FCC Statement
This device complies with part 15 and part 18 of the FCC
Rules. Operation is Subject To the following two
conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications not explicitly approved by the
party responsible for compliance could void the user's
authority to operate this equipment.
Note: this equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part
15 and part 18 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and candidate radio frequency energy and,
if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or
television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
· Reorient or relocate the receiving antenna.
· Increase the separation between the equipment and
receiver.
· Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
· Consult the dealer or an experienced radio/TV technician
for help.
The equipment complies with FCC radiation exposure limits
set forth for an uncontrolled environment. During the
operation of device a distance of 15 cm surrounding the device
and 20 cm above the top surface of the device must be
respected.
This device complies with Part 18 of the FCC Rules. This
equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
● Increase the separation between the equipment and any
other radio device.
● Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Alarm clock hour setting
press key ,the number is
(cid:31)
pulsating
press up and down key
to your desire hour
(cid:31)
After setting the hour you want ,press key again for 1 time to minute setting.or long press
key for 2 minutes is exit the setting
(cid:31)
3.Alarm Hour Setting
4.Alarm Minute Setting
5.Year Setting
6.Month Setting
7.Day Setting
How to set 12 hour or 24 hour display
Press key to switch between 12 and 24 hour mode
After setting the minute you want .press ,
key for 2 minutes exit the setting
(cid:31)
Alarm setting (open and close)
long press two minutes key to switch
The following is the function setting sequence,
the setting steps refer to the above picture
the default is celsius.
Fahrenheit and celsius setting
In standby mode press the key to change the temperature,
Minute setting
After setting the hour you want,press
key again for 1 time to minute
(cid:31)
setting
Press
to your desire minute
key
1.Hour Setting
2.Minute Setting