ConectiSys HNET 5.0 Installation and Operations Manual Sections:
I. FCC Warning and Compliance Statement II. Radio and antenna installation into power meter. III. Meter installation. IV. Meter unit operation. V. Reference Figures. I. FCC Warning and Compliance Statement FCC Warning The users manual or instruction manual for an intentional or unintentional radiator shall caution the user that changes or modifications not expressly approved by the party responsible for compliance (ConectiSys) could void the user's authority to operate the equipment. FCC Compliance Statement This device complies with Part 15 of the FCC Rules. Operation is subjected to the following two conditions 1) this device may not cause harmful interference and 2) this device must accept any interference received, including interference that may cause undesired operation. II. Radio and antenna installation into power meter Introduction: HNET 5.0s radio system was designed to be integrated into a Siemens Altimus 240v 60Hz Solid State Electricity Meter or equivalent for wireless power usage monitoring. The radio module consists of three PCB assemblies (power supply, controller module and RF module) and an antenna. The power supply consists of a 240VAC to 3.3VDC converter with external wire interfaces to the power meter (for AC input) and to the controller module (for DC output). The controller module and RF modules interface together via PCB mounted headers. The controller is interfaced to the meter PCB via optically coupled serial data lines. The dipole antenna is mounted inside of the meter along the bottom side of the meter faceplate. Page 1 of 5 Installation:
Note: Before radio installation has begun, it is assumed the radio module
(consisting of power supply, controller module and RF module) has already been assembled and tested in accordance with the manufacturers acceptance test procedure. See Figure 1. 1. Connect the AC input cable between power supply and meter PCB. (See 2. Connect controller module data interface cable to meter PCB. (See Figure 2a and 2b.) Figure 2a.) 3. Set radio into meter housing and install mounting screws. Ensure that no cables are crimped or physically interfering with the meter PCB or radio modules. (See Figure 3.) 4. Connect controller module data interface cable to controller module. (See Figure 3.) 5. Mount antenna along bottom side of meter faceplate. Antenna elements should be flat up against meter faceplate. (See Figure 4.) 6. Connect antenna coax cable from MMCX connector on antenna PCB to MMCX connector on RF module. Cable should be run on the right side of the meter and between the RF and controller modules. 7. Install meter assembly onto meter back-plate and insert locking tabs. Ensure coax and cables are not crimped or physically interfering with meter assembly. III. Meter Installation:
Assembled meter unit is to be installed on an appropriate meter box by authorized utility company personnel in accordance with all safety precautions and procedures. IV. Meter Unit Operation:
Meter assemblies with installed radio modules are non-user controlled wireless monitoring devices and need no direct end-user setup or intervention. Wireless meter units are remotely controlled by a base-station not described in this document. Page 2 of 5 V. Reference Figures. Figure 1 Radio Module Figure 2a AC and Data Input Cables Page 3 of 5 Figure 2b AC Input Cable Figure 3 Radio Mounting Page 4 of 5 Figure 4 Antenna Mounting Page 5 of 5