FCC ID: E2KT99W373PC15 5G WWAN Module

Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any inter ference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reaso nable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:

Reorient or relocate the receiving antenna. Connect the equipment into an outlet on a circuit different from that Increase the separation between the equipment and receiver. to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. FCC Caution:

Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Radiation Exposure Statement:

This device meets the governments requirements for exposure to radio waves. This device is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission of the U.S. Government. The exposure standard for wireless device employs a unit of measurement known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6W/kg. *Tests for SAR are conducted using standard operating positions accepted by the FCC with the device transmitting at its highest certified power level in all tested frequency bands. Operation of transmitters in the 5.925-7.125 GHz band is prohibited for control of or communications with unmanned aircraft systems. Industry Canada statement This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:

1) 2) this device may not cause interference, and this device must accept any interference, includ ing interference that may cause undesired operation of the device. Le prsent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorise aux deux conditions suivantes:

1) 2) l'appareil ne doit pas produire de brouillage, et l'utilisateur de l'appareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible d'en compromettre le fonctionnement. This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter, except tested built- in radios. Cet appareil et son antenne ne doivent pas tre situs ou fonctionner en conjonction avec une autre antenne ou un autre metteur, exception faites des radios intgres qui ont t testes. Radiation Exposure Statement:

The product comply with the Canada portable RF exposure limit set forth for an uncontrolled environment and are safe for intended operation as described in this manual. The further RF exposure reduction can be achieved if the product can be kept as far as possible from the user body or set the device to lower output power if such function is available. Dclaration d'exposition aux radiations:

Le produit est conforme aux limites d'exposition pour les appareils portables RF pour les Etats-Unis et le Canada tablies pour un environnement non contrl. Le produit est sr pour un fonctionnement tel que dcrit dans ce manuel. La rduction aux expositions RF peut tre augmente si l'appareil peut tre conserv aussi loin que possible du corps de l'utilisateur ou que le dispositif est rgl sur la puissance de sortie la plus faible si une telle fonction est disponible. The device for operation in the band 51505250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systems. Les dispositifs fonctionnant dans la bande de 5150 5250 MHz sont rservs uniquement pour une utilisation lintrieur afin de rduire les risques de brouillage prjudiciable aux systmes de satellites mobiles utilisant les mmes canaux. Devices shall not be used for control of or communications with unmanned aircraft systems. Les dispositifs ne doivent pas tre utiliss pour commander des systmes daronef sans pilote ni pour communiquer avec de tels systmes.

Label &Label location Label is affixed on the bottom side of host device. RMN: T07H Contains FCC ID: E2KT99W373PC15 Contains FCC ID: E2KBE200D2 Contains FCC ID: E2K-DWRFID2301 Contains IC: 24374-T99W373 Contains IC: 1514B-BE200D2 Contains IC: 1514B-DWRFID2301

Global Regulatory Compliance E Federal Communications Commission Office of Engineering and Technology Equipment Authorization and Evaluation Division 7435 Oakland Mills Road Columbia MD 21046 ATTN: Reviewing Engineer Subject: Agent Appointment & Attestation Statement FCC ID: E2KT99W373PC15 Reference: a) FCC CFR 2.911(d)(5)(i) b) FCC CFR 2.911(d)(5)(ii) c) FCC CFR 2.911(d)(7) a) DELL Inc. (the applicant) certifies that the equi Covered equipment prohibited from receiving Title 47;

b) DELL Inc. (the applicant) certifies that, as of th not identified on the Covered List pursuant to affiliate of a specifically named entity) producing c) DELL Inc. (the applicant) hereby accepts and di engineering & Environmental Affairs Date: 2023/11/15 pment for which authorization is sought is not an equipment authorization pursuant to 2.903 of CFR 2 date of the filing of the application, the applicant is 1.50002 of CFR Title 47, as an entity (nor a subsidiary or Covered equipment;

2signates the following agent for service of process in the United States for matters related to the appl maintain the designated agent for service of pro:

either the grantee has permanently terminated ;

equipment within the U.S., or upon the conclusic proceedings involving the equipment, whichever Agent Designation:

Company name: DELL Inc. Street Address: One Dell Way City/Province/Zip: Round Rock, TX 78682, USA Contact Name: Don Bobo Telephone No: +1 (512) 593 8560 Email: don_bobo@dell.com FRN: 0008359580 Signature of Designated Agent/Applicant:

#7:

KA Printed name: Don Bobo Title: Distinguished Member Technical Staff RQFO401 icable equipment and accepts the obligation to cess in the United States for no less than one year after all marketing and importation of the applicable yn of any Commission related administrative or judicial is the latter.

Date: December 7, 2023 FCC Laboratory 7435 Oakland Mills Rd Columbia MD 21046 SUBJECT: Class II Permissive Change for FCC ID: E2KT99W373PC15, Model: T99W373 The product, 5G WWAN Module , has been granted by FCC dated 10/05/2023 under FCC ID:

E2KT99W373PC15. The intention of this application is to enable the modular certified FCC ID:

E2KT99W373PC15 to be integrated in DELL Portable Computer-Tablet / Model: T07H. The module installed into host platform mentioned above is electronically and mechanically identical to the original certified module. The Original FCC testing on module under FCC ID: E2KT99W373PC15 was performed with an antenna of higher gain, and the antenna was connected to the module in an open environment. The current host platform under application uses an antenna with lower gain and is installed inside the host platform enclosure. The physical restraints introduced by the host platform should have resulted in equal or lower level of radiated emission. Therefore, additional Radiated emission testing is not necessary. William Wei Regulatory Compliance Engineer Tel: +886-2-2376-6556 Email: William.Wei@Dell.com

Date: November 29, 2023 FCC Laboratory 7435 Oakland Mills Rd Columbia MD 21046 Subject: Request for Confidentiality FCC ID: E2KT99W373PC15 To Whom It May Concern, Pursuant to the provisions of Sections 0.457 and 0.459 of Commissions rules (47CFR0.457, 0.459), we are requesting the Commission to withhold the following documents from public disclosure indefinitely. Operational Description Tune-up Procedure Above mentioned documents which contain detailed system and equipment description are considered as proprietary information in operation of the equipment. The public disclosure of above documents might be harmful to our company and would give competitor an unfair advantage in the market. In additional to above mentioned documents, pursuant to Public Notice DA 04-1705 of the Commission s policy, in order to comply with the marketing regulations in 47 CFR 2.803 and the importation rules in 47 CFR 2.1204, while ensuring that business sensitive information remains confidential until the actual marketing of newly authorized devices, we are requesting the Commission to withhold the following documents and release on the date when 731 form remarked, after the grant of equipment authorization is issued:

External Photos Internal Photos Test Setup Photos User Manual It is our understanding that all measurement test reports, FCC ID label format cannot be granted as confidential documents and those information will be available for public review once the grant of equipment authorization is issued. Best Regards, _______________________ William Wei Regulatory Compliance Engineer Tel: +886-2-2376-6556 Email: William.Wei@Dell.com

FCC Agent Authorization Date: November 29, 2023 To whom it may concern, Dell Inc. hereby authorize Sporton International Inc. to act on our behalf in all matters relating to applications for FCC equipment authorization, including the signing of all documents relating to these matters. Any and all acts carried out by Sporton International Inc. on our behalf shall have the same effect as acts of our own. We also hereby certify that neither the applicant nor any party to the application is subject to a denial of Federal benefits that includes FCC benefits pursuant to section 5301 of the Anti-Drug Abuse Act of 1988. 21 U.S.C. 862. This authorization is limited to the product of as following:

FCC ID: E2KT99W373PC15 This authorization is valid until further written notice from Dell Inc. Sincerely, ________________________ William Wei Regulatory Compliance Engineer Tel: +886-2-2376-6556 Email: William.Wei@Dell.com

WARNING:pdfminer.pdfpage:The PDF <_io.BufferedReader name='/Volumes/Scratch/Incoming/eg-scratch/6841195.pdf'> contains a metadata field indicating that it should not allow text extraction. Ignoring this field and proceeding. Use the check_extractable if you want to raise an error in this case Date: September 28, 2023 Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 USA ATTN: Reviewing Engineer Subject: Agent Appointment & Attestation Statement FCC ID: E2KT99W373PC15 Ref: a) FCC CFR 2.911(d)(5)(i) b) FCC CFR 2.911(d)(5)(ii) c) FCC CFR 2.911(d)(7) a) Dell Inc. (the applicant) certifies that the equipment for which authorization is sought is not Covered equipment prohibited from receiving an equipment authorization pursuant to 2.903 of CFR Title 47;

b) Dell Inc. (the applicant) certifies that, as of the date of the filing of the application, the applicant is not identified on the Covered List pursuant to 1.50002 of CRF Title 47, as an entity (not a subsidiary or affiliate of a specifically named entity) producing Covered equipment;

c) Dell Inc. (the applicant) hereby accepts and designates the following agent for the service of process in the Unites States from matters related to the applicable equipment and accepts the obligation to maintain the designated agent for service of process in the United States for no less than one year after either the grantee has permanently terminated all marketing and importation of the applicable equipment within the U.S., or upon the conclusion of any Commission related administrative or judicial proceedings involving the equipment, whichever is the latter. Agent Designation:

Company name: Dell Inc. Street Address: One Dell Way City/Province/Zip: Round Rock, TX78682, US Contact Name: Don Bobo Telephone No: +1(512)593 8560 Email: don_bobo@dell.com FRN: 0008359580 Signature of Designated Agent/ Applicant:

_____________________________________ Printed name: Don Bobo Title: Distinguished Member Technical Staff RQF0401

WARNING:pdfminer.pdfpage:The PDF <_io.BufferedReader name='/Volumes/Scratch/Incoming/eg-scratch/6363515.pdf'> contains a metadata field indicating that it should not allow text extraction. Ignoring this field and proceeding. Use the check_extractable if you want to raise an error in this case Dell Inc. MS: PS4-30 One Dell Way Round Rock, Texas 78682 www.dell.com Don Bobo Distingished Member of Technical Staff EMC, Global Regulations and Standards Telephone 512.593.8560 e-mail don.bobo@dell.com Worldwide Regulatory Compliance Engineering & Environmental Affairs Federal Communication Commission Equipment Authorization Division, Application Processing Branch 7435 Oakland Mills Road Columbia, MD 21048 January 9, 2023 FCC authorization letter for Dell Regulatory employees To whom it may concern, I, the undersigned, as the authorized signatory for the Dell Inc. grantee code E2K, hereby authorize the following EMC & Wireless Regulatory Engineers of Dell Inc., to act on my behalf in all manners relating to processes required according to FCC rules for equipment authorization:

Bill Wang April Chang Fiona Y Chen Kay Chen Yan Papernov Jessie Goh Jack TS Huang Tommy Hwang Nai Ghee Koh Jason KP Lee Jason Limoges Leonel Lopez James V Nguyen Rex Wan William Wei Steve L Williams Julie Shen Leo Hong Dyllan Chang Ken Tai CY Chang Jessie Lin Greg Hsiao Chloe Lin Brad Chen This authorization shall be sent along with application when filing with the FCC Certification Division and is valid until further written notice from the applicant. If you have any questions or need additional information, please feel free to contact me at 512-593-8560 or 512-619-7976. Sincerely, Don Bobo, Dell Inc., FRN: 0008359580 Internal Use - Confidential