WLM200NX MINIPCI 2 x 2 802.11N MIMO mini-PCI Modules WLM200NX MiniPCI network adapter provides leading 802.11a/b/g/n performance, supporting up to 300Mbps physical data rates and 200Mbps of actual user throughput on both the uplink and downlink. With the dual-
band design you will enjoy universal connectivity to any 802.11 device through your wireless AP or wireless Router. Built on Atheros chipset, it can be used with all draft IEEE 802.11n compatible WLANs, and is ideally suited to be integrated into a wide range of OEM devices. Features 2.4/5GHz IEEE 802.11a/b/g/n standard Output Power of up to 20dBm @ a/b/g/n Band Support for up to 2x2 MIMO with spatial multiplexing Four times the throughput of 802.11b/g and 802.11a Transmission Power Control (TPC) Enhanced performance with Atheros XSPAN technology Optimized for higher throughput High Performance (up to 300Mbps physical data rates and 200Mbps of actual throughput) Wireless Encryption and Authentication Supported at long range with Low Power Consumption 2 X U.FL Antenna Connector Multi-Country Roaming Support (IEEE802.11d) Suitable for Embedded System or OEM Project Affordable and Ideal for a Variety of Applications AR9220 Technical Specifications Chipset Host Interface PCI Interface v2.3 (Type III-B Mini PCI form factor) Operating Voltage Power Consumption Antenna Connector 2 x U.FL Antenna Connector 3.3 VDC 2.4W IEEE 802.11a : 54Mbps 48Mbps IEEE 802.11b : 11Mbps 5.5Mbps 54Mbps 48Mbps IEEE 802.11g : Fallback to 5.5Mbps, 2Mbps, 1Mbps 36Mbps 2Mbps 36Mbps 24Mbps 18Mbps 12Mbps 9Mbps 6Mbps 1Mbps 24Mbps 18Mbps 12Mbps 9Mbps 6Mbps automatically IEEE 802.11n :
20MHZ 40MHz 1Nss: 65Mbps @ 800GI, 72.2Mbps @ 400GI (Max.) 2Nss: 130Mbps @ 800GI, 144.4Mbps @ 400GI (Max.) 1Nss: 135Mbps @ 800GI, 150Mbps @ 400GI (Max.) 2Nss: 270Mbps @ 800GI, 300Mbps @ 400GI (Max.) OFMD: BPSK, QPSK, 16 QAM, 64QAM DSSS: DBPSK, DQPSK, CCK 64/128-bit WEP, TKIP, AES, IEEE802.1x authentication FCC, CE Yes Operating: -20C to 70C Storage: -65C to 100 5% to 95% (non-condensing) 59.6 x 51 x 3 mm WLM200NX MIMO MINIPCI CARD RADIO TX SPECIFICATIONS TX Power 18dBm 18dBm 17dBm 16dBm DataRate 6-24Mbps 36Mbps 48Mbps 54Mbps 6-24Mbps 36Mbps 48Mbps 54Mbps 20dBm 19.5dBm 18.5dBm 17dBm Tolerance 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 802.11b 802.11n DataRate TX SPECIFICATIONS TX Power 20dBm 20dBm 20dBm 20dBm 1Mbps 2Mbps 5.5Mbps 11Mbps Tolerance 2dB 2dB 2dB 2dB 2.4GHz 5GHz HT20 @800GI(400GI): +16 ~ +20dBm HT40 @800GI(400GI): +14 ~ +18dBm HT20 @800GI(400GI): +10 ~ +18dBm Data Rate 1M 5.5M 11M RX SPECIFICATIONS802.11b Sensitivity (Typical/Maximum 2Rx)
-96/-92Bm
-94/-90dBm
-91/-87dBm Tolerance 2dB 2dB 2dB RX SPECIFICATIONS(802.11a) Data Rate Sensitivity
(Typical/Maximum 2Rx) 6M 9M 12M 18M 24M 36M 48M 54M
-95/-91dBm
-95/-91dBm
-95/-91dBm
-94/-90dBm
-90/-86dBm
-87/-83dBm
-83/-79dBm
-82/-78dBm Tolerance 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 802.11g RX SPECIFICATIONS802.11g Data Rate Sensitivity
(Typical/Maximum 2Rx) 6M 9M 12M 18M 24M 36M 48M 54M
-96/-92dBm
-96/-92dBm
-96/-92dBm
-95/-91dBm
-92/-88dBm
-89/-85dBm
-85/-81dBm
-83/-79dBm Tolerance 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB Data Rate Modulation Techniques Security Certificate ROHS Compliance Environment Specifications Humidity Dimension 802.11a 802.11g 802.11b 802.11a 802.11 a/n HT20 802.11 a/n HT40 MCS0 MCS1 MCS2 MCS3 MCS4 MCS5 MCS6 MCS7 MCS8 MCS9 MCS10 MCS11 MCS12 MCS13 MCS14 MCS15 MCS0 MCS1 MCS2 MCS3 MCS4 MCS5 MCS6 MCS7 MCS8 MCS9 MCS10 MCS11 MCS12 MCS13 MCS14 MCS15
-95/-91dBm
-94/-90dBm
-92/-88dBm
-88/-84dBm
-85/-81dBm
-81/-77dBm
-80/-76dBm
-77/-73dBm
-94/-90dBm
-92/-87dBm
-89/-85dBm
-86/-82dBm
-83/-79dBm
-78/-74dBm
-77/-73dBm
-74/-69dBm
-91/-87dBm
-90/-86dBm
-88/-84dBm
-85/-81dBm
-82/-78dBm
-78/-74dBm
-77/-73dBm
-74/-70dBm
-91/-87dBm
-88/-84dBm
-86/-82dBm
-83/-79dBm
-80/-76dBm
-75/-71dBm
-73/-69dBm
-70/-66dBm 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 802.11 b/g/n HT20 802.11 b/g/n HT40 MCS0 MCS1 MCS2 MCS3 MCS4 MCS5 MCS6 MCS7 MCS8 MCS9 MCS10 MCS11 MCS12 MCS13 MCS14 MCS15 MCS0 MCS1 MCS2 MCS3 MCS4 MCS5 MCS6 MCS7 MCS8 MCS9 MCS10 MCS11 MCS12 MCS13 MCS14 MCS15
-96/-92dBm
-95/-91dBm
-93/-89dBm
-90/-86dBm
-87/-81dBm
-83/-76dBm
-81/-76dBm
-79/-73dBm
-95/-91dBm
-93/-89dBm
-90/-86dBm
-87/-83dBm
-84/-80dBm
-79/-75dBm
-77/-73dBm
-75/-71dBm
-90/-86dBm
-90/-86dBm
-89/-85dBm
-87/-82dBm
-84/-79dBm
-79/-75dBm
-78/-74dBm
-75/-71dBm
-90/-86dBm
-89/-85dBm
-87/-83dBm
-84/-80dBm
-81/-77dBm
-76/-72dBm
-74/-68dBm
-71/-67dBm Driver Linux Madwifi, WindowsXP , Windows 2000,Windwos Vista DRIVER INFORMATION 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB 2dB
Configurations are subjected to change without notice COMPLIANCE INFORMATION FCC NOTICE This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This device generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this device does cause harmful interference to radio or television reception, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Connect the computer into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Caution: Any changes or modifications not expressly approved by the grantee of this device could void the user's authority to operate the equipment. FCC Compliance Statement: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired Increase the separation between the computer and receiver. operation. This device must accept any interference received, including interference that may cause undesired operation. IEEE 802.11b or 802.11g operation of this product in the U.S.A. is firmware-limited to channels 1 through 11. RF exposure warning The equipment complies with FCC RF exposure limits set forth for an uncontrolled environment. The equipment must not be co-located or operating in conjunction with any other antenna or transmitter. IMPORTANT NOTE: EQUIPMENT MANUFACTURERS COMPEX FOR DISPLAYING WLM200NX MODULAR FCC ID ON FINAL INTEGRATED FCC ID: TK4WLM200NX OEM integration instructions:
This device is intended only for OEM integrators under the following conditions The module is only limited to installation in mobile applications. The antenna must be installed such that 20 cm is maintained between the antenna and users, and the transmitter module may not be co-located with any other transmit or antenna. The module shall be only used with the integral antenna(s) that has been originally tested and certified with this module. As long as 3 conditions above are metfurther transmitter test will not be required. However, the OEM integrator is still responsible for testing their end-product for any additional compliance requirement with this module installed (for exampledigital device emissionPC peripheral requirementsetc.) End product labeling:
This transmitter module is authorization only for use in device where the antenna may be installed such that 20cm may be maintained between the antenna and users. The final end product must be labeled in a visible area with the following: Contains Transmitter Module FCC ID:
TK4WLM200NX or Contains FCC ID: TK4WLM200NX. FCC ID: TK4WLM200NX IMPORTANT NOTE: EQUIPMENT MANUFACTURERS COMPEX FOR DISPLAYING WLM200NX MODULAR FCC ID ON FINAL INTEGRATED