INSTALLATION GUIDE 1148 Emergency Pendant Description The 1148 Emergency Pendant is a one-button, wireless emergency transmitter designed to be worn as a bracelet or on a break-away lanyard. The 1148 may be used to activate an Emergency alarm at the panel. The 1148 features a water-resistant design with a Status LED to provide visual indication that a message has been transmitted and received by the panel. The 1148 operates using the pre-installed lithium battery. Compatibility All DMP 1100 Series Wireless Receivers and Panels What is Included The 1148 Emergency Pendant includes the following:
Bracelet Clip Lanyard Clip
Emergency Pendant
Bracelet Clip Lanyard Clip Use as Bracelet or Lanyard
removed. Figure 1: Bracelet mounting Figure 2: Lanyard mounting
1.
Lanyard:
1. Slide the Pendant mount into the slots until fully seated. See Figure 2. 2. Place the Lanyard around your neck and snap together the break-away clasp.
Figure 3: 1148 Emergency Pendant with Bracelet Figure 4: 1148 Emergency Pendant with Lanyard Programming the Transmitter in the Panel Program the device as an Emergency Zone in Zone Information during panel programming. At the Serial Number: option, enter the eight-digit serial number. Refer to the panel programming guide as necessary. LED Status Operation Programming
YES
NO was sent. When Supervision time is set to 0, the 1148 Status LED blinks once every minute to
Status LED only blinks when the button is pressed. See Figure 5.
location for greater than the Supervisory time will result in a Zone missing display at the keypad. Note: When a receiver is installed, powered up, or the panel is reset, the supervision time for transmitters is reset. If the receiver has been powered down for more than one hour, wireless transmitters may take up to an additional hour to send a supervision message unless tripped, tampered, or powered up. This
sends a supervision message. Figure 5: Status LED LED LED Survey
to the receiver then immediately turns off when the receiver acknowledgement is received.
succession. Relocate the Pendant or receiver until the LED immediately turns off indicating the transmitter and
separate consecutive LED blinks. Any indication otherwise means proper communication has not been established. Digital Monitoring Products 2 1148 Installation Guide FCC Information
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Note: part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
Industry Canada Information
two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
den compromettre le fonctionnement. 1148 Installation Guide Digital Monitoring Products 3
Dimensions
Patents
8 0 0 - 6 4 1 - 4 2 8 2 w w w . d m p . c o m
2 5 0 0 N o r t h P a r t n e r s h i p B o u l e v a r d
5 2 0 5 1
. c n I
, s t c u d o r P g n i r o t i n o M l a t i g i D 5 1 0 2 1 0
. 1 1 3 3 1
-
T L