USER MANUAL IOT MODULE NB S FCC ID: 2AQHSF0410001 www.comodule.com Introduction The COMODULE IoT device is designed to be connected wirelessly into existing network infrastructure to gather and transmit data and to be controlled remotely. It thus creates opportunities for the physical world to be digitalized, which results in improved efficiency, accuracy and economic benefits. This manual is intended for electric kick scooter service providers for COMODULE IoT module integration. www.comodule.com Installation For the installation, the following equipment is needed:
COMODULE IoT module NB S Bolts for installation (come with COMODULE device) Compatible electric kick scooter ( Ninebot kick scooter used in the example) Installing the modules on the scooters 1. Remove the bolts on the lower part of the tube of the scooter with a torx head. 2. Plug the scooters to the electricity and make sure they show battery signal on the display. 3. Attach the IoT module to the scooter. Use bolts ISO 7380 TX M6 X 20. Apply threadlocker to the bolt. 4. Plug the cable of the module to the cable of the scooter. www.comodule.com www.comodule.com Interference INSTRUCTION TO THE USER:
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. In order to maintain compliance with FCC regulations, shielded cables must be used with this equipment. Operation with non-approved equipment or unshielded cables is likely to result in interference to radio and TV reception. The user is cautioned that changes and modifications made to the equipment without the approval of manufacturer could void the user's authority to operate this equipment. www.comodule.com