BLELRA1 LoRa Based Vehicle Asset Tracker Users Manual Changes or modifications not expressly approved by the manufacturer could void the users authority to operate the equipment Federal Communication Commission Statement (FCC, U.S.) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
Reorient or relocate the receiving antenna. Connect the equipment into an outlet on a circuit different from that to which the receiver Increase the separation between the equipment and receiver. is connected. Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Caution:
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment ISED RF Exposure Guidance Statement:
In order to comply with FCC/ISED RF Exposure requirements, this device must be installed to provide at least 20 cm separation from the human body at all times. Afin de se conformer aux exigences dexposition RF FCC / ISED, cet appareil doit tre install pour fournir au moins 20 cm de sparation du corps humain en tout temps. NOTE: The CoreKinect LoRa Based Vehicle Asset Tracker and location Name complies with Industry Canada RSS 247 standard. See RSS GEN 7.1.5. The term IC: before the certification/registration number only signifies that registration was performed based on a Declaration of Conformity indicating that Industry Canada technical specifications were met. The term IC: before the certification/registration number does not imply that Industry Canada approved the equipment. Le CoreKinect LoRa Based Vehicle Asset Tracker Ve est conforme la norme dIndustrie Canada RSS 247. Voir RSS GEN 7.1.5. Le terme IC: avant le numro de certification/enregistrement signifie seulement que lenregistrement a t effectu sur la base dune dclaration de conformit indiquant que les spcifications techniques dIndustrie Canada ont t rencontres. Le terme IC: avant le numro de certification/enregistrement nimplique pas quIndustrie Canada a approuv lquipement. ISED RSS Notice:
This device complies with Industry Canadas licence-exempt RSSs. Operation is subject to the following two conditions:
1. This device may not cause interference;
2. This device must accept any interference, including interference that may cause undesired operation of the device. Le prsent appareil est conforme aux CNR dIndustrie Canada applicables aux appareils radio exempts de licence. Lexploitation est autorise aux deux conditions suivantes:
1. lappareil ne doit pas produire de brouillage;
2. lappareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible den compromettre le fonctionnement. Usage 1. Place Beacons inside building, preferably in corners for better triangulation. 2. If sensors are in the building and within the placed beacons, they will attempt to acquire a GPS location. If the sensors fail to acquire GPS they will triangulate using the beacons and then transmit data back to the server.