RF915OPERATOR'SMANUAL 1. Description RF915isalowcost915MHztransceiverdesignedforverylowpowerwirelessapplications. 2. Application Wirelessdatacommunication Remotesensors Wirelessalarmandsecuritysystems 3. PinDefinition I P N 1 I P N 2 I P N 3 I P N 4 I P N 5 I P N 6 I P N 7 I P N 8 PinNo. 1 2 3 4 5 6 7 8 PinType DigitalI/O DigitalI/O DigitalI/O DigitalI/O DigitalI/O DigitalI/O DigitalI/O DigitalI/O FunctionDescription GPIO/CSN GPIO/GDO0 GND GPIO/GDO2 GPIO/SO GPIO/SCLK GPIO/SI GPIO/VDD Federal Communication Commission Interference Statement the in accordance with instructions, may cause harmful This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
. Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. interference FCC Caution: To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. (Example - use only shielded interface cables when connecting to computer or peripheral devices). End Product Labeling This transmitter module is authorized only for use in devices The final end product must be labeled in visible area with the following: Contains FCC ID: VEARF915A"
End Product Manual Information The user manual for end users must include the following information in a prominent location This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions
(1) This device may not cause harmful interference and
(2) This device must accept any interference received, including interference that may cause undesired operation. IMPORTANT NOTE: In the event that these conditions can not be met (for example certain laptop configurations or colocation with another transmitter), then the FCC authorization is no longer considered valid and the FCC ID can not be used on the final product. In these circumstances, the OEM integrator will be responsible for reevaluating the end product (including the transmitter) and obtaining a separate FCC authorization. As long as a condition above is met, further transmitter test will not be required. However, the OEM integrator is still responsible for testing their end product compliance emissions, PC peripheral requirements, etc.). this module installed (for example, digital device required with requirements additional for any THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:
(1) THIS DEVICEMAY NOT CAUSE HARMFUL INTERFERENCE AND
(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCERECEIVED, INCLUDING INTERFERENCE THAT MAYCAUSE UNDESIRED OPERATION.