MAGNASPHERE MSS -RFS-### SERIES WIRELESS SECURITY SENSOR INSTALLATION INSTRUCTIONS:
Required Tools and Components Provided by Manufacturer (per set) 1 MSS-RFS switch module 4 Mounting Screws 1 MSS-RFS magnet module 1 Battery (3VDC 1.55Ah CR123A Lithium) Provided by installer Hand Tools Auxiliary Contact (optional) Magnet Spacers *(optional, as needed) CONTACT STATE SHOWN wit m\ AUX CLOSED LOOP
@ REDUCED GAP Magnasphere's MSS-
RFS uses amore secure, restricted sense zone. Orientation and
~Yy alignment is critical for
| Proper operation. Secure sensing zone begins at this mark in the base Spacers needed only to
=o SF align for optimal gap. This
... Yare-earth magnet may be BOTTOM VIE used directly on steel doors. 4 DOOR STOP MOUNT
(EGRESS DOOR) 3 Tamper Switch S| oe mm 5 = i ao 3mm \RFS-1588 RFS-1589) |i G | i. Lo ERO
| S Patents #5530428, #6603378, RE379731 & Patents Pending 02-2014 MSS-RFS-INST REV1 FCC Standard: FCC Part 15 MAGNASPHERE N14 W23777 Stone Ridge Dr MAGNASPHERE fy Suite 160 Waukesha, Wi 53188 tel 262.347.0711 fax 262.347.0710 Wwww.magnasphere. com FCC:
FCC label statement:
This device complies with part 15 of the FCC Rules. Operation is subject to ihe following two conditions: (1) This device may not cause harmful intederence, and (2} this device mist accept any interference received, including interference that may cause undesired operation. Note: This equipment has been lested and faund to comply with the limits for a Class 8 digital device, pursuant 10 part 13 of the FCC Rules, These limits are designed fo provide reasonable protection against hanniul interference ia a residential installation. This equipment generates, uses and can radiate radio frequency energy and, # nol inslated and used in accordance with the instructions, may cause hanntul interference to radio communications. However, ihere is no guarantee ihat interference will oct oceur ina particular installation. if this equipment does cause harmful interference to radio or television reception, which can be determined by tuming the equipment off and on, ihe user is encouraged to ry to correct the interference by ane armor of the fallowing aleasures:
ow Reonent or relocate the receiving antenna. Increase the separation bebveen the equipment and receiver. Connect! the equipment inte an outlet on a cheuil different from that te weliich {ie receiver is connected,
(Consult ihe dealer or an experianced radio/TV technician for help. Changes or madifications not expressly approved by the pany responsible lor compliance could void the users authority to operate the equipment, RE Exposure Guidance: This equipment complies with Industry Canada and FCC radiation exposure lianis set forth for an uncentrolied anvironinent, This iransmitter musi not be co-located or operating in conjunction wilh any other antenna or ransmitler, oxeept in accordance wilh FCC multitransmitter product procedures. iC. LC. label Statement:
This device complies vith ladusty Canada licence-exempt RSS standari{s). Operation is subject ta the following hvo conditions: (7) his device may not cause interference, and {2} this device must accept any interference, including interference that may cause undesired ogeration of the device. Le prsent appareil est confoane aux CNR d'industrie Canada applicables aux apparails radio exempts da licence. Lexploltation est autorise aux deux condilfons suivantes < (1) Yapparel ne dail pas produire de broullage, et (2) lutitisateur de Pappareit doit accepter tout brauilage radiodslectrique sabi, mare sie brouillage est susceptible den cqmprometire ie lonctionnement, Under industry Canada regulations, this radio transmitter may only operate using an antenna of a ype and maxinum
(or fesser) gain approved for the transmitter by industry Canada, To reduce potential radia Interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e119. 18 not more than thal necessary for successful communication. Conioumdment 4 la raglementation d'indusire Canada, fe prsent metteur radio peut fonctionner avec une antenae wun type ef d'an gain maximal (od infdeur) approuv pour femotteur par Industrie Canada, Dans le but de tduire les tisques de brouillage radioglectique a intention des autres utilisateurs. it faul choisir te yee Wantenne ef sea gain de sate que la puissance isoirope rayonne quivatente (p.i..e.) ne dpasse pas fintensit ncessaire Hlablissement d'une communication satisfaisane,