Power Requirements Serial 4-Pin Connector Pin Assignment Power Over Ethernet 1x 802.3af/at PoE, IEEE 802.3af/at (48-56v) for Daughter Board Pin JTAG Interface Pin Signal Pin Serial 6-Pin Connector Pin Assignment Signal VCC 3.3V UART Transmit Data UART Receive Data GND Signal VCC 3.3V UART1_RTS UART1_TXD UART1_RXD UART1_CTS GND LED Indicators POWER Ethernet1 Ethernet0 Signal VDD USB2_D_M USB2_D_P GND GND GND LED Indicators USB 2.0 Port Pin Assignment 1 2 3 4 1 2 3 4 5 6 DS5 DS11 DS10 Pin 1 2 3 4 5 6 DC Jack Connector 12V for main board Power Consumption 12W (Max) JTAG Interface Pin 1 3 5 7 9 11 13 15 17 19 1 2 3 4 5 6 7 1 2 3 4 5 6 7 8 9 Signal 3.3V JTAG_TRST_N JTAG_TDI JTAG_TMS JTAG_TCK NC JTAG_TDO JTAG_RST_N GND GND 2 4 6 8 10 12 14 16 18 20 3.3V NC GND GND GND NC GND NC GND GND SIM Slot Pin Assignment SIM Slot Pin VCC RST CLK CD GND VPP I/O SIM Signal VCC SIM_RST SIM_CLK GND VPP SIM_DATA SIM_CARD_IN SD Card Socket Pin Assignment SD card socket SD_DAT2 SD_CD/DAT3 SD_VSS/GND SD_CMD SD_VDD SD_CLK SD_DAT0 SD_DAT1 SD_CD 10/11 Cover_GND/SD_GND Compex Systems Pte Ltd | www.compex.com.sg | (+65) 6288 8220 | sales@compex.com.sg | Last Updated: 13/05/2022 SL, LL Last Updated: 13/05/2022 hardware guide - wpj419Copyright Compex Systems. All rights reserved. COMPEX and the COMPEX logo, are registered trademarks of Compex Systems.While every effort is made to ensure the information is accurate, Compex does not accept liability for any errors or mistakes that may arise. All specifications are subject to change without notice. LTE Module Slot (2mm LTE Module Slot) GPIO Pin Mapping Top side Bottom side GPIO Pin Function GPIO Pin Function 1 3 5 7 9 11 13 15 17 19 21 23 25 27 29 31 33 35 37 39 41 43 45 47 49 51 Mechanical key NC NC NC NC NC NC GND GND NC NC GND GND GND GND GND
+3.3V
+3.3V GND NC NC NC NC USB3.0_RX-
USB3.0_RX+
USB3.0_TX-
USB3.0_TX+
2 4 6 8 10 12 14 16 18 20 22 24 26 28 30 32 34 36 38 40 42 44 46 48 50 52
+3.3V GND NC UIM_PWR UIM_DATA UIM_CLK UIM_RST UIM_VPP GND NC NC
+3.3V GND NC NC NC GND USB_D-
USB_D+
GND NC UIM_DET NC NC GND
+3.3V JTAG_TDI JTAG_TCK JTAG_TMS JTAG_TDO GPIO_35 GPIO_36 GPIO_37 GPIO_38 NC PULL_DOWN PULL_DOWN PULL_DOWN JTAG_RST_N GPIO_39 PCIE_CLK_REQ_N JTAG_TRST_N GPIO_40 MDIO MDC GPIO_42 GPIO_41 PCIE_W_DISABLE_L BISP_UART1_TXD GPIO_43 BISP_UART1_RXD GPIO_44 GPIO_10 BISP_UART1_CTS GPIO_45 GPIO_11 BISP_UART1_RTS GPIO_46 GPIO_12 BISP_SPI0_SS0_N GPIO_47 MALIBU_RESET_N GPIO_13 BISP_SPI0_MISO GPIO_48 PWRDN_WIFI GPIO_14 GPIO_15 PULL_DOWN GPIO_49 NC PULL_UP GPIO_50 PCIE_WAKE_UP_N GPIO_16 BISP_UART0_RXD GPIO_51 PULL_DOWN GPIO_17 BISP_UART0_TXD GPIO_52 GPIO_18 CHIP_IRQ_IN GPIO_53 GPIO_19 CHIP_RST_OUT GPIO_54 NC NC SDIO_CD SDIO_DAT_0 SDIO_DAT_1 SDIO_DAT_2 SDIO_DAT_3 SDIO_CLK SDIO_CMD NC NC NC NC NC PULL_UP GPIO_55 GPIO_56 GPIO_57 GPIO_58 GPIO_59 GPIO_60 GPIO_61 GPIO_62 GPIO_63 GPIO_64 GPIO_65 GPIO_66 GPIO_67 GPIO_68 GPIO_69 NC NC NC NC NC NC NC NC NC NC NC NC NC NC NC NC NC NC NC NC PULL_DOWN PULL_DOWN PULL_UP PULL_DOWN GPIO_0 GPIO_1 GPIO_2 GPIO_3 GPIO_4 GPIO_5 GPIO_6 GPIO_7 GPIO_8 GPIO_9 GPIO_20 GPIO_21 GPIO_22 GPIO_23 GPIO_24 GPIO_25 GPIO_26 GPIO_27 GPIO_28 GPIO_29 GPIO_30 GPIO_31 GPIO_32 GPIO_33 GPIO_34 Compex Systems Pte Ltd | www.compex.com.sg | (+65) 6288 8220 | sales@compex.com.sg | Last Updated: 13/05/2022 SL, LL Last Updated: 13/05/2022 hardware guide - wpj419Copyright Compex Systems. All rights reserved. COMPEX and the COMPEX logo, are registered trademarks of Compex Systems.While every effort is made to ensure the information is accurate, Compex does not accept liability for any errors or mistakes that may arise. All specifications are subject to change without notice. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruc-
tions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television recep-
tion, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
1. Reorient or relocate the receiving antenna. 2. Increase the separation between the equipment and receiver. 3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 4. Consult the dealer or an experienced radio/TV technician for help. This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interfer-
ence that may cause undesired operation. Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate this equipment. RF Exposure The antennas used for this transmitter must be installed to provide a separa-
tion distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. miniPCIe Slot Pin Assignment FCC Statement MiniPCIe slot ( 9.9mm height mini-PCIe slot) Top side Bottom side PCIE_RST
+3.3V GND NC NC NC NC NC NC GND NC
+3.3V GND GND GND NC NC NC NC NC NC NC NC NC GND
+3.3V 1 3 5 7 9 11 13 15 17 19 21 23 25 27 29 31 33 35 37 39 41 43 45 47 49 51 Pin 1 2 3 4 5 6 7 8 Mechanical Key PCIE_WAKE_UP_N PWRDN_WIFI PCIE_CLK_REQ_N PCIE_CLK-
PCIE_CLK+
NC GND GND NC NC GND GND GND GND NC
+3.3V
+3.3V NC
+5V
+5V
+5V
+5V PCIE_RX-
PCIE_RX+
PCIE_TX-
PCIE_TX+
2 4 6 8 10 12 14 16 18 20 22 24 26 28 30 32 34 36 38 40 42 44 46 48 50 52 Signal TX+/POE+
TX-/POE+
RX+/POE-
TX+/POE+
TX-/POE+
RX-/POE-
RX+/POE-
RX-/POE-
Ethernet 0 Pin Assignment Compex Systems Pte Ltd | www.compex.com.sg | (+65) 6288 8220 | sales@compex.com.sg | Last Updated: 13/05/2022 SL, LL Last Updated: 13/05/2022 hardware guide - wpj419Copyright Compex Systems. All rights reserved. COMPEX and the COMPEX logo, are registered trademarks of Compex Systems.While every effort is made to ensure the information is accurate, Compex does not accept liability for any errors or mistakes that may arise. All specifications are subject to change without notice.