Ethernet Cable HDMI Cable RS232 Cable FCC Statement These limits are designed to provide reasonable protection against harmful FCC ID: 2AI6X-PPLAYIT IC: 21722-PPLAYIT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with theinstructions, may cause harmfu interferencel to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna Increase the separation between the equipment and receiver Connect the equipment into an outlet on a circuit different from that to which the receiver is connected Consult the dealer or an experienced radio/TV technician for help To assure continued compliance, any changes or modifications not expressly approved by the party Responsible for compliance could void the users authority to operate this equipment( i.e. use only shielded interface cables when connecting to computer or peripheral devices) This device is designed to meet the requirements for exposure to radio waves Communications Commission (USA) and Canada. This Transmitter must be installed to provide a separation distance of at least 20 cm from all persons. Only approved detachable antennas can be used established by the Federal This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that the device. Le prsent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorise aux deux
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radiolectrique susceptible d'en compromettre le fonctionnement."
may cause undesired operation of subi, mme si le brouillage est conditions suivantes :
The device for operation in the band 5150-5250 MHz is only for indoor use interference to co-channel mobile
(i.e. priority users) of the bands 5250-5350 MHz and 5650-5850 MHz and that these radars could cause interference and/or damage to LE-LAN devices. satellite systems.High-power radars are allocated as primary users to reduce the potential for harmful Le dispositif pour lopration dans la bande 5150-5 250 MHz est uniquement pour usage lintrieur rduire le risque de brouillage sont dsigns comme utilisateurs principaux (c'est--dire les utilisateurs de priorit) des bandes 5250-5350 MHZ et dispositifs LAN-EL. radars pourraient causer des interfrences et/ou endommager les canal commun de systmes mobiles par satellite.Haute puissance radars 5650-5850 MHz et que ces prjudiciable au The devices with detachable antenna(s), the maximum antenna gain permitted for devices in the band 5725-5850 MHz shall be such that the equipment still complies with the e.i.r.p. limits specified for point-to-point and non-point-to-point operation as appropriate; The worst-case tilt angle(s) necessary to remain compliant with the e.i.r.p. elevation mask requirement set forth in RSS-247 Section 6.2.2(3) shall be clearly indicated, that is: (not applicable).