CLOSED: 50x120 cm WITH CHARGING CASE ITEM: HWE-30 25353 TWS EARBUDS with Charging Case USER MANUAL QUICK CONNECTION GUIDE Take out the left and right earphones from the charging compartment, the earphones will automatically turn on after a couple seconds. The main earphone (B) will enter the pairing mode (ashing red and blue light). Both earbuds will sync with each other automatically. Enter Bluetooth mode on your mobile device, search for "HEAD TWS Earbuds", and select. There will be a prompt stating,
"Connected". This means both earphones are connected and synced up to your mobile device. SAFETY INSTRUCTIONS Please read these instructions carefully before operating this device. POWER SOURCE Only use the power supply that came with the product. Using an unauthorized power supply will invalidate your guarantee and may irrecoverably damage the product. MOISTURE AND WATER Do not leave it in low temperatures as moisture can form inside the product, which may damage the circuit board. Keep away from heat sources and ames Do not leave it in high temperatures as electronic devices and plastic parts may warp in heat. CAUTION To avoid possible hearing damage, do not listen to music at high volume levels for long period of time. Always keep the volume within reasonable limits. GENERAL SAFETY INFORMATION Keep the product and all its parts out of reach of small children. This product is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety. SPECIFICATIONS Bluetooth 5.0 Ultra-low Charging Case: 9 hours of additional playback/talk power consumption Earphone charge time: 1 hour connection Distance: 10m 15m Charging case charge time: 1 hour Playback time: 3 hours Earphone battery capacity: 25mAh Talk time: 3 hours Charging case battery capacity: 300mAh Standby time: 300 hours BLUETOOTH FUNCTIONALITY 1. POWER ON: Take out the charging case or Press and hold the touch button for 5 seconds when turned off. 2. POWER OFF: Put it in the charging case , or Press and hold the touch button for 5 seconds when the power on isON". 3. Bluetooth pairing (pairing with mobile phone): Take out the charging case for the left and right earphones, the earphones will automatically turn on, connect left and right, and connect back to the last connected Bluetooth device, and automatically enter the state of pairing with the mobile phone without returning. Long press the touch button for about 5 seconds to manually enter the pairing state when turned off. 4. Connect with your mobile phone: The headset enters the pairing state, the mobile phone searches for the Bluetooth pairing name "HEAD TWS Earbuds", and clicks Connect 5. Play/Pause: While music is playing, click the touch key to pause and click play again. 6. Next song/volume decrease & Previous song/volume plus: Play music status, double-click L for the next song/long press 2 seconds volume down. Play music status, double-click R for the previous song/long press 2 seconds volume plus. 7. Last number redial: Triple tap left and right ears to call back last number. 8. Low power: A low battery prompt voice every 2 minutes 9. Hang up the call: Click the touch key during the call. 10. Reject incoming call: Press and hold for 2 seconds to automatically reject incoming call. 11. Hang up the current call and answer the second call: when there is another call, click the touch button to end the current call and answer the second call. 12. Reject the second call: when there is another call or the phone is on hold, press and hold the touch button for 1.5S to reject the second call. 13. Answer the second call and hold the current call: when there is another call, double-click to hold the current call and answer the second call 14. Switch between two phones during a three-way call: When a three-way call is in progress, double-click the touch key to switch between the two calls. 15. Voice Assistant: Four blows to the left and right ears wake up the voice assistant. CHARGING CASE There are two functions of the charging case: charging and storing the earphones. 1. Charging: When the earphones batteries are low, place them into the charging case to begin charging. The red light on the main button of each earphone will be solid red. When the earphones are fully charged, the red lights on the earphones will shut off. 2. Storage: When the earphones are not in use, place them inside the charging case. They will automatically disconnect from your device and begin to charge. When taking them out of the case, they will automatically reconnect to your device. FCC STATEMENT This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorientor relocatethe receiving antenna. Increasetheseparation betweentheequipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Note: Any changes or modications not expressly approved by the party responsible for compliance. such modications could void the user's authority to operate the equipment. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. HEAD is a registered trademark of HEAD Technology GmbH and HEAD Sport GmbH and is used under license by CJ GLOBAL Inc. The Bluetooth word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc. and any use of such marks by CJ Global is under license. Other trademarks and trade names are those of their respective owners. CJ Global Inc. All rights reserved. 2010 Maple Ave Fair Lawn NJ 07410. IC STATEMENT This device complies with Industry Canadas license-exempt RSSs. Operation is subject to the following two conditions:
1) This device may not cause interference; and 2) This device must accept any interference, including interference that may cause undesired operation of the device. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
- French:
Cet appareil contient des metteurs / rcepteurs exempt s de licence conformes aux RSS (RSS) d'Innovation, S ciences et Dveloppement conomique Canada. Le fonc tionnement est soumis aux deux conditions suivantes:
Cet appareil ne doit pas causer d'interfrences. Cet appareil doit accepter toutes les interfrences, y com pris celles susceptibles de provoquer un fonctionnement indsirable de l'appareil The digital apparatus complies with Canadian CAN ICES-3 (B)/NMB-3(B). l'appareil numrique du ciem conforme canadien peut - 3 (b) / nmb - 3 (b). The device has been evaluated to meet general RF exposure requirement. This equipment should be installed and operated with minimum distance 0mm between the radiator & your body. L'appareil a t valu pour rpondre aux exigences gnrales d'exposition aux RF. Cet quipement doit tre install et utilis avec une distance minimale de 0 mm entre le radiateur et votre corps. Made in China