USER MANUAL WIRELESS RF DEVICE RF_CC2541 Module EXT TRK-RF-06 REVISION 1.0 COPYRIGHT 2005 TERAOKA WEIGH-SYSTEM PTE LTD Table of Content i) Notice .............................................................................................................................. 1 ii) Safety Information ........................................................................................................... 2 iii) Safety Regulations .......................................................................................................... 3 1. General ..............................................................................................................................................................7 1.1 Product Features ............................................................................................................. 7 1.2 Operating Specification ................................................................................................... 7 2 3. 4. Dimension ....................................................................................................................... 8 Label Information ............................................................................................................. 8 Interface .......................................................................................................................... 9 5. Revision Records ......................................................................................................................................... 10 i) Notice DIGI The material contained in this document is proprietary and for information only and is subject to change without notice. Teraoka Weigh-System assumes no responsibility for any errors or damages arising from misinterpretation of any procedure. Screen displays, operating procedures and supporting features might vary with different software version releases. This document shall not be reproduced whether in part or whole without the written consent from Teraoka Weigh-System Pte Ltd. Teraoka Weigh-System Pte Ltd 4, Leng Kee Road
#06-01 SIS Building Singapore 159088
- 1 -
ii) Safety Information The operator of the equipment shall comply with the safety and warning indications and procedures outlined in this document. Teraoka Weigh-System Pte Ltd assumes no responsibility or liability for failure to comply with these requirements. TRK-RF-06 User Manual For continued protection against fire hazard replace only with battery of same rating and type. Avoid overloading the product beyond its rated maximum capacity Trained and qualified personnel shall only carry out repair and servicing of product. Disclaimer:
Specifications are subject to change without notice. All dimensions shown are approximate. Please be aware that Teraoka has indicated that its hardware and software used in the product may require additional updates in the future as our product is continually under development. The need for such updates most likely applies to the Printer software. 2 iii) Safety Regulations TRK-RF-06 User Manual Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. This device is intended only for OEM integrators under the following conditions:
1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and 2) The transmitter module may not be co-located with any other transmitter or antenna, As long as condition above are met, further transmitter test will not be required. However, the OEM integrator is still responsible for testing their end-product for any additional compliance requirements required with this module installed (for example, digital device emissions, PC peripheral requirements, etc.). IMPORTANT NOTE: In the event that these conditions do not be met (for example certain laptop configurations or co-location with another transmitter), then the FCC authorization is no longer considered valid and the FCC ID could not be used on the final product. In these circumstances, the OEM integrator will be responsible for re-evaluating the end product (including the transmitter) and obtaining a separate FCC authorization. End Product Labeling The final end product must be labeled in a visible area with the following: Contains FCC ID: SUFTRKRF06. Manual Information To the End User The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove this RF module in the users manual of the end product which integrates this module. The end user manual shall include all required regulatory information/warning as show in this manual. 3 TRK-RF-06 User Manual Canada Regulatory Wireless Notice:
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:
1) This device may not cause interference and 2) This device must accept any interference, including interference that may cause undesired operation of the device Le prsent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorise aux deux conditions suivantes :
le dispositif ne doit pas produire de brouillage prjudiciable, et 1) 2) ce dispositif doit accepter tout brouillage reu, y compris un brouillage susceptible de provoquer un fonctionnement indsirable IC Radiation Exposure Statement:
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. Dclaration d'exposition aux radiations:
Cet quipement est conforme aux limites d'exposition aux rayonnements IC tablies pour un environnement non contrl. Cet quipement doit tre install et utilis avec un minimum de 20 cm de distance entre la source de rayonnement et votre corps. This device is intended only for OEM integrators under the following conditions:
1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and 2) The transmitter module may not be co-located with any other transmitter or antenna. As long as condition above are met, further transmitter test will not be required. However, the OEM integrator is still responsible for testing their end-product for any additional compliance requirements required with this module installed (for example, digital device emissions, PC peripheral requirements, etc.). Cet appareil est conu uniquement pour les intgrateurs OEM dans les conditions suivantes:
(Pour utilisation de dispositif module) 1) L'antenne doit tre installe de telle sorte qu'une distance de 20 cm est respecte entre l'antenne et les utilisateurs,et 2) Le module metteur peut ne pas tre complant avec un autre metteur ou antenne. Tant que les condition ci-dessus sont remplies, des essais supplmentaires sur l'metteur ne seront pas ncessaires. Toutefois, l'intgrateur OEM est toujours responsable des essais sur son produit final pour toutes exigences de conformit supplmentaires requis pour ce module install IMPORTANT NOTE: In the event that these conditions can not be met (for example certain laptop configurations or co-location with another transmitter), then the IC authorization is no longer considered valid and the IC ID can not be used on the final product. In these circumstances, the OEM integrator will be responsible for re-evaluating the end product (including the transmitter) and obtaining a separate IC authorization. NOTE IMPORTANTE:
Dans le cas o ces conditions ne peuvent tre satisfaites (par exemple pour certaines configurations d'ordinateur portable ou de certaines co-localisation avec un autre metteur), l'autorisation du Canada n'est plus considr comme valide et l'ID IC ne peut pas tre utilis sur le produit final. Dans ces circonstances, l'intgrateur OEM sera charg de rvaluer le produit final (y compris l'metteur) et l'obtention d'une autorisation distincte au Canada. 4 TRK-RF-06 User Manual End Product Labeling The final end product must be labeled in a visible area with the following: Contains IC:5663A-TRKRF06. Plaque signaltique du produit final Le produit final doit tre tiquet dans un endroit visible avec l'inscription suivante: "Contient des IC: 5663A-
TRKRF06". Manual Information To the End User The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove this RF module in the users manual of the end product which integrates this module. The end user manual shall include all required regulatory information/warning as show in this manual. Manuel d'information l'utilisateur final L'intgrateur OEM doit tre conscient de ne pas fournir des informations l'utilisateur final quant la faon d'installer ou de supprimer ce module RF dans le manuel de l'utilisateur du produit final qui intgre ce module. Le manuel de l'utilisateur final doit inclure toutes les informations rglementaires requises et avertissements comme indiqu dans ce manuel. 5 For Taiwan TRK-RF-06 User Manual IMPORTANT NOTE:
1. 2. : CCXXXXYYyyyZzW 6 TRK-RF-06 User Manual 1. General The module design is based on RF transceiver with integrated MCU core, CC2541. It implements a proprietary communications protocol streamlined to lower cost and power consumption. The antenna used is a PCB antenna. The module will be FCC and TELEC certified for fast and simple integration into end applications. This module may be integrated into a wireless application that operates in 2.4G ISM frequency band. 1.1 Product Features Model Dimension (in mm) RF Standard Modulation Frequency Band Channel list Radio Range Transmit Power (EIRP) Receiver Sensitivity General purpose I/O 1.2 Operating Specification Voltage Current Operating Temperature Storage Temperature Humidity
TRK-RF-06 (RF_CC2541 Module EXT) 20.0(L) X 19.0(W) X 4.0(H) FCC, NCC, IC TELEC
: GFSK
2.402 GHz 2.480 GHz 79 Channels at 1MHz step 2402MHz +(n-1)MHz where n = 1 to 79
: Up to 100m, L.O.S
11.83dBm (max)
-90dBm (typical), PER = 1%
36
DC 3.0V 100mA TX mode,
-20 C to 40 C
-40 to +85 C 95% max non condensing 7 2 Dimension TRK-RF-06 User Manual 8 Label Information 3. TRK-RF-06 User Manual 4. Interface Interface pin assignments 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 VDD VDD GND GND GND GND DC DD P2_0 P1_7 GND GND SCL SDA GND P1_3 P1_2 P1_1 P1_0 GND GND P0_6 P0_5 P0_4 25 26 27 28 29 30 31 32 33 34 35 36 P0_3 P0_2 P0_1 P0_0 RESET_N GND GND P1_4 P1_5 P1_6 P2_3 P2_4 Notes:
1. The I/O pins is connected to the external interface port directly. 2. The voltage level is TTL high/low voltage level. 9 5. Revision Records Serial No. Date 1 2 3 02/09/2013 16/10/2013 31/10/2013 Edition Status 1.0 1.1 1.1 Description of Changes INITIAL RELEASE UPDATE FCC ID AND IC ID UPDATE THE CANADA STATEMENT DUE TO >10mW 10 TRK-RF-06 User Manual Software Version Remarks