Tapdn 3.0 PIR Sensor Instruction Manual Model: TAPDN-PIR-0002 1) Open top cover by holding the PIR sensor lens gently and pulling the top cover 2) Insert 2x AA batteries into lower housing per the illustrations in the housing 3) Ensure green LED is flashing, then replace top cover, taking note of alignment tabs 4) Remove paper backing and stick to desired flat surface 1) May also mount with screws (not included) 5) Use Tapdn Onboarding app to configure the sensor on the LoRaWAN network FCC ID: 2AT6B-0002 IC: 26085-PIR0002 Model: TAPDN-PIR-0002 THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS.
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. INTERFERENCE RECEIVED, Warning: Changes made to this device without the express permission of TAPDN may void the users authority to operate the device. This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le prsent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorise aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible d'en compromettre le fonctionnement. Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio nterference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication. Conformment la rglementation d'Industrie Canada, le prsent metteur radio peut fonctionner avec une antenne d'un type et d'un gain maximal (ou infrieur) approuv pour l'metteur par Industrie Canada. Dans le but de rduire les risques de brouillage radiolectrique l'intention des autres utilisateurs, il faut choisir le type d'antenne et son gain de sorte que la puissance isotrope rayonne quivalente (p.i.r.e.) ne dpasse pas l'intensit ncessaire l'tablissement d'une communication satisfaisante. This equipment complies with the ICES RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and any part of the human body. Cet quipement est conforme aux limites d'exposition aux radiations ICES dfinies pour un environnement non contrl . Cet quipement doit tre install et utilis une distance minimale de 20 cm entre le radiateur et une partie de votre corps.