To install:
Connect wires per wiring diagram as follows:
Neutral Neutre Neutro White Blanc Blanco Black Noir Negro Red Rouge Rojo Hot Phase Vivo Load Charge Carga
(Ground) Green
(Terre) Verte
(Tierre) Verde Neutral Neutre Neutro Remove pre-stripped insulation on device wires. Strip wires in box 1/2. Twist ends of stripped wires together as per schematic. Twist on wire connectors clockwise until secure. Connect green ground wire to bare wire, and mount to box with screws. After completing successful installation LED on device will blink until programmed. For detailed programming instructions for your Switch, refer to the ASPIRE RF manual that is included with the Handheld (RFHDCSG) or Table Top (RFTDCSG) Controller. FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1:
2:
may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. This device may not cause harmful interference, and This device must accept any interference received, including interference that However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. FCC CAUTION:
Any changes or modifications not expressly approved by Cooper Wiring Devices could void the users authority to operate the equipment.