CASHFLOW EasiChoice 4 in 1+
Installation Guide CASHFLOW EasiChoice 4 in 1+
Installation Guide General Information 4 in 1 +
3 Button Bezel The 4 in 1 + bezel kit has been designed to add a cashless RFID payment system with Loyalty Card support to a vending machine that uses an MEI bill validator. The 4 in 1 + is also available in a standalone version without the validator. The 4 in 1+ bezel replaces the bezel on the validator To remove the validator from the vending machine:
1. Remove the four 11/32 nuts located on the back of the validator. 2. Remove the 4 screws that hold the old bezel on the validator. Install the 4 in 1+ bezel on the validator and place the validator back into the vending machine. Tighten the 4 nuts against the validator mounting plate. 3. Plug the 4 in 1+ cable into the Advance 5000 socket. General Information 4 in 1+
3 Button Bezel The 4 in 1+ bezel kit has been designed to add a cashless RFID payment system with Loyalty Card support to a vending machine that uses an MEI bill validator. The 4 in 1 + is also available in a standalone version without the validator. The 4 in 1+ bezel replaces the bezel on the validator. To remove the validator from the vending machine:
1. Remove the four 11/32 nuts located on the back of the validator. 2. Remove the 4 screws that hold the old bezel on the validator. Install the 4 in 1+ bezel on the validator and place the validator back into the vending machine. Tighten the 4 nuts against the validator mounting plate. 3. Plug the 4 in 1+ cable into the Advance 5000 socket. Be careful not to pinch or damage the bezel cable when installing the 4 in 1+ bezel. Be careful not to pinch or damage the bezel cable when installing the 4 in 1+ bezel. A5K 4 in 1 +
A5K 4 in 1+
See the Advance 5000 manual for installation instructions. Contact MEI Technical Support @ 1-800-345-8172 with any questions. See the Advance 5000 manual for installation instructions. Contact MEI Technical Support @ 1-800-345-8172 with any questions. Notes:
FCC ID: QP8MEICARD3B CAUTION: changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. Notes:
FCC ID: QP8MEICARD3B CAUTION: changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (a) This device may not cause harmful interference, and (b) this device must accept any interference received, including interference that may cause undesired operation. This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (a) This device may not cause harmful interference, and (b) this device must accept any interference received, including interference that may cause undesired operation. 2013 MEI Inc. MEI 3222 Phoenixville Pike, Suite 200, Malvern, Pa. 19355 www.meigroup.com 2013 MEI Inc. MEI 3222 Phoenixville Pike, Suite 200, Malvern, Pa. 19355 www.meigroup.com