lnstruction
, 11. Windows,Mac OS,Linux 12.USB-A 13.131*19*13mm
(2mm ) 1.ABS 2.2405-2456MHz 3.<200m 4.50m+
5. 6.635-650nm 7. 8.200mAh 9.3.7V 10.Micro USB PPT 2 3 4 5 1
6 ,
() 7 11 9
10
8 USB-A 1. 2. 3. 4. Product Introduction Instructions for use lnstruction Wireless Presenter This product is an electronic product specially designed for computers and multimedia projection. In addition to the traditonal laser pointer function, it can also remotely turn the computer remotely by simple pressing the page up and down buttons. Operation, users can move freely in the classroom or presentation hall, closer to the audience, increase good interaction, freely ip the page in a static state, and get wonderful results. Widely used in product demonstrations, e-learning, conferences and training and many other occasions. Before using the product, please read this manual carefully and Keep it properly for future reference. Product specications
(1) Main material: ABS
(11) Operating system: Windows, Mac
(2) Working frequency:2405-2456MHz OS, Linux, etc
(3) Laser control distance:<200m
(12) Compatible interfaces: USB-A
(4) Remote control distance:50m+
interface
(5) Laser color: red laser
(13) Product size: 131*19*13mm
(6) Laser wavelength:635-650nm
(2mm )
(7) Battery type: lithium battery
(8) Battery capacity: 200mAh
(9) Working voltage: 3.7V
(10) Charging port: Micro charging port Function Description Insert the bottom receiver into the computer with USB interface after putting the battery into the product, then open the button on the product, open the PPT le at the same time, and point at the curtain or other display device to start the demonstration. Cautions 2 3 4 5 1 6 7 Laser hole LED indicator Hyperlink/Enter Page up/Full screen Switch Page down/Black screen Laser button 11 Charging port 10 11 volume +
volume -
(1) Do not disassemble, bump, crush or throw it into re!
(2) If severe swelling occurs, do not continue to use it!
8 USB-A Receiver
(3) Do not place in high temperature environment!
Do not repair or replace any part of the machine yourself (unless specically
(4) Do not use the laser to directly shine on yourself or others eyes, otherwise it instructed in this manual). Please complete the repairs to your dealer or authorized will cause serious damage to the eyes!
agent. PRESENTERPRESENTER FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Caution: Any changes or modications to this device not explicitly approved by manufacturer could void your authority to operate this equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. RF Exposure Information The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.