FCC ID: ZPNTPM108 TPMS PSG E type Uni Sensor

TPMS PSG E type Uni Sensor 1. Take the valve cap, valve nut away from the valve stem and keep grommet on the valve stem. Insert the sensor with valve stem into the rim valve hole, put on the valve stem nut. 2. While holding the sensor down against the wheel bottom, hand tighten the nut. With the torque wrench, tighten the nut to 4.0 Nm. 3. Place the plastic cap on. lubricant The force to make it sit shall not exceed 40 kg (90 lb). In case of the valve stem replacing, tighten the screw by 1.35 Nm.

(Tubeless Tire Valve) 180 km/h (112.5 mph). FCC Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 cm between the radiator and a human body. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. ISED Statement:

This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 cm between the radiator and a human body. Cet quipement est conforme aux limites d'exposition aux rayonnements ISED tablies pour un environnement non contrl. Cet quipement doit tre install et utilis avec une distance minimale de 20 cm entre le radiateur et un corps humain. This device contains licence-exempt transmitter(s) that comply with Innovation, Science and Economic Development Canadas licence-exempt RSS(s). Operation is subject to the following two conditions:

(1) this device may not cause interference,

(2) this device must accept any interference, including interference that may cause undesired operation of the device. Lmetteur exempt de licence contenu dans le prsent appareil est conforme aux CNR dInnovation, Sciences et Dveloppement conomique Canada applicables aux appareils radio exempts de licence. Lexploitation est autorise aux deux conditions suivantes :

(1) Lappareil ne doit pas produire de brouillage;

(2) Lappareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible den compromettre le fonctionnement.

TCB Authority to Act as Agent Number:

Revision:

Effective date: Oct 8, 2021 MS-0045317 0 Authority to Act as Agent Date: August 15, 2023 TUV Rheinland of North America, Inc. 1279 Quarry Lane., Suite. A Pleasanton, CA 94566 To Whom It May Concern:

I appoint TUV Rheinland of North American Inc., 1279 Quarry Lane, Suite A, Pleasanton, CA 94566, USA to act as our agent in the preparation of this application for equipment certification. I certify that submitted documents properly describe the device or system for which equipment certification is sought. I also certify that each unit manufactured, imported or marketed, as defined in the FCC or Industry Canadas regulations will have affixed to it a label identical to that submitted for approval with this application. For instances where our authorized agent signs the application for certification on our behalf, I acknowledge that all responsibility for complying with the terms and conditions for Certification, as specified by TUV Rheinland Group, still resides with CUB ELECPARTS INC., No. 6, Lane 546, Sec. 6, Changlu Road, Fuhsin Township, Changhua County, 506, Taiwan. For TCB applications, We certify that we are not subject to denial of federal benefits, that includes FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of 1988, 21 U.S.C. 862. Further, no party, as defined in 47 CFR 1.2002

(b), to the application is subject to denial of federal benefits, that includes FCC benefits. Thank you, Agency Agreement Date:

August 15, 2023 Agreement is valid for 12 months from the above date. By:

(Signature) June Wu

(Print name) Administrator

(Title)

+886-4-7782010

(Telephone) On behalf of:

CUB ELECPARTS INC.

(Company Name) Page 1 of 1

Attestation Statements Not Covered Entity Applicant To: Federal Communications Commission Date: August 15, 2023 7435 Oakland Mills Road, Columbia, MD 21046, USA Ref: Information Required by Section 2.911(d)(5)(ii) filing FCC ID: ZPNTPM108 CUB ELECPARTS INC. (the applicant) certifies that, as of the date of the filing of the application, the applicant is not identified on the Covered List (as a specifically named entity or any of its subsidiaries or affiliates) as an entity producing covered equipment. Sincerely yours, Applicant Signature Printed Name: June Wu Title: Administrator Address: No. 6, Lane 546, Sec. 6, Changlu Road, Fuhsin Township, Changhua County, 506,Taiwan Tel.: +886-4-7782010 Email: junewu@cubelec.com

Attestation Statements Not Covered Equipment To: Federal Communications Commission Date: August 15, 2023 7435 Oakland Mills Road, Columbia, MD 21046, USA Ref: Information Required by Section 2.911(d)(5)(i) filing FCC ID: ZPNTPM108 CUB ELECPARTS INC. (the applicant) certifies that the equipment for which authorization is sought is not covered equipment prohibited from receiving an equipment authorization pursuant to section 2.903 of the FCC rules. Sincerely yours, Applicant Signature Printed Name: June Wu Title: Administrator Address: No. 6, Lane 546, Sec. 6, Changlu Road, Fuhsin Township, Changhua County, 506,Taiwan Tel.: +886-4-7782010 Email: junewu@cubelec.com

TCB FCC Request for Confidentiality Letter Number: MS-0044715 1 Revision:

Effective date: Sep 12, 2022 Author:

Owner:

William Graff William Graff Date: August 21, 2023 Federal Communications Commission Equipment Authorization Branch 7435 Oakland Mills Road, Columbia, MD 21046, USA Subject: Confidentiality Request for FCC ID: ZPNTPM108 Pursuant to FCC 47 CRF 0.457(d), the applicant requests that a part of the subject FCC/IC application be held confidential. Type of Confidentiality Requested Short Term Short Term Short Term Short Term Short Term Short Term Short Term Short Term Short Term Permanent n/a Permanent Permanent Permanent Permanent Permanent Permanent Permanent Exhibit Block Diagrams External Photo Internal Photos ***

Operation Description/Theory of Operation Schematics Test Setup***

Tune-Up Procedure Users Manual***

Part List/ Antenna Construction CUB ELECPARTS INC. has spent substantial effort in developing this product and it is one of the first of its kind in industry. Having the subject information easily available to "competition" would negate the advantage they have achieved by developing this product. Not protecting the details of the design will result in financial hardship. Permanent Confidentiality:

The applicant requests the exhibits listed above as permanently confidential be permanently withheld from public review due to materials that contain trade secrets and proprietary information not customarily released to the public.

(*** Exceptional case for Permanent Confidentiality for these Exhibits by PAG only) Short-Term Confidentiality:

The applicant requests the exhibits selected above as short term confidential be withheld from public view for a period of specify number of days not to exceed 180 days from the date of the Grant of Equipment Authorization and prior to marketing. This is to avoid premature release of sensitive information prior to marketing or release of the product to the public. Applicant is also aware that they are responsible to notify TUV Rheinland in the event information regarding the product or the product is made available to the public. TUV Rheinland will then release the documents listed above for public disclosure pursuant to FCC Public Notice DA 04-1705. Sincerely, By:

_______________________________________________ June Wu Title: Administrator

(Print name) Tel: +886-4-7782010 Email: junewu@cubelec.com MS-0044715 Page 1 of 1 Revision 1

Certification Designating a US Agent for Service of Process To:

Federal Communications Commission Date: August 15, 2023 7435 Oakland Mills Road, Columbia, MD 21046, USA Ref: Attestation Statement Part 2.911(d)(7) filing FCC ID: ZPNTPM108 CUB ELECPARTS INC. (the applicant) certifies that as of the date of the filing of the application, FCC US Agent, LLC (the agent) is our designated U.S. agent. We acknowledge the applicants consent and the designated agent for service of processs obligation to accept service of process. The applicant accepts to maintain an agent for service of process for no less than one year after the grantee has terminated all marketing and importation or the conclusion of any Commission-

related proceeding involving the equipment. The applicant further acknowledges it is our responsibility to inform the FCC whenever the agent information changes. APPLICANT Company Name: CUB ELECPARTS INC. Contact Person: June Wu Address: No. 6, Lane 546, Sec. 6, Changlu Road, Fuhsin Township, Changhua County, 506, Taiwan Tel.: +886-4-7782010 Email: +886-4-7754203 FCC FRN: 0020982906 U.S. Agent Company Name: FCC US Agent, LL FRN: 0033402884 Address: 3722 Illinois Avenue, Saint Charles, IL, 60174, USA Contact Person: Tim Payne Phone: 708-571-3148 Email: Support@FCCUSAgent.com Sincerely yours, The Applicant Company Name CUB ELECPARTS INC. Contact Person June Wu The Agent FCC US Agent, LLC Tim Payne Signature

15-Aug-23 Federal Communications Commission 7435 Oakland Mills Road Columbia, MD 21046 FCC ID: ZPNTPM108 IC: 9959A-TPM108 HVIN: TPM108 Models: TPM108,TPM108XXX,TPM108-XXX,B121-XXXXXX,B121-XXXXXX-X XX,B121-046,B121-046XXX-XXX Declaration on Similarity We herewith confirm that for the models listed above the RF Transmitter Module is Electrically Identical. The differences are only in the model numbers. 1) The suffix x can be 0-9, A-Z, a-z, - or blank for marketing differentiation. ___________________ June Wu

(Printed)

(Signature)