Cogent systems RF-READER USER MANUAL RF-READER RFREADER USER MANUAL DesfireMifareDemo(CLR2007.exe) Preparations: RF-READER, contact less card(DesfireMifare), driver, Demo(CLR2007.exe)
Driver installation:
N Connect the RF-READER to PC. While the message box suggesting you to install the driver, choose N, temporarily and then choose next as picture below:
DRIVERINSTALL_1 N Choose the item select from list or specified path (senior).Then press next (N). See the picture.
- 1 -
Cogent systems RF-READER USER MANUAL DRIVERINSTALL_2 N Browse the drivers documents, press Y and choose next (N) as the following picure:
Start to install the driver. See the picture below:
DRIVERINSTALL_3
- 2 -
Cogent systems RF-READER USER MANUAL DRIVERINSTALL_4 When the installation is completed, choose done. DRIVERINSTALL_5 Confirm if the driver has been installed well. Press my computer by right key and choose
- 3 -
Cogent systems RF-READER USER MANUAL manage. After open the computer management, select device controller to check if the driver has been installed well. Look at the picture below, it suggests that the driver has been installed well.
Operation manual:
Demo CLR2007.exe Open the Demo program CLR2007.exe, see the picture below:
- 4 -
Cogent systems RF-READER USER MANUAL DEMO ReadOK Put the card upon the reading area. Then choose read, while massage box suggests that it is well done. The reading procedure is completed.
(READ writeOK Put the card upon the reading area. Then choose write, while massage box suggests that it is well done. The writing procedure is completed.
- 5 -
Cogent systems RF-READER USER MANUAL
(WRITE)
- 6 -
FCC INFORMATION This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This device complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. The antenna used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help. The installer of this radio equipment must ensure that the antenna is located or pointed such that it does not emit RF field in excess of Health Canada limits for the general population; consult Safety Code 6, obtainable from Heath Canadas website www.hc-sc.gc.ca/rpb.