保
保修期内可通
通过购买渠道
或联
uct is twelv
he purchasi
ve months. F
ng channel
Failure or
or Brand si
damage not
de for after
caused by h
r-sales ser
human
rvice
following
:
pply to the
e majeure.
the product
caused by
human fact
tors.
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be
installed and operated with minimum distance between 20cm the radiator your body: Use
only the supplied antenna.