WdBoxModel LE-902 User manual Power: 9V 500MA 5W Two Scan mode: Auto Scan, Manual Scan. Two working mode: Transmitter, Receiver. Working frequency:
Channel frequency Channel frequency 001 002 003 004 005 006 007 008 2.433 2.4362 2.4394 2.4426 2.4458 2.449 2.4522 2.4554 009 010 011 012 013 014 015 016 2.4586 2.4618 2.465 2.465 2.4714 2.4746 2.4778 2.481 Manual Scan:
1. Press MODE to switch working mode between transmitter (t.xxx) and receiver (r.xxx). Press ENTER to display selected working mode. 2. Press UP/DOWN to select the working frequency (16 available channels). Press ENTER after selection. Auto Scan:
1. Tap AUTO to switch between transmitter (t.-AU) and receiver (r.-AU). Press ENTER after selection. 2. Press and hold AUTO both transmitter and receiver till LED blink. The transmitter and receiver is matched when the LED blink. Matched frequency will be stored in memory. Press and hold receivers AUTO will clear the stored frequency. Matching more than two D-Fi: Power on only a pair of D-Fi for matching. After first pair matched, power on the third and press AUTO for matching. You can add one D-Fi at a time. Keep the distance between 1-10 meter when matching. 2: negative 3-pin XLR signal:
1: ground 3: positive 5-pin XLR signal:
1: ground 3: positive 5: empty 2: negative 4: empty LED indicators:
POWER: power on/off Signal: blink in transmitting FCC STATEMENT 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operated in conjunction with any other antenna or transmitter.