FCC ID: 2ARKMOBDLRA1 Vehicle Tracking and Diagnostic System

OBDLRA1 OBD II Based Vehicle Telemetry and Location Users Manual Changes or modifications not expressly approved by the manufacturer could void the users authority to operate the equipment Federal Communication Commission Statement (FCC, U.S.) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:

Reorient or relocate the receiving antenna. Connect the equipment into an outlet on a circuit different from that to which the receiver is Increase the separation between the equipment and receiver. connected. Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Caution:

Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment IC WARNING This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canadas license-exempt RSS(s). Operation is subject to the following two conditions:

(1) This device may not cause interference.

(2) This device must accept any interference, including interference that may cause undesired operation of the device Cet appareil contient des metteurs / rcepteurs exempts de licence conformes aux RSS (RSS) d'Innovation, Sciences et Dveloppement conomique Canada. Le fonctionnement est soumis aux deux conditions suivantes:

(1) Cet appareil ne doit pas causer d'interfrences.

(2) Cet appareil doit accepter toutes les interfrences, y compris celles susceptibles de provoquer un fonctionnement indsirable de l'appareil. Contents Frequency Table ......................................................................................................................................... 4 Device Specifications .................................................................................................................................. 5 Installation Instructions ................................................................................................................................ 6 SX1272 nRF52 LoRa: Chirp Spread Spectrum BT: GFSK 902.3-927.7MHz 2402-2480 GHz N/A 2dBi BLE 5

-1.5dBi

-30C to 80C

-30C to 80C Chip Modulation TX Frequency Version Antenna Gain Temperature (operating) Frequency Table Device Specifications Installation Instructions

| WUE IMMUN 10 D584C01200CB an OBDLRA1 Serial): OBDL1A028551 FCC ID: 2ARKMOBDLRA1 IC: 24436-OBDLRA1

ew WWW.COx2m.com

~w Made in USA

Date Federal Communications Commission Authorization & Evaluation Division 7345 Oakland Mills Road Columbia, Maryland 21046 RE: LETTER OF AGENT AUTHORIZATION To Whom It May Concern:

We, the undersigned, hereby authorize Compliance Testing, LLC to act on our behalf in all matters relating to application for equipment authorization, including the signing of all documents relating to these matters. We also hereby certify that no party to the application authorized hereunder is subject to the denial of benefits, including FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of 1988, 21 U.S.C.853(a). Sincerely, ee a =

~ X = =>

Assar Badri CEO CoreKinect LLC 5024 S. Ash Ave, Suite 101 Tempe, AZ 85282

Long Term Confidentiality Request Letter Date: 2/15/2019 Compliance Testing LLC 1724 S. Nevada Way Mesa, AZ 85204 RE: CONFIDENTIALITY REQUEST FOR 2ARKMOBDLRA1 To Whom It May Concern:

This letter serves as an official request for confidentiality under sections 0.457 and 0.459 of CFR 47. We have requested that the following documents required to be submitted with this application be permanently withheld from public review. Block Diagram Schematics Theory of Operation Parts List These documents contain detailed system and equipment descriptions and related information about the product, which manufacturer/applicant considers to be proprietary, confidential, and a custom design and otherwise, would not release to the general public. Since this design is a basis from which future technological products will evolve, manufacturer/applicant feels that this information would be of benefit to its competitors, and that the disclosure of the information in these documents would give our competitors an unfair advantage in the market. Please contact me if there is any information you may need. Sincerely, Assar Badri CEO CoreKinect assar@corekinect.com

COREKINECT FCC Model Difference OBDLRA1 and GENLRA3 FCC ID:2ARKMOBDLRAT1 Model Number: OBDLRA1, GENLRA3 To whom it may concern, We, CoreKinect LLC, declare that the RF schematic, RF hardware version, and RF operating parameters are the same for both the OBDLRA1 and GENLRA3. The differences between the two models are the plastic case formfactor and battery capacity due to different attachment styles and length of time operating between battery charging/replacement. Regards, a Mitchel Kelley Principal Engineer CoreKinect LLC 2800 S. RURAL RD. STE 103 Crete ait tereetet TEMPE, AZ 85282