FCC ID: 2AJABNS21-6QRY HOME CCTV CAMERA

Smart Homeye l Mobile App Quick Guide P/N: 3810-0415A User Information This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference. and

(2) This device must accept any interference received, including interference that may cause undesired operation. Any changes or modications (including the antenna) made to this device that are not expressly approved by the manufacturer may void the users authority to operate the equipment. To comply with FCC RF exposure compliance requirements, a separation distance of at least 20 cm must be maintained between the antenna of this device and all persons. This device must not be co-located or operation in conjunction with any other antenna or transmitter. Smart Homeye l Mobile App Quick Guide

-

App Installation Power Connection 1. 1.1. Plug the adaptor to 5V DC power input jack. 1.2. Power LED will turn ON when power is connected correctly. Connect Wi-Fi to AP (using WPS button) 2. 2.1. Press WPS button on the Access Point. 2.2. Press and hold WPS button on the camera for more than 3 seconds. A light on WPS button will change from blinking to solid when connection is established. 2.3. Wi-Fi LED will turn ON when Wi-Fi is connected to the Access Point. 2.4. If the Access Point does not support the WPS function, set the Access Point information using Smart Homeye app. Install Smart Homeye App 3. 3.1. Scan the QR code below on your Android / iOS device to install Smart Homeye app. 3.1. 3.2. Search for the App using Keyword Smart Homeye, Homeye on app store and install it. Product registration to Smart Homeye App 4. 4.1. Connect your mobile device to the Access Point via Wi-Fi before connecting to the camera. 4.2. Open Smart Homeye app. Smart Homeye l Mobile App Quick Guide 1 App Installation 4.3. When the camera is not registered, Add Device message will pop-up. Press OK button to add the camera. The camera can also be added by touching on + button at the upper-right corner. 4.4. Add New Camera. When adding a new camera, touch Next button in Add Camera window. Use Add existing camera Menu to simply select a pre-registered camera using UID & QR Code. (You can share the camera using UID and QR Code.) Android Device iOS Device 3 55 2 Smart Homeye l Mobile App Quick Guide App Installation on Android Devices 4.5. Search for the Homeye. If several Homeye products are detected, make sure to select the right one by checking the Mac Address printed on the bottom of camera. 4.6. Once Homeye is accessed, the available Wi-Fi will be listed. Select the desired Wi-Fi from the list and input the SSID password to connect. Once the registration is done after conguration, the status LED will change from blinking to solid. If the status LED is still blinking, the registration is not successful. Please repeat the registration procedure. Smart Homeye l Mobile App Quick Guide 3 App Installation on Android Devices 4.7. You can view the video by selecting the registered Homeye from the Device list. Online_P2P: Camera is connected using P2P Mode. Online_Relay: Camera is connected using Relay Mode. Offline: Camera is disconnected.

(The Offline maybe due to network or server status, and the status check will repeat every 15 sec.)

!

Caution 1. Please use the DC 5V Power Adaptor included in the package. 2. Dont force to reposition the cameras pan and tilt angle manually as it might damage the camera. 3. Dont drop the camera or apply impact. 4. Micro SD Card is a consumable product, and a long-term use may cause data loss or recording error. Periodic management such as regular format schedule is required. 5. When power is on, please use the Micro SD Card Safe Removal Button to remove the SD Card. 6. There can be a slight shaking during the panning and tilting operation of camera. Smart Homeye l Mobile App Quick Guide 4 App Installation on iOS Devices 4.5. For iOS Devices security, access the Homeye rst using the iOS Wi-Fi Conguration Menu and return to Smart Homeye App. Select the right Homeye from searched Wi-Fi list using iOS Wi-Fi Conguration Menu. If several Homeye products are detected, make sure to select the right one by checking the Mac Address printed on the bottom of camera. 4.6. The default password for Homeye is 12345678. Access Homeye by inputting the Password, and run the Smart Homeye App. Smart Homeye l Mobile App Quick Guide 5 5 App Installation on iOS Devices 4.7. On Smart Homeye App, the available Wi-Fi will be listed. Select the desired Wi-Fi from the list and input the SSID password to connect. Once the registration is done after conguration, the status LED will change from blinking to solid. If the status LED is still blinking, the registration is not successful. Please repeat the registration procedure. Smart Homeye l Mobile App Quick Guide 6 6 App Installation on iOS Devices 4.8. You can view the video by selecting the registered Homeye from the Device list. Online_P2P: Camera is connected using P2P Mode. Online_Relay: Camera is connected using Relay Mode. Offline: Camera is disconnected.

(The Offline maybe due to network or server status, and the status check will repeat every 15 sec.)

!

Caution 1. Please use the DC 5V Power Adaptor included in the package. 2. Dont force to reposition the cameras pan and tilt angle manually as it might damage the camera. 3. Dont drop the camera or apply impact. 4. Micro SD Card is a consumable product, and a long-term use may cause data loss or recording error. Periodic management such as regular format schedule is required. 5. When power is on, please use the Micro SD Card Safe Removal Button to remove the SD Card. 6. There can be a slight shaking during the panning and tilting operation of camera. Smart Homeye l Mobile App Quick Guide 7 7 Specications Camera Video Audio MODEL Image Sensor Full Resolution Sync System S/N Ratio Lens Day & Night Sensitivity

(F1.2, 30 IRE , ICR B/W) White Balance Exposure 3D-DNR Motion Detection Digital Zoom Compression Method Multi-Prole Streaming Intelligent Bit-Rate Control Image Setting Mono Upstream Mono Downstream Network Protocol Network Security Streaming Method Wireless LAN Power Factory Reset Audio Intelligent Video Alarm Events Alarm Buffer (Audio/Video) Smart App. Operating Temperature / Humidity Power Adapter Dimension / Weight Micro SD card External Terminals Alarm & Event Client Software Operating Environment

/ Humidity, Power, Dimensions Local storage Homeye Mini Progressive scan 1/2.9 inch CMOS 2M pixels 1,920 x 1,080pixels (FHD) Internal 62dB or more 2.8mm, F1.8 AUTO(Mechanical ICR)

- Color : 0.12 Lux

- BW : 0 Lux With IR ON AWB (2.000K ~ 10,000K) ESC Supported ON / OFF (1 Programmable Zone) Supported H.265 / H.264 / MJPEG

- 3 simultaneous video proles

- Select the codec type, resolution and frame rates for each prole Hybrid Bit Rate control (VBR+CBR) Text overlay, Privacy mask, De-interlace lter 32Kbps G.726 ADPCM, 64Kbps 16bit -law PCM ~ Microphone 64Kbps 16bit -law PCM ~ Speaker IPv4/v6, TCP, UDP, IGMP, ICMP, ICMPv6, ARP, RARP, PPPoE, RTCP, RTP, RTSP, SDP, HTTP, HTTPS, SMTP, FTP, DHCP, UPnP, NTP, DNS, DynDNS

- User ID & Password protection, IP address ltering

- Digest Authentication, User Access Log

- RTSP streaming with proprietary format for control information.

- Standard RTSP streaming - HTTP streaming IEEE 802.11b/g/n(HT20/40) DC 5V, Max 1.0A Camera Reset Microphone, Speaker Motion Detection PUSH Notication congurable Pre-alarm (5 sec) & Post-alarm (10 ~ 60 sec) Android, iOS 10C ~ 50C / 8 ~ 80% RH DC 5V, 1.5A 62mm x 120mm x 50mm / Approx. 200g Max 64G (32G Micro SD card) Smart Homeye l Mobile App Quick Guide 8

Internal photos Antenna FCC ID: 2AJABNS21-6QRY Page 1 of 3 Internal photos FCC ID: 2AJABNS21-6QRY Page 2 of 3 Internal photos Blank FCC ID: 2AJABNS21-6QRY Page 3 of 3

External photos FCC ID: 2AJABNS21-6QRY Page 1 of 1

Label photo FCC ID: 2AJABNS21-6QRY Model: NS21-6QRY Because the device is so small that it is not practicable to place the statement specified under 15.19 statement request, the information required by this paragraph shall be placed in a prominent location in the Users Manual. FCC ID: 2AJABNS21-6QRY Page 1 of 1

CNB Technology Inc 613-614, 99, Digital-ro 9-gil, Geumcheon-gu, Seoul, South Korea Date: September. 06, 2016 Federal Communications Commission 7435 Oakland Mills Road Columbia MD 21046 To whom it may concern:

I, the undersigned, hereby authorize Jeff Do of KES Co., Ltd. and hereafter referred to as KES Co., Ltd., to act on our behalf in all manners relating to application for equipment authorization, including signing of all documents relating to these matters. Any and all acts carried out by Jeff Do of KES Co., Ltd. on our behalf shall have the same effect as acts of our own. I, the undersigned, hereby certify that we are not subject to a denial of federal benefits, that includes FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of 1988, 21 U.S.C. 853(a). In authorizing KES Co., Ltd. as our agent, we still recognize that we are responsible to:

a) b) c) d) e) f)

(e.g. testing, inspection, assessment, comply with the relevant provisions of the certification program;

make all necessary arrangements for the conduct of the evaluation, including provision for examining documentation and access to all areas, records (including internal audit reports) and personnel for the purposes of evaluation surveillance, reassessment) and resolution of complaints;

make claims regarding certification only in respect of the scope for which certification has been granted;

do not use our product certification in such a manner as to bring the Certification Division into disrepute and not make any statement regarding our product certification which the Certification Division may consider misleading or unauthorized;

upon suspension or cancellation of certification, discontinue use of all advertising matter that contains any reference thereto and return any certification documents as required by the Certification Division;

use certification only to indicate the products are certified as being in conformity with specified standards;

g) h) i) j) CNB Technology Inc 613-614, 99, Digital-ro 9-gil, Geumcheon-gu, Seoul, South Korea endeavor to ensure that no certificate or report nor any part thereof is used in a misleading manner;

ensure that any reference to our product certification in communication media such as documents, brochures or advertising, complies with the requirements of the Certification Division;

keep a record of all complaints made known to the us relating to the products compliance with requirements of the relevant standard and to make these records available to the Certification Division when requested;

take appropriate action with respect to such complaints and any deficiencies found in products or services that affect compliance with the requirements for certification;

k) document the actions taken. This authorization is valid until further written notice from the applicant. Sincerely Yours, SAE YOUNG HONG / President REMARK:

1. This authorization letter will be sent along with your application when filing with the Certification Division. 2. Please follow the format and type it on company letterhead and send original to us. 3. Authorized signature must be in agreement with grantee code contact in FCC database

.

CNB Technology Inc 613-614, 99, Digital-ro 9-gil, Geumcheon-gu, Seoul, South Korea Date: September. 06, 2016 Federal Communications Commission Authorization and Evaluation Division Confidentiality Request regarding application for certification of FCC ID: 2AJABNS21-6QRY Pursuant to Sections 0.457 and 0.459 of the Commissions Rules, we hereby request confidential treatment of information accompanying this application as outlined below:

PERMANENT Exhibit Type Part List Schematics Diagram(s) Block diagram File Name Part List_NS21-6QRY.pdf Schematics_NS21-6QRY.pdf Block diagram_NS21-6QRY.pdf Operation description Operation description_NS21-6QRY.pdf And the above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these materials may be harmful to the applicant and provide unjustified benefits to its competitors. The applicant understands that pursuant to Section 0.457 of the Rules, disclosure of this application and all accompanying documentation will not be made before the date of the Grant for this application. Sincerely, SAE YOUNG HONG / President

CNB Technology Inc 613-614, 99, Digital-ro 9-gil, Geumcheon-gu, Seoul, South Korea Federal Communications Commission Authorization and Evaluation Division 1435 Oakland Mills Road Columbia, MD 21046 Date: August 17, 2016 Regarding FCC Application (FCC ID: 2AJABNS21-6QRY) We, CNB Technology Inc, declare that the device does not support channel 12 ~ 13 in 2.4 GHz band. The firmware setting is not accessible by end users and/or unauthorized 3rd parties. Sincerely, SAE YOUNG HONG

/President