FCC ID: 2A735-SIRASF1E Wireless image transmission module

Coretronic Intelligent Robotics Corporation SIRAS CONTROLLER Contains RF Module:FLIR / P301-D FCC ID:2A735-SIRASF1E User Manual Product Feature

Based on the principle of TDD, key technologies such as OFDM and MIMO are used to improve frequency band utilization

Support 64QAM, 16QAM, QPSK, BPSK modulation modes and independent dynamic adjustment of multiple code rates

Support AES encryption, support a variety of security policies to prevent illegal monitoring and interception

Adopt frequency hopping scheme, monitor the interference situation in real time, and automatically select the frequency hopping range;

automatically and quickly change the frequency point and adjust the modulation and coding strategy (MCS) according to the interference situation of the current channel

Built-in H.265 encoder, using advanced encoder rate control algorithm, and seamless connection with baseband automatic MCS adjustment, it is more suitable for wireless link transmission under the condition of ensuring image quality SIRAS CONTROLLER Specifications Display screen 5.5 inch1920*1080 1000 cd/m2 System Configuration Android version 9.0 or above 2G running memory, 16G storage space Body size

(excluding antenna, handle) Approx. 180 x 130 x 40 mm weight

<800g Battery ambient temperature 0 ~55 Battery capacity and type 10400 mAh, 7.4V, 2S, Li Po Charging

(fast charging protocol) PD30W charging time 3 H (30W fast charge) Work time Waterproof level Channel Maximum communication distance 6H IP53 16 CH

(no interference, no blocking) 10 KM (FCC) Communication frequency band Data transmission supports flight control 2.4/5.8GHz automatic switching without interruption

(Mavlink protocol) Open source flight control PIX, APM, etc. Video transmission supports QGroundControl ground station

(standard RTSP stream) MissionPlanner Functional interface Charging: Type-C Firmware upgrade: DATA (4-Pin) Mobile network: SIM card slot External storage: TF card slot Tripod mount: 1/4 threaded hole Video output: Standard HDMI Install the Hardware

The location of P301-D on SIRAS CONTROLLER Step1. Put P301-D in the slot after opening the housing of remote. Step2. Press down into the slot Step3. locking screw Step.4 Installing the Antenna IPEX Connector Step.5 Installing the heat sink and locking screw Step.6 Install the heat shield Step.7 Combine the upper and lower covers of remote by four screws. ANTENNA LIST This radio transmitter FCC ID: 2A735-SIRASF1E has been approved by FCC to operate with the antenna types listed below with the maximum permissible gain and required antenna impedance for each antenna type indicated. Antenna types not included in this list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this device. Antenna List No. Manufacturer Part No. Antenna Type Peak Gain 1 CIROCOMM 43N15C6V0W0010T Dipole 4.0dBi / 2400~2500MHz 5.0dBi / 5150~5925MHz FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. CAUTION:

Any changes or modifications not expressly approved by the grantee of this device could void the user's authority to operate the equipment. RF Exposure warning This device meets the governments requirements for exposure to radio waves. This device is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission of the U.S. Government. The exposure standard employs a unit of measurement known as the Specific Absorption Rate, or SAR. The Limb SAR limit set by the FCC is 4.0 W/kg. Tests for SAR are conducted using standard operating positions accepted by the FCC with the EUT transmitting at the specified power level in different channels. The FCC has granted an Equipment Authorization for this device with all reported SAR levels evaluated as in compliance with the FCC RF exposure guidelines. SAR information on this device is on file with the FCC and can be found under the Display Grant section of https://apps.fcc.gov/oetcf/eas/reports/GenericSearch.cfm after searching on FCC ID: 2A735-SIRASF1E. To ensure that RF exposure levels remain at or below the tested levels, use a belt-clip, holster, or similar accessory that maintains a minimum separation distance of 0 mm between your body and the device.

ee" SIRAS This device complies with Part 15 of the SIRAS CONTROLLER FCC Rules. Operation is subject to the following two conditions: (1) this device DC INPUT: 5V=2A /9V=2A may not cause harmful interference, and

(2) this device must accept any BATTERY: 3.7V = 20000mAh interference received, including interference that may cause undesired MODULE : FLIR P301-D operation. Contains FCC ID:2A735-SIRASF1E Teledyne FLIR LLC www.flir.com Made in Taiwan

CorpCoretronic Intelligent Robotics Corporation. No.11,Lixing Rd.,East Dist., Hsinchu City 30078, Taiwan Date: December 2, 2022 Class Il Permissive Change Request Letter This is to request a Class Il permissive change for FCC ID: 2A735-SIRASF1E, originally granted on 08/22/2022. The major change filed under this application is:

Change #1: Additional platform added, product: Remote, model number: SIRAS CONTROLLER. Sincerely, Doug Lin / Senior Engineer Coretronic Intelligent Robotics Corporation

Coretronic Intelligent Rd.,East Robotics Dist.,Hsirichu City 30078, Taiwan No.11,lixing Corporation Dept. FCC TCB To: Telefication B.V., Edisonstraat 12A 6902 PK ZEVENAAR The Netherlands Subject:

Request for confidentiality FCC ID: 2A735-SIRASF1E Reference number:######

Dear FCCTCB, 1.Long-Term Confidentiality Pursuant to 47 CFR Section materials submitted 0.459(a) in support requests application:

of FCC certification

& (b), we hereby non-disclosure and confidential treatment of the following D Bill(s) of Material 121 Block Diagrams 121 Operational Description 121 Schematic Diagrams D Tune-up Procedure contain Above materials under 47 CFR, section parties secrets, 0.457(d)(2). proprietary Disclosure and technical or publication information, or any portion which would customarily from competitors be guarded confidential to other material could cause substantial competitive harm and provide unjustified for competitors. of this company benefits 2.Short-Term Confidentiality

(STC) Pursuant to Public DA 04-1705 CFR 2.803 and the importation following

(See notes below):

materials Notice of the Commission's policy, applicant in order to comply with the marketing hereby in 47 regulations Confidential Short-Term rules in 47 CFR 2.1204, treatment of the requests 121 Internal Photos 121 User's Manual 121 Test Set-up Photos 121 External Photos Justification: Due to market confidential, we ask for the short term confidentiality by list ed 180 days. Date: 10 August Name and signature 2022 of applicant:

Doug Lin/ Senior Engineer l)oll-'o L; YI can only have ONE type of confidentiality!

or type of document Notes:

1) A document 2) Short-Term confidentiality The planned 3) FCC 4) Release 5) Request must be informed takes place automatically for extension or for release is in principle date should stated in the RF731 application earlier. when marketing begins thus extension for 45 days from date of grant;

form. must be received by Telefication must be requested it can be extended max 3 times (total time 180 days max.JI in time. Telefic0tion at leost 7 days before date of actual does not remind you of this!

marketing or before expiration of the STC period