8103/2200 14:21 COMPUTIME LTD > +852 2785 5487 tot Yeremmari o Wireless Alarm with Motor Sensors M Programmable Remote Included Wireless wall-mounttable top alarm LOCATION OF CONTROLS DEL SP210E
1. Motion Sensor 2. Alarm Speaker -
3. IR Remote Receiver 0 4. Status LED om 5. Battery Compartment Disarm Gatipn. 6. AF Siren Speaker Unit programmable switch 7. IR Remote Control programmable switch
:{fRemote Control Eentral. The Wireless Alana be a delay of 10 second pen Fe continues, the Your new alarm is designed so that it can be armed and disarmed using a factory programmed remot is red using 4 AA alkaline batteries (not supplied). If activated and motion is detected, there before the siren sounds, The siren will sound for 30 seconds before the alarm automatically resets. iff siren will sound for another 30 seconds, until the alarm is deactivated using the BATTERY INSTALLATION (SEE FIGURES BELOW) . Access the battery compartment on the rear of the unit by removing the back cover. Press on the aper center part of the cover and slide it down. Insert four (4) AA batteries (net includ-
ed} following the polarity diagram. When the Jast battery is inserted, the Status LED will flash and the Siren will chirp to indicate the batteries are installed property. Replace the battery com-
partment cover. The Siren will chirp in every 10-15 seconds when the batteries need replacing. BATTERY PRECAUTIONS . Follow these precautions when using batteries in this device:
1. Use only the size and type of batteries specified. 2. Be sure to follow the corract polarity when installing the batteries as indicated in the battery compartment. Reversed batteries may cause damage of the device. 3. Do not mix different type of batteries together (2.9. Alkaline and Carbon-zinc) or ald 4 r a tect Remote Control Side down to oxposo batteries with fresh ones.
|. if the device Is not to be used for a long period of time, remove the batteries to prevent damage or injury fram possible battery leakage. 5. Do not try to recharge batteries not intended to be recharged; they can avetheat and Tupture. (Follow battery manufacturer's directions.) *
NOTE; Not intended for use In exposed outdoor applications, Will not operate properly if used in below. freeziriy focations. GPERATION i FNSTALLATION Arming the Alarm The unit is dasigned to be either free standing or wall mounted. When leaving the protected apea walt MOUNTING the Motion Detector unit an Choose the desired location, remove the back plate. Battery bow LED il fas sh a point the Remote Control sg the ARM button. The j@ Siren will chirp ta indicat:
felay of 30 seconds to enabl:
arate 2 PEN screws provided secure the plate to the wall (see you to lee the preted ared|befare ay alarm sounds. Wher se . motion is detected, the alarm wilt sound, 3 Giip te unk on . the back plate ensuring that the batteries WARNING: THE ALARMJSIREN IS VERY LOUC 4. Secure the unit to the back plate hy fastening the screw on PLEASE 00 NOT ALLOW THIN SOUND FOR VERY LONE the bottom of the unit. inate TIME PROGRAMMING THE ALARM When returning to the pratactadiarea, simply point the Remot 1. Remove battery compartment cover, remove batteries. Control at the ten bee ctor it 4 press py EOISARIT: buttor 2, Locate the IR Remote Control programmable switch and set 4 switches at desirable positions. 3. To use the Alarm unit in combination with AF Siren Speaker Unit, locate the RF Siren Speaker programmable switch and sat 3 switches to match the 3 dip switch settings of 9 tain is pressed, the Battery Lo:
chirp to indicate the unit This will disarm the unit: Thai G/seconds delay enables you t get to the alarm before it soul :
NOTE: When the DISARM"b!
LEO witt flash and the Siren!
disarmed. the SP210B. Range of detection :
4, Replace batterfes and battery compartment cover. The Motlon Detector has a S0atet range, with approximate 12 INSTALLATION degrees angle of coverage. The unit Is designed to be either free standing or wail mounted. Care and Maintesance 4 For wall mounting place the unit in the destred location, preferable To clean the unit housing used soft cloth slightly dampene next to the front or back door. , with water and wipa dry. Oqjht use chemical agents as th Install the unit using the supplied screw (see figure at right.) may damage and discolor thawijit, anere
@1-MAR-2088 14:31 +852 2798 3996 3%
8683-2088 ive COMPLITIME LTE + 252 2745 S152 NO, B36 Dg2 WARNING '
Changes of modifications to this uni{ not expressly appoved by the party responsible or compliance could void the user's authority to operate the equipment, 4 in addition, for @ Class B digital device or peripheral of cordless phone. the user manual shai include the follaving or similar statement, placed in a prominent location in the text of the manual : |
NOTE '
This equipment has been tested and found to comaly with the mits fo a Ciass B cigite! device, pursuact to ode 15 of the FCC Rules. These limits are designed to provide reasonable protecton aganst harmful interference in a resident a! installation. This equipment generates, uses and can radiate rad o frequency enegy ard if not installed and used in accordance with the instructions, may cause harmful interference to radio Communications. i However, there is no guarantee that interference wil net occur na particu'ar instalation. If this equipment dogs cause harmful interference to radio oF television reception, which can be determined by turning the equipment off and or, the User is encouraged to try to corract the interference by one or mare of the following meas.res:
1, Reorient or relocate the receiving antenna. fi 2. Increase the separation between the equipment ard receiver. il 3, Connect the equigment into an outlet on 4 c.rcuit differert rom thal to which the receiver is needed 4. Consutt the dealer or an experienced radio/TV technician for help. f