Contents oy ae Quick Installation Guide Komfy Switch with Camera WARNING! Potential Shock Hazard Please read all the instructions before you begin installation. The Komfy Switch is designed for installation in standard electrical boxes and to be installed in accordance with National Fire Protection Association
(NFPA 70). If you are not sure about any part of the instructions, consult a qualified electrician to perform the installation. Verify Switch Compatibility Komfy Switch Cover Faceplate with 2 Click Pads Kom ; y by D-Link | |
-_-> q Wiring Labels | f 1. Not compatible with 3-way (multi-location control) switches. 5 r aT 2. Requires neutral wire (refer to Step 2). ic H ve j Verify Wi-Fi Signal Strength Hold your iPhone close to the switch you are replacing. Make sure Wiring Labels you have a good Wi-Fi signal there. Antennas contained in the device: 1x1 BT antenna, 2x2 WiFi antenna. Komfy Switch with Camera A A i a 5 Wire Nuts 1. Turn Off Circuit Breaker 3. Wire Labeling 6. Attach Komfy Switch 9. Attach Accessories Screw the Komfy Switch into the electrical box and then slide the power selector to 1 or 2. 1-gang and 2-gang have different screws patterns as shown below:
Attach the included faceplate to the Komfy Switch and then put the Komfy Switch cover with click pads over the faceplate. Turn off the power to the light switch at the main circuit breaker or fuse box. Use the included wiring labels and attach the stickers to the corresponding wires. Green for Ground, white for Neutral, black for Hot, red for
"Upper Light and brown for Lower Light. Wiring Labels Important: Flip your light switch a few times to ensure the power is off. 2. Remove Faceplate from Old Switch
. POWER oe Take a picture for future reference. 4. Remove Old Switch Disconnect the old switch from the electrical box. Slide power Slide power selector to 1. selector to 2.
@ Load 5. Wiring 1- Gang: 2 - Gang:
Required. You need 1 load Connect the wires from the Komfy Switch to the old switch wires. 2 middle screws 4 side screws Faceplate Komfy Switch Cover for 1-gang. With Click Pads 7. Turn On The Circuit Breaker Turn the power back on at the circuit breaker or fuse box. Wall Light Switch Outlet Hot Wire (Live) Required. Wall Light Switch Outlet If you want to remove the the switch cover, pull out at the corners either at the top or bottom to remove it.
( Neutral Required, but not always present. | The unused wire STOP if you do not have it. should be protected Ground by a wire nut. Optional, and not always present. Wall Light Switch Outlet Load Required. You need 2 loads for 2-gang. Neutral Required, but not always present. STOP if you do not have it. Hot Wire (Live) Required. Ground Optional, and not always present. Refer to Step 3 for Color Wiring Labeling 8. Press and Hold Setup Button for 5 Seconds When the Wi-Fi LED lights up, press and hold the setup button for 5 seconds until the Wi-Fi LED starts blinking. When the Wi-Fi LED stops blinking, the Komfy Switch is ready to be configured. 10.Configure Komfy Switch Download the Komfy App and sign up for a Komfy account. Tap the Add Device button to complete the configuration.
Dense, Welcome [orecix |
Lets add device with ||
Komi SCT:
. Add Device [coud soraae | Add Device
= [econ]
Ld Existing User