FRONT
OPEN: 14,4 cm x 15 cm
CLOSED: 3,6 cm x 15 cm
Tripod
Selfie Stick
with Light
ITEM 53804-DI
DESCRIPTION
1
2
3
4
1- Built-in Rechargeable Light
2- 270º Rotating Phone Clamp
3- Detachable Remote
4- Handle Converts to Tripod
PAIRING THE WIRELESS SHUTTER
TO YOUR PHONE
1. Pull to remove the clear plastic tab
from the wireless remote to activate
the internal battery.
2. Hold down and press the remote
button to power on and the LED
indicator will flash blue.
3. Search and pair with BT name
"Selfie Stick" on your cellphone. LED
indicator will stop flashing after it is
successfully connected.
Use the remote control to take
pictures from your phone when you
are using the tripod.
4. The remote control will
automatically shut down in 5
minutes if not paired to conserve
battery.
5. The remote control will go into
sleep mode in 10 minutes if not
being used.
6. Hold down and press the remote
button to power off and the LED
indicator will flashes 3 times.
USING THE BUILT IN
RECHARGEABLE LIGHT
1. Connect the included Micro USB
cable for 1 hour to charge the
internal battery on the light.
2. To tun the light ON or OFF hold
down the power button on the side
of the light for approx 3 seconds.
The Bluetooth® word mark and
logos are registered trademarks
owned by the Bluetooth SIG, Inc.
and any use of such marks by CJ
Global is use under license.
Other Trademarks and trade
names are those of their
respective owners.
FCC Caution:
This device complies with part 15
of the FCC Rules. Operation is
subject to the following two
conditions:
(1) This device may not cause
harmful interference, and (2) this
device must accept any
interference received, including
interference that may cause
undesired operation.
Any Changes or modifications
not expressly approved by the
party responsible for compliance
could void the user's authority to
operate the equipment.
Note: This equipment has been
tested and found to comply with
the limits for a Class B digital
device, pursuant to part 15 of the
FCC Rules. These limits are
designed to provide reasonable
protection against harmful
interference in a residential
installation. This equipment
generates uses and can radiate
radio frequency energy and, if not
installed and used in accordance
with the instructions, may cause
harmful interference to radio
communications. However, there
is no guarantee that interference
will not occur in a particular
installation. If this equipment
does cause harmful interference
to radio or television reception,
which can be determined by
turning the equipment off and on,
the user is encouraged to try to
correct the interference by one or
more of the following measures:
-Reorient or relocate the receiving
antenna.
-Increase the separation between
the equipment and receiver.
-Connect the equipment into an
outlet on a circuit different from
that to which the receiver is
connected.
-Consult the dealer or an
experienced radio/TV technician
for help.
The device has been evaluated to
meet general RF exposure
requirement. The device can be
used in portable exposure
condition without restriction.